Archer GE800 - Routeur TP-LINK - Free user manual and instructions

USER MANUAL Archer GE800 TP-LINK

IT.E. Power Supply T150500-2-DT Responsible party:

TP-Link USA Corporation

Address: 10 Mauchly, Irvine, CA 92618

E-mail: sales.usa@tp-link.com

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna. + Increase the separation between the equipment and receiver.

+ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

+ Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 25 cm from all persons and must not be co-located or operating in conjunction With any other antenna or transmitter.

FCC regulations restrict operation of this device to indoor use only. The operation of this device is prohibited on oil platforms, cars, trans, boats, and aircraft, except that operation of this device is permitted in large aircraft while flying above 10000 feet. Operation of transmitters in the 5.925-7.125 GHz band is prohibited for control of or communications with unmanned aircraft systems.

FCC compliance information statement Product Name: IT.E. Power Supply

Model Number: T150500-2-DT Responsible party:

TP-Link USA Corporation

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

- Reorient or relocate the receiving antenna. + Increase the separation between the equipment and receiver.

+ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

+ Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and the equipment is properly maintained and operated.

Issue Date: 2023-09-11

CE This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Indoor use: Inside buildings only. Installations and use inside road vehicles and train carriages are not permitted. Limited outdoor use: If used outdoors, equipment shall not be attached to a fixed installation or to the external body of road vehicles, afixedinfrastructure or a fixed outdoor antenna. Use byunmanned aircraft systems (UAS) is limited to within the 5170 - 5250 MHz band.

Frequency band: 5250 - 5350 MHz:

Indoor use: Inside buildings only. Installations and use in road vehicles, trains and aircraft are not permitted. Outdoor use is not permitted.

Frequency band: 5470 - 5725 MHz:

Installations and use in road vehicles, trains and aircraft and use for unmanned aircraft systems (UAS) are not permitted.

EU Declaration of Conformity

TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/53/EU, 2009/125/EC, 2011/65/EU and (EU)2015/863.

The original EU Declaration of Conformity may be found at https/wwwitp-link.com/en/support/ce/ RF Exposure Information

This device meets the EU requirements (2014/53/EU Article 3.14) on the limitation of exposure of the general public to electromagnetic fields by way of health protection.

The device complies with RF specifications when the device used at 20 cm from your body. National Restrictions

Attention: This device may only be used indoors in all EU member states, EFTA countries and Northern Ireland.

AT BE BG|CH|CY CZ | DE] DK EE |EL|ES}FI|FR|HR|HU| IE

, IS | IT | LI LT LU LV MT) NL NO | PL |PT |RO SE | SI | SK |UK(NI)

UK CA UK Declaration of Conformity

TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of the Radio Equipment Regulations 2017.

The original UK Declaration of Conformity may be found at https://www.tp-link.com/support/ukca

National Restrictions Attention: This device may only be used indoors in Great Britain.

Canadian Compliance Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the device.

L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :

The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;

DFS (Dynamic Frequency Selection) products that operate in the bands 5250- 5350 MHz, 5470-5600MHZ, and 5650-5725MHz.

Le dispositif fonctionnant dans la bande 5150-5250 MHzestréservé uniquement pour une utilisation à l'intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux;

ISED regulations restrict operation of this device to indoor use only. The operation of this device is prohibited on oil platforms, cars, trains, boats, and aircraft, except that operation of this device is permitted in large aircraft while flying above 10000 feet. Operation of transmitters in the 5.925-7.125 GHz band is prohibited for control of or communications with unmanned aircraft systems.

5,925-7,125 GHz est interdite pour le contrôle ou les communications avec des systèmes d'avions sans pilote.

Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated With minimum distance 20cm between the radiator & your body.

Déclaration d'exposition aux radiations:

ÆS (Æ) : Archer GE800

Equipment name Type designation (Type)

FRA ER AL EM SR Restricted substances and its chemical symbols

Te # F # QE SA SAR Unit . Hexavalent | Polybrominated | Polybrominated

Lead | Mercury Cadmium chromium biphenyls diphenyl ethers

(Pb) (Hg) (Cd) (Cr) (PBB) (PBDE)

O O O O O O O O O O O O

Notel: “Exceeding0.1wt%” and “exceeding0.01 wt%” indicate that the percentage content of the restricted substance exceeds the reference percentage value of presence condition.

22 SO RÉÉSRIRAMAZENLÉSREMENLÉSEREÉ.

Note2: “O”_indicates that the percentage content of the restricted substance does not exceed the percentage of reference value of presence.

683. 7 RÉSSURIRR MR AA,

Note3: The “—” indicates that the restricted substance corresponds to the exemption.

MpoaykT CepTubiKoBaHO 3riaHO C npaBuramMn cucremMn YKkpCENPO Ha

BiANOBIAHICTE BHMOTAM HOPMATUBHUX AOKYMEHTIB TA BHMOTAM, LLO nepea6aueni AUHHUMY 3aKOHOAAB4UMU AKTAMU YKpaïHU.

ER Safety Information + Keep the device away from water, fire, humidity or hot environments.

+ Donotattemptto disassemble, repair, or modify the device. Ifyou need service, please contact us.

+ Do not use damaged charger or USB cable to charge the device. + Do not use any other chargers than those recommended

+ Do not use the device where wireless devices are not allowed. 144

- Adapter shall be installed near the equipment and shall be easily accessible.

+ Use only power supplies which are provided by manufacturer and in the original packing of this product. If you have any questions, please don't hesitate to contact us.

+ Operating Temperature: O°C - 40°C (32°F - 104°F)

- This product uses radios and other components that emit electromagnetic fields. Electromagnetic fields and magnets may interfere with pacemakers and other implanted medical devices. Always keep the product and its power adapter more than 15 cm (6 inches) away from any pacemakers or other implanted medical devices. lf you suspect your product is interfering with your pacemaker or any other implanted medical device, turn off your product and consult your physician for information specific to your medical device.

Please read and follow the above safety information when operating the device. We cannot guarantee that no accidents or damage will occur due to improper use of the device. Please use this product with care and operate at your own risk. Explanation of the symbols on the product label

Symbols may vary from products.

Note: The product label can be found at the bottom of the product andits IT.E. power supply.

Symbol Explanation =] Class Il equipment 4 Class Il equipment with functional earthing

Polarity of output terminals

Caution, risk of electric shock

La #2 &c+ O h Dangerous voltage 2 @

Energy efficiency Marking

Caution, hot surface

Fuse is used in neutral N

RECYCLING This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEÉEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.

User has the choice to give his product to a competent recycling organization or to the retailer when he buys anew electrical or electronic equipment.

Caution, avoid listening at high volume levels for long periods

Disconnection, all power plugs

Switch of mini-gap construction

Switch of micro-gap construction (for US version) H Switch of micro-gap / micro-disconnection construction (for other versions except US)

Switch without contact gap (Semiconductorswitching device)