FX9-1-ALRG - Aspirateur sans fil AEG - Free user manual and instructions

USER MANUAL FX9-1-ALRG AEG

CONSUMABLES & ACCESSORIES www.aeg.com/shop

Ref: ASPK9 Part nr: 900169080/0

Ref: ESMA Part nr: 9001677807

Ref: AZE127 Part nr: 900922927/0

Ref: ESRO Part nr: 9001677765

S-fresh 18 Value pack

Ref: ESVP1 Part nr: 9001681221

Brush roll hard floor

Home & Car kit Ref: AKIT18 Part nr: 900922935/3

Brush roll all-floors & carpet

Ref: ESBA9 Part nr: 9009229478

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

DE AR ES Children shall not play with the appliance.

FA Cleaning and maintenance shall not be made by children without supervision.

FR Batteries must be removed from the appliance before it is scrapped.

GR The battery is to be disposed of safely.

NL Only use the charging adapter that was provided with the product.

PT The product should only be used for normal vacuuming indoors and in a domestic environment. Make sure it is stored indoors and in a dry place.

Packaging material, e.g. plastic bags should not be accessible to children to avoid suffocation.

To protect the motor, battery and electronics the product should not be operated in:

• an ambient temperature below 5 °C or exceeding 35 °C. • A humidity level below 20% or exceeding 80% (noncondensing).

Never use the vacuum cleaner:

• In wet areas. • Close to flammable gases, etc. • When the product shows visible signs of damage. • On sharp objects or liquids. • On hot or cold cinders, lighted cigarette butts, etc. • On fine dust, for instance from plaster, concrete, flour, hot or cold ashes.

Storage considerations to protect the battery and electronics;

• If the product is temporarily stored in a temperature below 5 °C or exceeding 35 °C, let the product cool down or warm up and dry for a few hours before usage. Dew condensation may form inside the product if the unit is moved from a cold to a warm environment.

• Mind your fingers if cleaning the inside of the floor nozzle. • Make sure to use the designated handles when operating the product and when using the slide function of the main unit. • Make sure the main unit is locked in the upper position when using the cleaner in high cleaning mode (Chapter 6 step 1)

If the product is stored for an extended time period (without usage or continuous charging), we recommend to store the product

• indoors and in temperature between 5 °C to 35 °C , and at a humidity between 20% to 80%. • with the batteries charged at 50% capacity or more.

• Do not leave, store or charge the vacuum cleaner in direct sunlight. • Avoid exposing the vacuum cleaner to strong heat. • The battery cells within must not be dismantled, short circuited or placed against a metal surface. • Never use the vacuum cleaner without its filters. • Do not try to touch the brush roll while the cleaner is switched on and the brush roll is turning. Using the vacuum cleaner in the above circumstances may cause serious personal injury or damage to the product. Such injury or damage is not covered by the warranty or by AEG. SERVICING AND WARRANTY All service or repairs must be carried out by an authorized AEG service centre. This warranty does not cover reduction in battery runtime due to battery age or use, as the life of the battery depends upon the nature of use.

TROUBLESHOOTING PROBLEM CAUSE GB SOLUTION The brushroll is blocked

Clean and remove entangled hair, threads and fibres from the brush roll.

The product stops or does not start

The product might be overheated

Turn off the vacuum cleaner. Then check if the nozzle, tube, hose or filters are blocked and/or dirty. Let the product cool down for minimum 2 hours on the charging stand before starting it again. If the product still is not working, please contact an authorized

Reduction or no suction power

The battery is empty (last

LED blinks) Filters / Nose Cone is dirty or missing Air Channel / Cyclon is blocked Floor nozzle is blocked Hose is blocked

DE AR ES Charge the vacuum cleaner.

- Clean or wash the filters and put them back (See also Instruction book section 7).

- Change or replace the filters (www.aeg.com/shop). - Remove the dust container and check the air channel and air inlet in the dust container to see if something is stuck. - Remove Floor nozzle and check if something is stuck in the nozzle. - Remove Floor nozzle and check if something got stuck in the hose. If so use a stick to remove the obstacle. However, be careful in case the obstruction.

FR GR NL Note: The warranty does not cover any damage to the hose caused by cleaning it.

If the product is not working anymore it will be necessary to replace the motor at an authorized AEG service centre. Note: Damage to the motor caused by the penetration of water is not covered by the warranty. Main unit is in wrong position Product is placed wrong in the charging stand Charging pin is not plugged in The product is not Wrong or no nozzle charging attached To protect the battery and electronics, charging will not occur if room temperature is below 5°C or over 35°C. Charging is taking Room temperature is over longer than 6 hours 35°C Brushroll is not rotating

- Stop the product and let it dry for 48h (do not put it in the charging stand!).

Water or other liquids has been sucked into the product

Changing the floor nozzle while product is running

Push the main unit down to the lowest position. It should not be locked in the upper position and/or in between.

Check if the connectors from the back of the main unit are connected to the charging stand. Make sure charging pin is connected in the back of the charging stand, and charging adapter is plugged in the socket. Make sure the main floor nozzle is attached to the product or it will not charge.

Store and charge the product indoor and in a room temperature between 5 - 35°C.

Charging time will be longer if the temperature is high, which is normal. Store and charge the product in a normal room temperature.

Please also see Instruction book chapter 2. After changing the nozzle restart the product.

BATTERY LAMPS INDICATION GB Charging

DE AR ES During usage

Blink slowly = 100 % fully charged

50- 75 % capacity remaining

25 – 50 % capacity remaining

FA FX9® needs to be recharged.

FR CUSTOMER CARE AND SERVICE

32,4 V High power mode

*based on AEG Internal Testing

This warranty does not cover reduction in battery runtime due to battery age or use, as the life of the battery depends upon the amount and nature of use.

When contacting the AEG service center, ensure that you have following data available:

- Model number, - PNC number - Serial number The information can be found on the rating plate. PNC number Model number Serial number

This symbol on the product indicates that this product contains a built-in rechargeable battery which shall not be disposed with normal household waste.

This symbol on the product or on its packaging indicates that the product may not be treated as household waste. To recycle your product, please take it to an official collection point or to an AEG service center that can remove and recycle the battery and electric parts in a safe and professional way. Follow your country’s rules for the separate collection of electrical products and rechargeable batteries.

SICHERHEITSVORKEHRUNGEN GB High Power Modus

Changing the floor nozzle while product is running

RESOLUÇĂO DE PROBLEMAS PROBLEMA