Pantheon Robust Pergola 3x3 - Pergola Blumfeldt - Free user manual and instructions

Product type	Outdoor pergola
Brand	Blumfeldt
Model	Pantheon Robust Pergola 3x3
Dimensions	3 x 3 m (base area)
Frame material	Steel (stable steel construction)
Roof material	Polyester fabric, 160 g/m², PU-coated
Area of use	Year-round outdoor use, for sun and light protection
Assembly	With two people on a firm, level surface
Anchoring	According to EN 1090-1 on a load-bearing foundation
Wind behavior	Remove or secure roof when wind exceeds 50 km/h
Water resistance	Water-repellent, not fully waterproof
Cleaning	Warm water and mild soap; no pressure washer
Maintenance interval	Check screws and connections twice a year and after storms
Corrosion protection	Annually in sea air or road salt exposure
Safety distance	Keep at least 1.5 m from heat sources
Load capacity	Not for climbing or hanging heavy objects
Spare parts	Use only original spare parts
Warranty	Void in case of improper installation or disregard of instructions
Manufacturer	Chal-Tec GmbH, Mühlenstraße 25, 10243 Berlin
Operating instructions	German, 20 pages as PDF

Frequently Asked Questions - Pantheon Robust Pergola 3x3 Blumfeldt

How do I install the Blumfeldt Pantheon Robust pergola?

Assembly requires at least two people on a firm, level surface. Make sure no hidden cables are damaged and anchor the structure according to EN 1090-1. Also observe the local wind and snow load zones.

Is the roof waterproof?

The polyester roof with 160 g/m² is water-repellent, but not completely waterproof. Standing water should be removed to avoid damage to the fabric.

Can the pergola remain in place during winter?

The pergola is suitable for year-round use, but not for extreme conditions such as storms, heavy snowfall, or hail. Remove heavy snow loads immediately and secure the roof when wind exceeds 50 km/h.

How do I clean the pergola?

Clean the polyester roof only with lukewarm water and mild soap. Do not use solvents, bleach, or pressure washers.

How often does the pergola need maintenance?

Check all screws, bolts, and anchoring points twice a year and after storms. Lubricate moving parts with non-resinous lubricants.

What distance must I keep from heat sources?

Keep at least 1.5 m distance between the pergola and open flames, grills, or heaters. The roof material is flammable.

Can I connect additional electrical accessories?

If the pergola is equipped with electrical accessories such as LED lighting, they must comply with the Low Voltage Directive 2014/35/EU and be installed by a qualified electrician.

What happens in strong wind?

At wind speeds above 50 km/h, you should remove or secure the roof cover to avoid damage to the structure and fabric.

Which surfaces are suitable for assembly?

Suitable surfaces are firm, level, and load-bearing bases such as concrete, stone, or a correspondingly reinforced terrace. Before drilling, hidden cables must be checked.

Can I use spare parts?

Use only original fasteners and dowels supplied or approved by the manufacturer. For damaged parts, only original spare parts may be used to maintain the safety certification.

USER MANUAL Pantheon Robust Pergola 3x3 Blumfeldt

Dear Customer,

Congratulations on purchasing this product. Please read the following

instructions carefully and follow them to prevent possible damages. We assume no liability for damage caused by disregard of the instructions and improper use. Scan the QR code to get access to the latest user manual and more product information.

Estimado cliente,

General safety instructions

• Read this manual carefully before installation and use.
• Keep all documentation for future reference and provide it to any future owner.
• This pergola is intended solely for domestic outdoor use as sun and light weather protection.
  • Any modification or improper installation may cause structural failure or injury.
  • Children and pets must be supervised around the pergola.
• Do not allow climbing or playing on the frame, especially near corners or supports.
• If the pergola includes movable roof panels, ensure they are operated only by adults.
• The polyester roof material is flammable; keep away from open flames, grills, or heating devices.
• Maintain a minimum distance of 1.5 m between any heat source and the pergola structure.
• Do not smoke or use candles directly under the roof.
• Proper installation, use of non-original parts, or disregard of these safety instructions may void the warranty.
• The manufacturer accepts no liability for damage or injury resulting from misuse, overloading, or severe weather conditions.

Notes on installation and assembly

• Installation must be carried out by competent persons familiar with steel construction and anchoring methods.
• Mount only on a solid, level, and load-bearing surface such as concrete, stone, or properly reinforced decking.

• Check for hidden electrical, gas, or water lines before drilling or anchoring.
  • Use only the original fasteners and anchors supplied or approved by the manufacturer.

• Assemble the structure with at least two people to avoid injury and ensure stability.

• During assembly, avoid windy conditions and ensure all parts are temporarily secured.
• The structure must be anchored in accordance with EN 1090-1 and rated for local wind and snow load zones (DIN EN 1991).
• The pergola is suitable for year-round outdoor use, but not for extreme conditions such as storms, heavy snowfall, or hail.

Notes on operation

• In wind speeds exceeding 50 km/h, remove or secure the roof cover to prevent damage.
• The polyester roof (160 g/m ² , PU-coated) is water-repellent, not fully waterproof. Remove standing water to avoid fabric damage.
• Do not climb, sit, or hang objects on the frame or roof.
• Avoid attaching heavy decorations, lights, or planters that may exceed the design load.
• Keep all joints and mechanical parts clear of obstructions.
• If fitted with electrical accessories (e.g. LED lighting), they must comply with Low Voltage Directive 2014/35/EU and be installed by qualified electricians.

Notes on maintenance and inspection

• Inspect all screws, bolts, and anchoring points twice per year and after severe weather.
• Tighten any loose connections immediately.
• Clean the polyester roof only with lukewarm water and mild soap. Do not use solvents, bleach, or high-pressure cleaners.
• Remove leaves, dirt, and snow accumulation promptly to maintain stability and prevent corrosion. Lubricate moving or hinged parts with suitable non-resinous lubricants.
• Replace damaged parts only with original spare parts to maintain safety certification.
• Seasonal inspection (spring/autumn) must be performed.
• Remove heavy snow loads immediately.
• Apply corrosion protection annually if the structure is exposed to sea air or de-icing salts.

M	M6*15		16PCS
S			16PCS

4

C verläuft durch G I C passes through G
C passe par G I C passa attraverso G
C atraviesa G

5

H1			12PCS	M1	M6*35		4PCS
				M5	M6*30		2PCS
				S		###	6PCS

H*1 muss zwischen
M5 und M1
befestigt werden.
H*1 should be
fixed between M5
and M1.
H*1 debe fijarse
entre M5 y M1.
H*1 doit être fixé
entre M5 et M1.
H*1 deve essere
fissato tra M5
e M1.

6		S		[IMAGE]	4PCS	M	M6*15	[IMAGE]	1PCS
		H			6PCS	M1	M6*35	[IMAGE]	2PCS
						M5	M6*30	[IMAGE]	1PCS
H*1 muss zwischen M5 und M1 befestigt werden.H*1 should be fixed between M5 and M1.H*1 debe fijarse entre M5 y M1.H*1 doit être fixé entre M5 et M1.H*1 deve essere fissato tra M5 e M1.
7a		S			10PCS	M2	M6*50		2PCS
						M4	M6*80		8PCS
7b		S			10PCS	M2	M6*50		2PCS
						M4	M6*80		8PCS
7c						M2	M6*50		2PCS
									2PCS

10		S			36PCS	M	M6*15		32PCS
						M6	M6*60		4PCS
11						N			16PCS