ZI-SPA380 - Saw Zipper - Free user manual and instructions
Find the device manual for free ZI-SPA380 Zipper in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product type | Panel saw |
| Brand | Zipper |
| Model | ZI-SPA380 |
| Motor power | 3 kW |
| Blade diameter | 380 mm |
| Blade bore | 30 mm |
| Max. cutting depth at 90° | 90 mm |
| Max. cutting depth at 45° | 65 mm |
| Blade tilt range | 0° - 45° |
| No-load speed | 3000 rpm |
| Voltage | 400 V / 3-phase |
| Frequency | 50 Hz |
| Sliding table dimensions | 1500 x 380 mm |
| Dust extraction port | 100 mm |
| Dimensions (W x D x H) | 2100 x 1000 x 900 mm |
| Weight | 280 kg |
| Included accessories | Sliding carriage, parallel fence, push stick |
| Safety equipment | Blade guard, anti-kickback pawls, emergency stop |
| Maintenance | Lubricate sliding table, check belt alignment |
| Spare parts availability | Through manufacturer service network |
Frequently Asked Questions - ZI-SPA380 Zipper
What is the maximum cutting depth of the Zipper ZI-SPA380?
The maximum cutting depth at 90° is 90 mm and at 45° it is 65 mm.
What type of saw blade is compatible?
Use a 380 mm diameter blade with a 30 mm bore. Ensure the blade's maximum speed rating exceeds 3000 rpm.
How do I adjust the cutting depth?
Turn the height adjustment handwheel located on the front of the machine until the blade reaches the desired height. Lock the adjustment before cutting.
How can I tilt the blade for bevel cuts?
Release the tilting lock lever, rotate the tilting handwheel to set the angle according to the protractor scale, then re-tighten the lever.
Can I cut aluminium or other non-ferrous metals?
Yes, but you must use a blade designed for non-ferrous metals and reduce the feed rate. Always wear appropriate PPE and ensure the material is properly clamped.
How do I connect a dust extractor?
The saw has a 100 mm dust extraction port on the rear of the blade guard. Connect a suitable extractor hose to remove sawdust efficiently.
How to check if the saw blade is parallel to the miter gauge groove?
Use a dial indicator. Turn off and unplug the saw, then measure the distance from the blade tip to the groove at the front and rear. Adjust the blade alignment screw if necessary.
What maintenance is required?
Regularly lubricate the sliding table, clean the dust extraction area, and check the blade guard for smooth movement. Also inspect the drive belt for wear.
What should I do if the blade vibrates during cutting?
Stop the saw and check if the blade is dull or warped. Replace the blade if damaged. Also verify that the flanges are clean and the arbor nut is properly tightened.
Is it safe to operate the saw without a riving knife?
No, always use the riving knife and the blade guard. These devices prevent kickback and must never be removed during operation.
User questions about ZI-SPA380 Zipper
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Saw in PDF format for free! Find your manual ZI-SPA380 - Zipper and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. ZI-SPA380 by Zipper.
USER MANUAL ZI-SPA380 Zipper
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Zipper
Model : ZI-SPA380
Category : Saw