DS-K1103M - Access Control System Hikvision - Free user manual and instructions
Find the device manual for free DS-K1103M Hikvision in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Type of Product | Access Control Keypad Reader |
| Dimensions (H × W × D) | 120 mm × 80 mm × 30 mm |
| Weight | 200 g |
| Power Supply | 12 V DC, 500 mA |
| Card Reading Technology | 125 kHz EM or 13.56 MHz Mifare |
| Keypad | 12-key backlit keypad (0-9, *, #) |
| Output Interface | Wiegand 26/34 bit |
| User Capacity | 2,000 users |
| Operating Temperature | -20°C to 60°C |
| Protection Rating | IP65 (weatherproof) |
| Main Functions | Card + PIN authentication, standalone programming, tamper alarm |
| Installation Type | Surface mount (screws included) |
| Maintenance | Wipe with dry cloth; avoid solvents |
| Security Features | Tamper switch, anti-passback, duress code |
| Spare Parts & Repairability | Replacement faceplate and keypad available; PCB not user-serviceable |
| General Information | Compatible with Hikvision access controllers; brand: Hikvision; model: DS-K1103M |
Frequently Asked Questions - DS-K1103M Hikvision
How to wire the DS-K1103M?
Connect the 12V DC power to the red/black wires, and the Wiegand D0/D1 signals to the controller. Ground (GND) must be shared.
How to add a user?
Enter master code (default 12345), press *, then 1 (add user), followed by user ID and card/PIN.
What cards are compatible with DS-K1103M?
It supports 125 kHz EM cards (like HID Prox) and 13.56 MHz Mifare cards, including Ultralight, Classic, and DESFire.
How to reset to factory defaults?
Power off the device, press and hold the # key, then power on. Keep holding until two long beeps indicate reset.
How to connect DS-K1103M to an access controller?
Use the Wiegand output pins: D0 (green), D1 (white), and GND (black). Connect to corresponding Wiegand input on the controller.
Can I use DS-K1103M outdoors?
Yes, it has an IP65 rating, making it weatherproof. However, avoid direct sunlight and extreme temperatures above 60°C.
What is the read range of the card reader?
Typical read range is 3-5 cm for Mifare and 2-4 cm for EM cards, depending on card quality.
How to change the master code?
Enter current master code, press *, then 0, then enter new 4-8 digit code, followed by # to confirm.
How to troubleshoot beep errors?
Continuous short beeps indicate invalid card or wrong PIN. Long beeps with light flash suggest tamper alarm or controller error.
How to update firmware on DS-K1103M?
Firmware updates are not user-accessible. Contact Hikvision support or use the Hikvision Tool software with a special cable if available.
User questions about DS-K1103M Hikvision
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Access Control System in PDF format for free! Find your manual DS-K1103M - Hikvision and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. DS-K1103M by Hikvision.
USER MANUAL DS-K1103M Hikvision
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Hikvision
Model : DS-K1103M
Category : Access Control System