59G394 - Sander Graphite - Free user manual and instructions
Find the device manual for free 59G394 Graphite in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product type | Orbital sander |
| Brand | Graphite |
| Model | 59G394 |
| Power supply | Mains 230 V ~ 50 Hz |
| Power | 250 W |
| No-load speed | 12,000 – 14,000 min⁻¹ |
| Orbital diameter | 2.5 mm |
| Dimensions (L × W × H) | 250 × 120 × 160 mm |
| Weight | 1.5 kg |
| Sanding area | 90 × 187 mm (1/3 sheet) |
| Sound pressure level | 82 dB(A) |
| Vibration level | 7.5 m/s² |
| Protection class | II (double insulation) |
| Integrated dust bag | Yes |
| Switch | On/Off with lock |
| Power cord | 2 m |
| Main functions | Sanding flat surfaces, paint removal, smoothing |
| Maintenance and cleaning | Clean the filter regularly, replace worn abrasives, check brushes |
| Safety | Wear goggles and a mask, unplug before maintenance |
| Spare parts and repairability | Available from the dealer, repair by professional |
| General information | User manual included, 2-year warranty |
Frequently Asked Questions - 59G394 Graphite
How to change the sandpaper?
Unplug the device. Remove the old abrasive. Place the new paper on the base plate aligning the holes. Secure it with the clamps or the tightening system. Consult the manual for your model.
What speed to use for wood?
Use medium to high speed (12,000-14,000 rpm) for wood. For fine sanding, reduce the speed. Always adapt the abrasive to the material.
How to clean the dust bag?
Empty the bag after each use. If washable, wash it with warm water and dry it completely before putting it back. A clean bag improves suction.
The device vibrates too much, what to do?
Check that the sandpaper is properly attached and that the base plate is not worn. Make sure the screws are tight. If vibrations persist, contact customer service.
Can I use the sander without the bag?
Yes, but it will project dust. It is recommended to use the bag or a vacuum to protect your health and work environment.
How to replace the brushes?
Unplug the device. Remove the caps from the brush holders. Extract the worn brushes and insert new ones (same reference). Replace the caps. Do this when the brushes measure less than 6 mm.
What is the warranty?
The legal warranty is 2 years from the date of purchase. Keep the invoice as proof. Manufacturing defects are covered, not normal wear.
The noise is high, is this normal?
The sound level can reach 82 dB(A). Wear hearing protection. Abnormal noise may indicate a mechanical problem.
How to store the device?
Store it in a dry place, protected from dust. Coil the cord without bending it. Clean the device before storage.
Can I sand metal?
Yes, with a suitable abrasive (fine grit). Use a lower speed to avoid overheating. Wear safety goggles against sparks.
User questions about 59G394 Graphite
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Sander in PDF format for free! Find your manual 59G394 - Graphite and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 59G394 by Graphite.
USER MANUAL 59G394 Graphite
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Graphite
Model : 59G394
Category : Sander