FR-251 - Fridge DAEWOO - Free user manual and instructions

USER MANUAL FR-251 DAEWOO

When out of operating for a long time. BRemove the power supply cord. BDry your refrigerator, opening the door for 2-3 days. When you get ready to move. B Securely fasten removable interior parts (or move and package them separately). Do not lay your refrigerator horizontally, otherwise compressor may be get damaged. © UUhen you need service; Before calling for service check a few things noted below for yourself first. the refrigerator is not operating: Bis the power supply cord unplugged? Bis home fuse blown or circuit breaker off? ff refrigerator is warmer than usual: BhHas the door been open frequently or for a long period? Bis refrigerator overcrowded preventing good air circulation? Bis the clearance between side and rear plate of the refrigerator and the wall allowed sufficiently? there are unusual sounds: Bis refrigerator placed on the level? BAre foreign objects behind the refrigerator? Mare dishes on refrigerator shelves vibrating? If so, re-arrange the dishes. À CAUTION Improper use of the grounding plug can result in a risk of electric Shock. If a grounding adapter is used, make sure the receptacle box is fully grounded. Ifthe supply cord is damaged, it must be replaced by the manufacturer or its service agent or a simmilary qualified person in order to avoid a hazard.

DA=VOO Model No.: FR-251 REFRIGERATOR INSTRUCTION MANUAL I Thank you for selecting this refrigerator. Before using this refrigerator, please read this manual carefully.

© REFRIGING-ROOM POCKET(SMALL) @® REFRIGING-ROOM POCKET(LARGE) @ LAMP COVER © REFRIGERATOR TEMPERATURE CONTROL KNOB @® REMOVABLE SHELF (LARGE) @ GLASS SHELF @® VEGETABLE BOX CHILLED TRAY Here are features of your new refrigerat Take a moment to know all the features and convenience it was designed to provide. Numbers match those in the illustration on page 1. Bicetray Fill tray 3/4 full to allow expansion of water during freezing. Place tray in freezer chest. To release cubes, twist lid slightly. B Removable shelf Shelves can be removed by pulling forward. The shelf can be placed at your desirable position. BI Freezer Shelf To remove the freezer shelfl

1. Remove the screw on the left of inside freezer shelf with screw driver.

2. Push the shelf hooks to the back slightly and remove it by lifting off the slots of

3. Reverse procedure to install.

H Defrost Drain Vessel To remove defrost drain vessel.

1. Lift the defrost drain vessel slightly, then rotate bottom out and pull it down.

2. Reverse procedure to install.

B Lamp Cover a To remove lamp cover

1. Push up the bottom ends of lamp

cover gently, then pull out.

2. Reverse procedure to install.

B Vegetable Crisper May be used for fruit and vegetable storage. Both the crisper and its cover shelf are removable for easy cleaning. Simply slide forward to remove. B Egg Pocket Egg supporter in this pocket can be turned upside down. May be used for small size goods. L Lamp Cover

CAUTION socket. earthing screw. . Don't make it spill to this unit. etc., into this unit.

compressor. . Check your voltage before inserting the power supply cord into the

2. Contact the earthing conductor to this unit with an attachment

4. Don't work with flammable spray, such as painting, near this unit.

5. Don't put ignitable materials, such as benzine, L.P. Gas, alcohol,

. Precaution to the leakage of any gas equipment near this unit. . Precaution not to hold on to the door of this unit by children. . Precaution not to reinsert the power supply cord within 5 minutes after release it from socket. If not, a trouble may be occured to on hard and level floor. Avoid places that are exposed to smoke. The discoloring can occur to the refrigerator. where there is no heat source nearby. High surrounding temperature will lower cooling efficiency and increases your electricity bill. < For good ventilation place refrigerator with the spaced specified on the figure. This helps cooling efficiency and lowers the electricity bill.

E INSTALLATION PLACE FOR R REFRIGERATOR

4 N ( d( à < Place the refrigerator - Place your refrigerator « Place the refrigerator in an area with low moisture. Splashing water or a high moisture area may cause a short circuit and make rusting easier. e Placing the refrigerator on the carpet may cause heat to develop and discolor the appliance. In such a case put a hard wooden board or a rubber mat between the refrigerator and the carpet. Wooden Board, Rubber Mat

e Check if the doors are completely shut. Maintain — Level e Check the voltage and wait about an hour before plugging the power cord into an outlet.

3. THINGS TO KNOW BEFORE MOVING OR RELOCATING THE REFRIGERATOR!

< After running the refrigerator for 2 - 3 Hours put food in the refrigerator. - For relocating indoors use the wheels. e When moving have two people carry the refrigerator for safety < Fasten the doors with tape while moving to prevent them from opening. 4 N f df à 4 N ( df à - Select a safe place to e Level the refrigerator + Install the parts to their + Unplug the power Take food out of the < Fasten the interior install your refrigerator. by using the own place. cord. refrigerator components With tape. adjustable foot. compartments.

[ Te aTA N - When cleaning your < The refrigerator can refrigerator, unplug the smell on its initial power cord and use a operation, but the e Use a soît cloth for cleaning the interior and exterior of the soft cloth and odour will be away refrigerator. dishwashing liquid to when the refrigerator clean. is cooled sufficiently. Soft coëi Do not splash water directly on the refrigerator itself. < Put the parts back to their original position. Install refrigerator in a convenient location away from extreme heat and cold. Allow sufficient clearance about 6 cm between the refrigerator and rear wall so it is easy for refrigerator to radiate heat. Bi Select a place with strong level floor. [ à BAllow 6cm of space between the the wall refrigerator's side and the wall. Z 6cm è - L J CAGEUT Level refrigerator so it rests solidly on the floor, without rocking. There are tuo leveling glides, one at each front comer. Tum to the left to raise a comer, to the right to lower it. Use shims under rear comers, if necessary. Bi you want, the refrigerator door to close when not held open, adjust glides so that the front of the refrigerator is raised. However, front corners must be level with each other, and rear corners with each other. Bi you want the refrigerator door to remain motiontess when open, adjust the leveling glides so that all four corners are level with each other. Make sure all packing material is removed. If the shipping tape has left a residue on the door, touch the residue lightly with the adhesive side of tape or with isopropyl alcohol (most rubbing alcohol is this type).

TEMPERATURE CONTRO Temperature is controlled automatically. The TEMPERATURE CONTROL at the inside ofthe refrigerator and freezer section control the degree of cooling of each compartment. Freezer temperature control Refrigerator temperature control MED. MIN.

The control has three settings from MIN to MAX. Starting your new refrigerator

1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth, the

inside with a damp cloth.

2. Set TEMPÉRATURE CONTROL at MED.

3. Connect the power supply cord.

To change temperature Many factors influence the intemal temperature of the refrigerator section and freezer section M The temperature and humidity of the home. BThe frequency of door openings and the amount of warm food placed in the refrigerator. BThe combination of foods and containers stored in the refrigerator. For these reasons, you may want to adjust the control to suit the season and your needs. When adjusting the tmperature: BTum TEMPERATURE CONTROL toward MAX for colder temperature in refrigerator and freezer sections, and toward MIN for warmer temperature in refrigerator and freezer sections BAllow approximately 12 hours or overnight for the temperature to stabilize, Then check to see if further adjustments are necessary. To turn off refrigerator Disconnect the power supply cord. Remove ice tray and food. Leave doors ajar for air circulation and dehumidification of both sections.

DEFROSTING THE REFRIGERATOR

Itis defrosted automatically in the refrigerator. You don't need to defrost the refrigerator. À CAUTION To Avoid The Risk of Electrical Shock or Death unplug the power cord before replacing a burned out light bulb or cleaning. Remove all food and special compartments from the freezer and refrigerator sections. Exterior : Wash with warm, soapy water, rinse and dry. Use appliance polish or wax periodically to keep the exterior looking like new. Door gasket : Clean at least twice a year with mild soap and water. Rinse and dry. Apply a light film of petroleum jelly to the gaskets to keep them soft. Interior : Wash the liner with warm, soapy water, rinse and dry. Interior and Exterior

1. DO NOT USE abrasive, heavy-duty Powders, etc.

These can scratch and dull the surface, depending on their abrasiveness and the cleaning pressure applied. Avoid metal pads and abrasive impregnated plastic, nylon and cloth pads, etc.

2. DO NOT USE concentrated liquid dishwashing detergent (disslove in warm

water before using.), abrasive cleaners, solvents or polishing agents on plastic parts. These cleaners may cause cracking or discoloring.