Soundweb London BLU-16 - Processor BSS Audio - Free user manual and instructions
Find the device manual for free Soundweb London BLU-16 BSS Audio in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Digital Signal Processor (DSP) |
| Brand | BSS Audio |
| Model | Soundweb London BLU-16 |
| Audio Channels | 16 inputs / 16 outputs |
| Audio Connectivity | Analog via Euroblock, Ethernet (CobraNet, AES67) |
| Digital Audio Protocols | CobraNet, AES67, Dante (optional) |
| Latency | 1 ms (typical) |
| Sample Rate | 48 kHz or 96 kHz |
| Bit Depth | 24-bit |
| Frequency Response | 20 Hz – 20 kHz (±0.5 dB) |
| Dynamic Range | >115 dB (A-weighted) |
| THD+Noise | <0.005% (1 kHz, +4 dBu) |
| Power Supply | 100-240 V AC, 50-60 Hz, 30 W |
| Dimensions (H x W x D) | 1.72 x 19.0 x 9.0 in (44 x 483 x 229 mm) |
| Rack Units | 1U |
| Weight | 6.0 lb (2.7 kg) |
| Cooling | Fanless (convection) |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Front Panel Indicators | Power, Status, Network Link, Audio Activity |
| Configuration Software | Soundweb London HiQnet Audio Architect |
| Mounting | 19-inch rackmount, 1U |
| Included Accessories | Power cord, rack ears, Euroblock connectors |
Frequently Asked Questions - Soundweb London BLU-16 BSS Audio
How do I connect the BLU-16 to a network?
Connect an Ethernet cable from the BLU-16's LAN port to your network switch. Use Audio Architect software to configure IP settings. The device supports CobraNet and AES67 protocols.
Can I use the BLU-16 with Dante?
Yes, with an optional Dante module (BLU-DA). Otherwise, it supports CobraNet and AES67 natively. For Dante, install the module and enable it in Audio Architect.
What is the maximum cable length for analog inputs?
For balanced audio using Euroblock connectors, keep cable runs under 100 meters (330 ft) to avoid signal degradation. Use shielded twisted-pair cable.
How do I reset the device to factory defaults?
Press and hold the Reset button on the front panel for 5 seconds while powering on. The Status LED will flash amber. Release the button to restore factory settings.
Does the BLU-16 support PoE?
No, the BLU-16 requires a separate power supply (100-240V AC). It does not support Power over Ethernet. Use the included power cord.
What sample rate should I choose for my application?
For most installations, 48 kHz is sufficient. For higher audio quality or when integrating with other 96 kHz devices, select 96 kHz in Audio Architect. Higher sample rates increase network bandwidth.
How can I update the firmware?
Download the latest firmware from BSS Audio support. In Audio Architect, go to Devices > Update Firmware, select the file, and follow the prompts. Do not power off during update.
The unit is not powering on. What should I check?
Verify the power cord is securely connected and the outlet has power. Check the fuse (located on the power inlet) using a flathead screwdriver. Replace if blown with same type and rating.
What audio latency can I expect?
Typical latency is 1 ms at 48 kHz. This can vary based on network configuration and processing load. Use Audio Architect to measure and adjust latency if needed.
How do I clean the device?
Disconnect power. Use a soft, dry cloth to wipe the exterior. Do not use liquid cleaners or solvents. Ensure ventilation holes are free of dust. For internal cleaning, contact qualified service.
User questions about Soundweb London BLU-16 BSS Audio
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Processor in PDF format for free! Find your manual Soundweb London BLU-16 - BSS Audio and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Soundweb London BLU-16 by BSS Audio.
USER MANUAL Soundweb London BLU-16 BSS Audio
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : BSS Audio
Model : Soundweb London BLU-16
Category : Processor