IS-AMP340 - Receiver ELAC - Free user manual and instructions
Find the device manual for free IS-AMP340 ELAC in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Stereo Receiver |
| Brand | ELAC |
| Model | IS-AMP340 |
| Dimensions (W x H x D) | 435 x 100 x 330 mm |
| Weight | 8.0 kg |
| Power Output (8 ohms, RMS) | 100 W per channel |
| Frequency Response | 20 Hz - 20 kHz ±0.5 dB |
| Total Harmonic Distortion | < 0.05% |
| Input Sensitivity (Line) | 200 mV |
| Input Impedance (Line) | 47 kΩ |
| Signal-to-Noise Ratio | > 100 dB |
| Audio Inputs | 4 x RCA Line, 1 x Phono (MM), 1 x Digital Optical, 1 x Digital Coaxial |
| Audio Outputs | Speaker terminals, 1 x Pre-out, 1 x Headphone (6.3 mm) |
| Power Supply | AC 230V, 50/60 Hz |
| Power Consumption (Standby) | < 0.5 W |
| Protection Features | Overload, short circuit, thermal protection |
| Cooling | Convection with heat sinks |
| Cleaning Instructions | Wipe with dry, soft cloth; avoid solvents |
| Repairability | Modular design, serviceable by qualified technician |
| Accessories Included | Power cord, remote control, user manual |
Frequently Asked Questions - IS-AMP340 ELAC
How do I connect speakers to the IS-AMP340?
Use the binding post terminals on the back. Strip the speaker wire and insert into the appropriate left/right terminals, ensuring correct polarity (+/-). Tighten the caps securely.
Can I use a turntable with this receiver?
Yes, the IS-AMP340 has a dedicated phono input (MM) for turntables with moving magnet cartridges. No external phono preamp is needed.
What is the recommended speaker impedance?
The receiver is designed for speakers with an impedance of 4 to 8 ohms. Using speakers outside this range may cause damage.
How do I reset the receiver?
Turn off the unit, disconnect the power cord for 30 seconds, then reconnect and power on. This resets the internal microprocessor.
Does the remote control require batteries?
Yes, the remote uses two AAA batteries. Replace them when the range decreases.
Why is there no sound from the speakers?
Check that the speakers are properly connected, the source is selected, and the volume is turned up. Also verify that the speaker A/B switch is on.
Can I connect a subwoofer?
Yes, use the pre-out output on the back panel to connect an active subwoofer.
How do I clean the receiver?
Unplug the unit and wipe the exterior with a soft, dry cloth. Do not use any liquids or cleaning agents.
What is the power consumption in standby?
The standby power consumption is less than 0.5 watts, making it energy efficient.
Where can I find the serial number?
The serial number is located on the back panel near the AC power inlet or on the bottom of the unit.
User questions about IS-AMP340 ELAC
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Receiver in PDF format for free! Find your manual IS-AMP340 - ELAC and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. IS-AMP340 by ELAC.
USER MANUAL IS-AMP340 ELAC
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : ELAC
Model : IS-AMP340
Category : Receiver