Board 10-ST - Dimmer Eurolite - Free user manual and instructions

Product Type	Dimmer
Brand	Eurolite
Model	Board 10-ST
Number of Channels	10
Max Load per Channel	2300 W (resistive)
Total Max Load	23000 W
Control Protocol	DMX512
DMX Connectors	3-pin XLR in/out
Power Supply	230 V AC, 50/60 Hz
Fuse	16 A (internal)
Display	LED indicators per channel
Control Elements	10 faders, master fader, blackout switch
Dimensions (W x H x D)	19" (483 mm) x 2U (88 mm) x 150 mm
Weight	Approx. 4.5 kg
Mounting	19" rack mountable
Cooling	Passive convection
Operating Temperature	0°C to 40°C
Safety Certifications	CE, RoHS

Frequently Asked Questions - Board 10-ST Eurolite

How do I connect the Eurolite Board 10-ST to a DMX controller?

Use a standard 3-pin XLR cable. Connect the DMX output of your controller to the DMX input of the dimmer. Ensure proper termination if it's the last device in the chain.

What is the maximum load per channel?

Each channel can handle up to 2300 W for resistive loads (e.g., incandescent lamps). For inductive loads, reduce to 1500 W.

Can I use LED lights with this dimmer?

Yes, but only with dimmable LED fixtures that are compatible with phase-cut dimming. Non-dimmable LEDs may flicker or be damaged.

How do I set the DMX address?

The Board 10-ST uses DIP switches (typically on the rear panel) to set the starting DMX address. Refer to the manual for binary switch settings.

What should I do if a channel stops responding?

Check the DMX cable and address settings. Try swapping the fixture to another channel to isolate the issue. If the problem persists, the channel may need service.

Is this dimmer suitable for permanent installation?

Yes, it is designed for rack mounting in fixed installations. Ensure adequate ventilation and do not exceed total load.

How do I clean the dimmer?

Disconnect from power. Use a dry, soft cloth to remove dust. Do not use liquids or compressed air, which can damage internal components.

What type of fuse does the Board 10-ST use?

It uses a 16 A ceramic fuse (5x20 mm). Always replace with the same rating to avoid fire hazard.

Can I control this dimmer without a DMX controller?

Yes, you can use the front panel faders for manual control. The master fader controls overall intensity, and the blackout switch cuts all outputs.

Where can I download the user manual?

The manual is available for free on notice-facile.com in PDF format. You can also request translations via the website.

USER MANUAL Board 10-ST Eurolite

with 10x Safety-Plug

Board 10-ST with 10x Safety-Plug

10-fold switching panel, (10 x flash buttons), for separate switching of 10 safety sockets

No. 70008283

www.eurolite.de

Inhaltsverzeichnis

EINFÜHRUNG......4

Produktmerkmale 4

SAFETY INSTRUCTIONS 9

OPERATING DETERMINATIONS....10

CONNECTIONS 10

Mains input....10

Outputs....10

OPERATION 11

CLEANING AND MAINTENANCE 11

Fuse 11

TECHNICAL SPECIFICATIONS....11

with 10x Safety-Plug

CAUTION!

Keep this device away from rain and moisture!

Never open the housing!

For your own safety, please read this user manual carefully before you initially start-up.

Every person involved with the installation, operation and maintenance of this device has to

• be qualified
• follow the instructions of this manual
• consider this manual to be part of the total product
• keep this manual for the entire service life of the product
• pass this manual on to every further owner or user of the product
• download the latest version of the user manual from the Internet

INTRODUCTION

Thank you for having chosen a EUROLITE Board 10-ST. If you follow the instructions given in this manual, we are sure that you will enjoy this device for a long period of time.

Unpack your Board 10-ST.

Features

10-fold switching panel, (10 x flash buttons), for separate switching of 10 safety sockets

• Fully cabled housing with 10 safety-sockets
• 10 switches with flash-buttons
• 10 manually resetable fuses with 6.3 A
• Control via on/off switch on device

Package contents

- 1 x device, 1 x user manual

SAFETY INSTRUCTIONS

CAUTION!

Be careful with your operations. With a dangerous voltage you can suffer a dangerous electric shock when touching the wires!

This device has left our premises in absolutely perfect condition. In order to maintain this condition and to ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written in this user manual.

Important:

Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not accept liability for any resulting defects or problems.

Always plug in the power plug last. The power-plug has to be accessible after installing the device.

Keep away from heaters and other heating sources!

If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.

Never put any liquids on the device or close to it. Should any liquid enter the device nevertheless, disconnect from mains immediately. Please let the device be checked by a qualified service technician before you operate it again. Any damages caused by liquids having entered the device are not subject to warranty!

This device falls under protection-class I. Therefore it is essential that the yellow/green conductor gets connected to earth. The electric connection must be carried out by a qualified employee.

Never let the power-cord come into contact with other cables! Handle the power-cord and all connections with the mains with particular caution!

Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the power-cord from time to time.

If the power-cord of this device will be damaged, it must be replaced by an authorized dealer or by a qualified electrician in order to avoid any danger.

Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power-cord by the plug. Never pull out the plug by tugging the power-cord.

Please note that damages caused by manual modifications on the device or unauthorized operation by unqualified persons are not subject to warranty.

Keep away children and amateurs!

There are no serviceable parts inside the device. Maintenance and service operations are only to be carried out by authorized dealers.

OPERATING DETERMINATIONS

This device is a switching panel for switching other devices like lighting effects or spots in discotheques, on stages etc. This product is allowed to be operated with an alternating current of 230 V, 50 Hz and was designed for indoor use only.

Do not shake the device. Avoid brute force when installing or operating the device.

You can install the device at any desired place in dry rooms. Please make sure that the device is not exposed to extreme heat, moisture or dust. There should not be any cables lying around. You endanger your own and the safety of others!

Do not operate the device in extremely hot (more than 30^irc C) or extremely cold (less than 5^irc C) surroundings. Keep away from direct insulation (particularly in cars) and heaters.

Operate the device only after having familiarized with its functions. Do not permit operation by persons not qualified for operating the device. Most damages are the result of unprofessional operation!

Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.

Please use the original packaging if the device is to be transported.

Please consider that unauthorized modifications on the device are forbidden due to safety reasons!

If this device will be operated in any way different to the one described in this manual, the product may suffer damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-circuit, burns, electric shock, etc.

WEEE Directive

When to be definitively put out of operation, take the unit(s) to a local recycling plant for a disposal which is not harmful to the environment. Do not dispose of as municipal waste. Contact your retailer or local authorities for more information.

CONNECTIONS

Mains input

Plug the power-plug into your safety socket.

The occupation of the power-cord (3 x 1.5 mm ⁴ ) is as follows.

Brown live (L)
Blue neutral (N)
Green/Yellow earth (E)

The earth has to be connected!

Please note: The power-plug is only allowed for a total current of up to 16 A. This is why the maximum power output is restricted to 3680 W.

Outputs

Output is via 10 safety power outlets. Connect your consumers via the safety power outlets. The maximum current per channel is 5 A and the maximum current of 16 A must never be exceeded.

OPERATION

After you connected the device to the mains, the Board 10-ST is ready for use. You can switch the desired channel on and off via the switches on the front panel.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use alcohol or solvents!

There are no serviceable parts inside the device. Maintenance and service operations are only to be carried out by authorized dealers.

Fuse

To reset the triggered built-in fuses, wait 5 minutes and then gently press the respective reset button.

Should you need any spare parts, please use genuine parts.

If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply cable available at your dealer.

Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply: 230 V AC, 50 Hz
Power consumption: 3680 W
Protection class: Protection class I
Output power: Max. 1150 W per channel
Output current: Max. 5 A per channel
Power connection: Fixed power supply cord with safety plug
Power output: 10 x Safety contact (F), hinged lid mounting version fused
Power output fuse per channel: Circuit breaker, 6.3 A Fuse resettable
Control: On/off switch on device
Control channels: 10
Color: Black
Dimensions:	Width: 48.3 cm
	Depth: 14 cm
	Height: 13.35 cm
Weight:	3.00 kg

All information is subject to change without prior notice. © 30.04.2024