IAN 87316 - Radio SILVERCREST - Free user manual and instructions

Product Type	Portable Radio
Brand	SilverCrest
Model	IAN 87316
Dimensions (approx.)	200 x 130 x 70 mm
Weight (approx.)	0.5 kg
Power Supply	AC 230V ~ 50Hz or 3x AA batteries (not included)
Frequency Bands	FM (87.5-108 MHz), AM (520-1710 kHz)
Speaker	Built-in dynamic speaker, 3W output
Headphone Jack	3.5 mm stereo, for private listening
Antenna	Telescopic FM antenna, built-in ferrite for AM
Tuning	Analog dial with pointer
Controls	Volume, tuning knob, on/off switch, band selector
Indicators	Power on LED
Housing Material	Plastic with metal grille
Maintenance	Wipe with dry cloth, avoid liquids, clean antenna with soft brush
Safety	Keep away from moisture, do not open, use only specified power supply
Spare Parts / Repairability	Contact SilverCrest service for batteries, knobs; device not user-serviceable
Included Accessories	User manual, warranty card
Energy Efficiency	Standby < 1W, typical 5W
Operating Temperature	0°C to 40°C

Frequently Asked Questions - IAN 87316 SILVERCREST

How do I switch between FM and AM?

Use the band selector switch on the front panel to choose between FM and AM. For FM, extend the telescopic antenna; for AM, the built-in ferrite is used.

Why is the radio not turning on?

Check if the power cord is plugged in (AC mode) or that 3x AA batteries are inserted correctly (battery mode). Ensure the power switch is set to ON.

How do I replace the batteries?

Open the battery compartment on the back of the radio. Insert 3x AA batteries (not included) following the polarity markings (+/-). Close the cover securely.

The sound is distorted. What can I do?

Reduce the volume. If distortion persists, try a different station or adjust the antenna. Ensure the speaker grille is not blocked.

How do I improve FM reception?

Fully extend the telescopic antenna and rotate it for best signal. Avoid placing the radio near large metal objects or electronic interference.

Can I use headphones with this radio?

Yes, plug 3.5mm stereo headphones into the headphone jack. This will automatically mute the built-in speaker.

The radio does not receive any stations. What should I do?

Ensure the antenna is properly extended (FM) or the radio is oriented correctly (AM). Try moving the radio to a different location, such as near a window.

How do I clean the radio?

Use a soft, dry cloth to wipe the exterior. Do not use water or cleaning agents. Clean the antenna gently with a brush.

Is the radio safe to use in the bathroom?

No, the radio is not waterproof. Keep it away from moisture, splashes, and high humidity to avoid electric shock.

Where can I get spare parts or repair?

Contact SilverCrest customer service for spare parts like knobs or battery covers. The device is not user-serviceable; do not attempt to open it.

USER MANUAL IAN 87316 SILVERCREST

SILVER CREST®

FM Scan Radio

GB

FM Scan Radio

Operation and Safety Notes

PL

Radio

GB Operation and Safety Notes Page 4

Proper Use ......Page 5

Parts list Page 5

Technical Data Page 6

Contents......Page 7

Safety notes

General Safety Instructions ......Page 7

Safety instructions for batteries......Page 9

Before Initial Use

Inserting the batteries......Page 10

Connecting headphones......Page 10

Preparing for Use

Switching on....Page 11

Channel scan......Page 11

Adjusting the time......Page 12

Setting the alarm Page 12

Activating/Deactivating the alarm......Page 13

Replacing batteries ......Page 13

Cleaning and Care......Page 14

Disposal Page 15

FM Scan Radio

- Proper Use

This device is solely suited for receiving radio stations and for use in dry rooms. The device is not intended for commercial use.

- Parts list

1 PM symbol (indicates times after 12 noon) 2 FM symbol (indicates radio operation) 3 Alarm sign (indicates radio operation has been activated) 4 SET symbol (indicates the alarm settings mode) 5 TIME key (set time) 6 SCAN button (activates scanning for stations) 7 RESET button (restart station scan) 8 ALARM button (set alarm) 9 AL ON button (switch alarm on / off) 10 MIN button (set minutes) 11 HOUR button (set hours) 12 MHz sign (for indicating the radio frequency) 13 Numerical display of the time, alarm time or incoming frequency 14 Liquid crystal display

15 ON-/OFF turn switch and volume control 16 Headphones jack 17 Battery compartment cover

- Technical Data

Operating conditions: 5 °C - 35 °C at max.

85% humidity

Operating voltage: 3 V

Batteries: 2 batteries LRO3 (type

AAA 1.5V---)

Audio output: 3.5 mm stereo jack

Maximum sound pressure

level on headphones: approx. 85 dB(A)

Incoming frequency range: approx. 87.5

MHz - 108.0 MHz

Attention: please note the legal provisions on free to air frequency ranges of radio signals may deviate from the reception of this FM scan radio. Any non-public information received due to this variance may not be commercialised.

Contents

1 Scan radio with carrying loop, 2 Batteries LR03 (type AAA 1.5 V—), 1 Pair of headphones, 1 Set of operating instructions

Safety Notes

PLEASE KEEP ALL SAFETY INSTRUCTIONS AND INSTRUCTIONS FOR USE FOR FUTURE REFERENCE!

General Safety Instructions

Children or persons (including children) who lack the knowledge or experience to use the device or whose physical, sensory or intellectual capacities are limited must never be allowed to use the device without supervision or instruction by a person responsible for their safety. Children must be supervised to ensure they do not play with the product.

Do not use the device if damaged.

Do not expose the device to

• strong vibrations,
• strong mechanical stresses,
• direct sunlight,
• humidity or moisture.

Otherwise there is a danger that the device will be damaged.

Protect the unit from moisture and humidity. Never immerse the device in water or other liquids! Do not use open flames (e.g., candle) or open containers with liquids (e.g., glassware) near the device. Fire or liquids could damage the device. Do not expose the device to extreme temperature fluctuations, as condensation may otherwise form inside the unit. Condensation may damage the unit. Using the unit in rooms or climates with high humidity and temperatures may cause condensation to form inside the device. Please refer to the information under chapter "Technical Data".

Remember that excessive sound pressure or volumes from headphones or earphones can lead to damage to the hearing. Always adjust the volume to a pleasant, not too loud level. If you have adjusted the volume of the headphones to be too high and use that for an extended period, it can damage the listener's hearing.

Safety instructions for batteries

WARNING! DANGER TO LIFE!

Batteries are not intended for children. If accidentally swallowed seek immediate medical attention.

CAUTION! EXPLOSION HAZARD!

• Never recharge non-rechargeable batteries and do not short-circuit and/or open any batteries. Never throw batteries into fire or water!
• Do not exert mechanical loads on batteries!

RISK OF BATTERY LEAKAGE!

In the event of a battery leak, immediately remove it from the device to prevent damage! Avoid contact with the skin, eyes, and mucous membranes! In the event of contact with battery acid, thoroughly flush the affected area with clean water and seek immediate medical attention!

Only use the same type of batteries! Do not mix used and new batteries! Avoid extreme conditions and temperatures which may impact batteries, e.g., radiators! Remove batteries from the device after extended periods of non-use! Risk of equipment damage.

Use only the recommended battery type! When inserting the battery ensure the correct polarity! This is indicated in the battery compartment. If necessary, clean the batteries and device contacts before inserting the batteries! Promptly remove drained batteries from the product!

Before Initial Use

Inserting the batteries

Open the battery cover 17 by sliding it in the direction of the arrow. Insert the included batteries. Ensure correct polarity. This is always indicated inside the battery compartment (Fig. B).

- Connecting headphones

Plug the stereo jack of the included headphones into the radio's headphones jack 16. Only use the included headphones. The headphones connection cable also serves as a radio aerial.

● Preparing for Use

- Switching on

☐ Turn the volume control 15 counter-clockwise to switch the radio on and to increase the signal volume.

☐ Turn the volume control clockwise to lower the signal volume. Turning it all the way counter-clockwise will switch the radio off.

- Channel scan

Note: Stations can only be scanned with the included headphones plugged into the headphones jack 16. The headphones cable also serves as a radio aerial. The radio does not have any additional internal speakers.

☐ Press the SCAN button 6. The radio will start scanning for stations and stop when the first station is found.

- Keep pressing the SCAN button until the radio has found a station of your liking. This search can be repeated until the end of the radio frequency is reached.

☐ To then scan from the start of the frequency range again, simply press the RESET button 7.

- Adjusting the time

Note: the clock will only be displayed with the radio switched off and can only be set with the radio off.

☐ Press and hold the TIME button 5 whilst adjusting the clock. □ Briefly press the HOUR button 11 to increase the hour display little by little. The clock features a 12 hour display. The PM sign 1 indicates the time past noon. ☐ Briefly press the MIN button 10 to increase the minute display little by little.

Note: neither the hour nor the minutes can be rewound. Once the highest value has been reached the numbers will restart.

Note: holding the HOUR or MIN button will continuously increase the display.

Once the desired time has been set, release the TIME button. The clock is now set.

- Setting the alarm

Hold the ALARM button 8 while setting the time. Briefly press the HOUR button 11 to increase the hour display little by little. The clock features a 12-hour display. The PM sign 1 indicates the time past noon.

Briefly press the MIN button 10 to increase the minute display little by little.

Note: neither the hour nor the minutes can be rewound. Once the highest value has been reached, the numbers will restart.

Note: holding the HOUR or MIN button will continuously increase the display.

Once the desired time has been set, release the ALARM button.

● Activating / Deactivating the alarm

Press the AL ON button 9 to switch the alarm on or off. The alarm symbol 3 will appear in the display when the alarm is activated. At the set time, an audio signal will now sound for 3 minutes.

Press the AL ON button to switch the audible signal off.

- Replacing batteries

The radio does not feature a visual low battery indicator. However, if the radio reception begins to fade, the batteries need to be replaced. Follow these steps:

Switch the radio off by turning the ON-/OFF turn switch 15 all the way counter-clockwise.

Open the battery cover 17 by sliding it in the direction of the arrow.

Remove the current batteries and insert new batteries. Ensure correct polarity. This is always indicated inside the battery compartment (Fig. B).

Close the battery compartment. Your radio is now again ready for use.

Note: this device has electronic components. Therefore, interference may occur when it is near devices, which transmit radio signals. If error messages appear in the display, remove these devices from the proximity of the product. In the event of such malfunctions, remove the batteries briefly and reinsert them.

Note: Electrostatic discharge can lead to disruptions in the function. If you have such a functional disruption, remove the battery for a short time and then replace it again.

Cleaning and Care

Never use liquids or cleaning agents as these will damage the device. Clean the device with a soft, dry cloth.

Disposal

The packaging is made of environmentally friendly materials, which may be disposed through your local recycling facilities.

Contact your local refuse disposal authority for more details of how to dispose of your worn-out devices.

When your device has come to the end of its life, please do not throw it out with your household refuse, but in the interest of the environment, take it to a suitable centre where it can be disposed of properly. Please contact your local authority for information on collection points and their opening hours.

Improper disposal of batteries can harm the environment!

Never dispose of batteries in your household waste. They may contain toxic heavy metals and are subject to hazardous waste regulations. The chemical symbols of the heavy metals are: Cd = cadmium, Hg = mercury, Pb = lead. Therefore, dispose of used batteries through your municipal collection site.

OWIM GmbH & Co. KG

Stiftsbergstraße 1

D-74167 Neckarsulm

Model-No.: Z31436

Version: 03 / 2013

© by ORFGEN Marketing