BIFINETT KH 1102 BOUILLOIRE - Kettle KOMPERNASS - Free user manual and instructions

USER MANUAL BIFINETT KH 1102 BOUILLOIRE KOMPERNASS

1,7 l Electric water kettle

2. Technical Data

This electric water kettle is meant to heat water for household use. It is not meant to be used with any other fluids and for commercial or industrial use. Voltage ..................................: 230 V / 50 Hz Power consumption .......................: 2200 W Important for your safety! To avoid life-threatening electric shocks:

• Make sure that the base with electrical connections never comes in contact with water. First let the base dry completely, in case it gets wet accidentally.
• Make sure that the power cord never becomes wet or damp during operation. Lay the cord such that it cannot be pinched or otherwise damaged. Should the power cord be damaged, get it replaced by the customer service, before the kettle is used again.
• Always pull the plug out of the power socket after use. Switching off the device is not sufficient because the device receives power as long as the power plug is connected to the socket. To prevent fire hazards and the risk of injury:
• Always heat water with a closed lid, otherwise the automatic cut-out mechanism doesn’t work. Boiling water can then spray out over the edge.
• When in use, the electric water kettle is very hot and hot vapours may escape from it. It is always best to wear oven mitts when handling the kettle.
• Make sure that the electric water kettle is kept in a stable and vertical position before you switch it on. Boiling water can cause an unstabile kettle to fall over.
• Never leave the electric water kettle unattended.
• Do not let children and other frail persons handle the appliance unsupervised, as they may not always be able to assess potential risks.. Keep this manual for future reference – and also pass it on with the device to any future owners.

3. Starting Up the Device

• The kettle switches off on its own, once the water has boiled to the right temperature. The switch comes back to its earlier up position and the indicator switches off too. To interrupt the heating, slide the switch back to the up position. Even then the indicator switches off. Before you start using the kettle, make sure that ... – the kettle, power plug and power cord are in perfect condition. – all packing material has been removed from the kettle. Fill the kettle with water up to the MAX mark and let it boil thoroughly once, as has been described in the next section. Pour this water away.

4. Boiling Water

Warning:

Danger! Never bring the electrical base near water - life-threatening hazard! Pull the power plug out of the socket before you remove the kettle from the base. This allows you to prevent water from spilling out of the kettle and fall on the electrical connections in the base thereby leading to a short circuit. Boil only as much water as you need for current use. That helps you save electricity, water and time:

• Take the kettle to fill water – never bring the electrical base near water – life threatening hazard! Open the lid by pressing the unlocking key Hold the kettle vertically while filling water. Only then will the level indicator on the side correctly indicate the amount of water. Fill the kettle ... – at least up to the MIN mark to prevent the appliance from overheating. – no higher than the MAX mark so that no boiling water spills out.
• First close the lid .
• and and then put the kettle on the base , until it stands absolutely erect on the base .
• Now insert the power plug into the power socket. and press the switchdownwards, until it rests in down position. An indicator at the end of the handle shows that the kettle is heating. For safety reasons you should not open the lid when the water is boiling or is still very hot to avoid risk of injuries.

5. Cleaning and Care

6. Storage

Let the kettle cool down completely before you put it away.

• Wind the power cord around the holder on the bottom of the device.
• Keep the kettle on a dry surface.

Danger: Do not open any part of the

housing. There are no operating elements inside. An open housing can create the risk of a life-threatening electrical shock. Never submerse any parts of the device in water or other liquids! There could be potential hazard of life-threatening electric shock, if moisture enters the voltage conducting parts upon operating the appliance again. Tip: Empty the kettle completely before you put it away..

7. Disposal

Care for the environment. Do not dispose off the appliance with household waste under any circumstances. If you wish to dispose of the device, dispose of it at a collection site for recycling of electronics. Before you clean the kettle, ....

• Pull the power plug out of the socket and first let the kettle cool down completely.
• Clean all outer surfaces and the power cord with a slightly damp piece of cloth. In any case, dry the kettle thoroughly, before you use it again.
• Never use any cleansers, abbrasive substances or solvents. They can damage the parts of the appliance..

8. Warranty & Service

The warranty conditions and the service address can be found on the warranty slip. In the event of calcium deposits:

• Take any decalcifying agent used for kitchen utensils (e.g. decalcifiers for coffee machines) from a grocery shop.
• For stainless steel surfaces, you can use appropriate cleaning agents from a specialized dealer.

Removing the water strainer and putting it back again:

• Open the lid completely. Press on the nose on the water strainer, from above in order to take it out from inside
• After cleaning the kettle you can simply put put the strainer back and push it firmly – that’s all!