X66264MD1 - Range hood AEG - Free user manual and instructions

Brand	AEG
Model	X66264MD1
Product type	Range hood
Dimensions (W x D x H)	60 x 50 x 45 cm
Net weight	12 kg
Power supply	220-240 V, 50 Hz
Motor power	150 W
Exhaust duct diameter	150 mm
Speed levels	3 speeds + intensive
Lighting type	LED, 2 x 3 W
Maximum airflow rate	450 m³/h
Grease filter	Washable metal
Charcoal filter (optional)	Not included, rechargeable
Installation mode	Exhaust or recirculation
Maximum noise level	65 dB(A)
Special functions	Delayed shut-off, timer
Care and cleaning	Metal filter dishwasher-safe; clean exterior with damp cloth
Safety	Automatic safety shut-off, backflow protection
Repairability	Repairability index: 7.9/10
Spare parts available	Charcoal filter, LED bulb, motor, remote control (on request)

Frequently Asked Questions - X66264MD1 AEG

How to install the AEG X66264MD1 range hood in recirculation mode?

To install in recirculation mode, you need to purchase a charcoal filter (not included) and place it in the designated compartment. Refer to the installation diagram in the manual for the exact positioning.

How to clean the metal grease filter?

The metal grease filter can be cleaned in the dishwasher or by hand with hot water and dish soap. Let it dry completely before reinstalling.

What is the noise level of the range hood?

The maximum noise level is 65 dB(A) in intensive speed. In normal speed, it is lower, generally around 50-55 dB(A).

How to replace the LED lighting?

The lighting is provided by integrated LEDs that are not individually replaceable. In case of failure, contact AEG after-sales service for module replacement.

Can the range hood be used without an exhaust duct?

Yes, in recirculation mode. You need to install a charcoal filter (optional) to purify the air before returning it to the kitchen.

How often should the charcoal filter be changed?

The charcoal filter should be replaced every 3 to 6 months depending on usage. A saturation indicator may be present on some models.

What to do if the range hood does not turn on?

First check the power supply (outlet, fuse). If nothing works, the motor or control board may be defective; contact a technician.

How to set the delayed shut-off timer?

Press the timer button (clock icon) for about 2 seconds. The hood will automatically turn off after 10 minutes.

What is the recommended installation height above the cooktop?

For an electric or induction cooktop, the minimum height is 65 cm; for a gas cooktop, 75 cm. Follow the safety instructions in the manual.

Where to find the serial number of my range hood?

The serial number (Seriennummer) is indicated on the rating label located inside the hood, near the filter or on the motor housing.

USER MANUAL X66264MD1 AEG

FOR PERFECT RESULTS

Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.

Visit our website to:

Get usage advice, brochures, trouble shooter, service information: www.aeg.com

Register your product for better service: www.aeg.com/productregistration

Buy Accessories, Consumables and Original spare parts for your appliance: www.aeg.com/shop

ENVIRONMENT CONCERNS

Recycle the materials with the symbol 📁. Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol 📄 with the household waste. Return the product to your local recycling facility or contact your municipal office department for household waste or the shop where you purchased this product.

CUSTOMER CARE AND SERVICE

We recommend the use of original spare parts.

When contacting Service, ensure that you have the following data available.

The information can be found on the rating plate. Model, PNC, Serial Number.

Warning / Caution-Safety information.

General information and tips

Environmental information.

Subject to change without notice.

1! SAFETY INSTRUCTIONS

Caution! Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. The extractor hood has been designed exclusively for domestic use.

Caution! Do not connect the appliance to the mains until the installation is fully complete. Before any cleaning or maintenance operation, disconnect hood from the mains by removing the plug or disconnecting the mains electrical supply.

Always wear work gloves during the maintenance, installation and lighting operations. The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or knowledge, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety. This appliance is designed to be operated by adults, children should be monitored to ensure that they do not play with the appliance. This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. Never use the hood without effectively mounted grating! The hood must NEVER be used as a support surface unless specifically indicated. The premises where the appliance is stalled must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels. The flaming of foods beneath the hood itself is severely prohibited. The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances. Any frying must be done with care in order to make sure that the oil does not overheat and ignite.

Caution! Accessible parts of the hood may become hot when used with cooking appliance.

With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities. The hood must be regularly cleaned on both the inside and outside (AT LEAST ONCE A MONTH).

This must be completed in accordance with the maintenance instructions provided in this manual). Failure to follow the instructions provided in this user guide regarding the cleaning of the hood and filters will lead to the risk of fires. Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks. We will not accept any responsibility for any faults, damage or fires caused to the appliance as a result of the non-observance of the instructions included in this manual.

⚠ Warning! Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.

2. USE

The hood serves to aspirate the fumes and vapors resulting from cooking.

The attached installation manual indicates the version to be used depending on the model you have, the suction version with

external evacuation of filtering with

internal recirculation

3. INSTALLATION

The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug, connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation. If it is not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III in accordance with installation instructions.

Warning! Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled.

The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to.

4. MAINTENANCE

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally. Clean using a cloth dampened with neutral liquid detergent. Do not use abrasive products. DO NOT USE ALCOHOL!

Warning! Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. Therefore, we recommend observing these instructions.

The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations.

4.1 Grease filter - The grease filter must be cleaned once a month using non aggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity.

4.2 Non-washable activated charcoal filter - The saturation of the charcoal filter occurs after more or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter. In any case, it is necessary to replace the cartridge at least every four months. The charcoal filter may NOT be washed or regenerated.

5. CONTROLS

The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights. Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.

The control switches are located on the unit's front panel:

1 Suction speed (power) ON-OFF/decrease key

2 Suction speed (power) 1 - 2 - 3 -4 Increase key. Suction speeds (powers) 3 and 4 have a limited duration, respectively 10 and 5 minutes, after which suction speed (power) 2 is activated.

Note: The LED on the display flashes indicating speed timing.

3 Lighting ON/OFF key

4 "Breeze" function key (Environment ventilation)

The hood switches on at low suction speed (power) for about one hour and then switches off.

5 Display

Filter saturation indicator

At regular intervals, the hood warns when the filters must be serviced.

Grease filter saturation indicator

The set speed and the letter "F" alternate on the display.

Carbon filter saturation indicator

The set speed and the letter "C" alternate on the display.

Reset of saturation indicator

In order to reset the saturation indicator, switch on the hood then press and hold button 1 for about 3 seconds.

Perform filter maintenance as recommended in this manual.

In the event that both indicators of filter saturation “F” and “C” start flashing, proceed with the reset twice.

The saturation indicator of the charcoal filter is not normally active and if the hood is used in the recirculation mode, it must be activated manually the first time.

Activation of the charcoal filter saturation indicator:

Turn off the hood and simultaneously press buttons 2 and 3 for 3 seconds.

The letters “F” and “C” will flash on the display for 2 seconds, to indicate successful activation of the saturation indicator of the charcoal filter.

Deactivation of the charcoal filter saturation indicator:

Turn off the hood and simultaneously press the buttons 2 and 3 for 3 seconds. Only letter “F” will flash on the display for 2 seconds, to indicate successful deactivation of the saturation indicator of the charcoal filter.

Temperature Alarm

The hood is equipped with a temperature sensor which activates the motor at speed 3 in case the temperature in the display zone is too high.

The alarm condition is indicated by the display with the letter "t" flashing.

This condition remains as such until the temperature falls below the alarm threshold.

This mode can be quit by pressing key "2". Every 30" the sensor checks the ambient temperature of the display zone.

5.1 Hob ² Hood

The hood is equipped with a function for wireless connection with the cooktop for automatic adjustment of the most suitable speed. Refer to the instruction manual of the cooktop to verify the presence and compatibility of this function.

In the case of first connection to the mains or abrupt disconnection from power supply (blackout), wait 1 minute to allow the hood to restore the connection with the cooktop.

6. LIGHTING

The hood is equipped with a lighting system based on LED technology.

The LEDs guarantee an optimum lighting, a duration up to 10 times as long as the traditional lamps and allow to save 90% electrical energy.

Caution! Do not look directly into the LED light.

To replace lights, contact authorised spare part center.

5. COMMANDES

1! SAFETY INSTRUCTIONS

4.2 Non-washable carbon filter

5. CONTROLS

5. CONTROLS

www.aeg.com/productregistration

5. CONTROLS

www.aeg.com/productregistration

5. CONTROLS

5. CONTROLS

www.aeg.com/productregistration

4.2 Washable activated carbon filter

5. CONTROLS

5. CONTROLS

www.aeg.com/productregistration

5. OPERATION

4.2 Non-washable activated carbon filter

5. CONTROLS

5. CONTROLS

4.2 Non-washable activated carbon filter

5. CONTROL

www.aeg.com/productregistration

www.aeg.com/productregistration

5. CONTROLS

5. COMMANDS

1! SAFETY INSTRUCTIONS

5. CONTROLS

www.aeg.com/productregistration

4.2 Non-washable activated carbon filter

5. CONTROLS

www.aeg.com/productregistration

5. CONTROL

4.2 Non-washable activated carbon filter.

The saturation of the carbon filter occurs after a more or less prolonged use depending on the type of kitchen and the cleanliness of the grease filter. In any case, it is necessary to replace the cartridge at least every four months.

5. COMMANDS

4.2 Non-washable active carbon filter

5. CONTROLS

5. CONTROLS

4.2 Non-washable active carbon filter

5. CONTROLS

www.aeg.com/productregistration

Purchase accessories, consumables and original spare parts for your appliance:

www.aeg.com/shop

ENVIRONMENT PROTECTION

5. CONTROLS

www.aeg.com/productregistration

www.aeg.com/productregistration

5. CONTROLS

5. CONTROLS

www.aeg.com/productregistration

5. COMMAND

www.aeg.com/productregistration