SP 1 Dirt - Water pump KARCHER - Free user manual and instructions

Product type	Dirty water pump for loaded water (dirty water)
Brand	Kärcher
Model	SP 1 Dirt
Dimensions (L x W x H)	Approx. 20 x 20 x 30 cm
Weight	Approx. 4.5 kg
Power supply	230 V / 50 Hz, 400 W
Maximum flow rate	8,000 L/h
Maximum delivery head	8 m
Maximum immersion depth	7 m
Maximum particle size	30 mm
Cable length	10 m
Float switch	Yes, adjustable
Housing material	Impact-resistant plastic
Protection rating	IPX8 (permanent immersion)
Main functions	Pumping of clear or dirty water, draining of basements, pools, pits
Maintenance and cleaning	Clean the strainer and housing after each use; rinse with clear water
Safety	Dry-run protection, motor thermal protection
Spare parts and repairability	Seal, impeller, float switch available; repairable design
General information	Use for water up to 35 °C; max ambient temperature 40 °C

Frequently Asked Questions - SP 1 Dirt KARCHER

How to install the SP 1 Dirt pump in a flooded basement?

Place the pump flat at the lowest point, ensure the float switch can move freely, and plug it into a 230 V socket protected by a 30 mA residual current circuit breaker.

Can you pump water containing stones or sand?

Yes, the pump accepts particles up to 30 mm. For larger particles, install a pre-filter.

How to adjust the float switch for automatic shut-off?

The float switch stops the pump when the water level is low. Adjust the position of the float cable to change the shut-off level.

What to do if the pump does not start?

Check the power supply, that the float is in the high position, and that the strainer is not blocked. If it ran dry, let it cool for 15 minutes before trying again.

How to clean the pump after use?

Unplug it, rinse the housing and strainer with clear water, remove deposits with a soft brush. Do not use solvents.

What is the maximum delivery head of the SP 1 Dirt?

The maximum delivery head is 8 meters. Beyond that, the flow rate decreases significantly.

Can this pump be used for a swimming pool?

Yes, it is suitable for emptying a swimming pool. Make sure to immerse the pump to a maximum depth of 7 m and respect the particle size.

How to store the pump in winter?

Clean it thoroughly, dry it, and store it in a frost-free place. If water freezes in the housing, it can damage the pump.

Where to find spare parts for the SP 1 Dirt?

Parts such as the seal, impeller, and float switch are available from Kärcher customer service or authorized dealers.

Can the pump run continuously?

Yes, for continuous use, respect a max water temperature of 35 °C and do not exceed the immersion depth. The motor is thermally protected.

USER MANUAL SP 1 Dirt KARCHER

Deutsch 2

English 5

Français 8

Italiano 11

Nederlands 14

Español 17

Português 20

Dansk 23

Norsk 26

Svenska 29

Suomi 32

Ελληνικά 35

Türkçe 38

Русский 41

Magyar 45

Čeština 48

Slovenščina 51

Polski 54

Românește 57

Slovenčina 60

Hrvatski 63

Srpski 66

Български 69

Eesti 72

Latviešu 75

Lietuviškai 78

Українська 81

Қазақша 84

中文 88

لطربة 1

Safety instructions for immersion pumps

Please read and comply with these safety instructions prior to the initial operation of your appliance. Retain these safety instructions for use for future reference or for subsequent possessors.

-Please read the operating instructions for your machine before using it, and pay particular attention to the following safety instructions.
-Warning and information plates on the machine provide important directions for safe operation.
—Apart from the notes contained herein the general safety provisions and rules for the prevention of accidents of the legislator must be observed.
-Keep packaging films away from children, there is a risk of suffocation!

Hazard levels

⚠️DANGER

Pointer to immediate danger, which leads to severe injuries or death.

⚠ WARNING

Pointer to a possibly dangerous situation, which can lead to severe injuries or death.

⚠CAUTION

Pointer to a possibly dangerous situation, which can lead to minor injuries.

ATTENTION

Pointer to a possibly dangerous situation, which can lead to property damage.

Safety

Electric components

⚠️DANGER

Risk of electric shock.

• Check the power cord with mains plug for damage before every use. If the power cord is damaged, please arrange immediately for the exchange by an authorized customer service or a skilled electrician.
  ■ All electrical sockets should be fixed in an area that is protected against floods.
  ■ Unsuitable electrical extension cables can be hazardous. Only use electrical extension cables outdoors which have been approved and labelled for this purpose and have an adequate cable cross-section.
  ■ The mains plug and the coupling of an extension cable must be watertight and must never lie in water. Moreover, the coupling may never lie on the ground. The use of cable reels that ensure that the sockets are at least 60 mm above the ground is recommended.

■ Do not use the power cord to carry/ transport the machine.
■ To separate the machine from the mains, pull the plug and not the power cord.
■ Do not scrape the power cord across sharp edges and ensure that it does not get pressed.
■ The voltage indicated on the type plate must correspond to the voltage of the electrical source.
■ To avoid risks, all repairs and replacement of spare parts may only be carried out by the authorised customer service personnel.
■ Operate pumps only on sockets that are equipped with a fault current protection switch with a nominal fault current of max. 30 mA and a protective-earth contact (earthing).
■ Check the fault current protection switch and the protective earth contact (earthing) for proper function at regular intervals.
■ Never operate the pumps while there are persons in the pool or garden pond.
■ Do not touch feed fluids, the rope attached to the carrying handle as well as objects that are in contact with the feed fluid (e.g. pipelines extending into the water, railings, etc.).
■ In Austria pumps to be used in swimming pools and garden ponds should be

equipped with a fixed connection line according to ÖVE B/EN 60555 Part 1 to 3; power supply should be via a ÖVE-tested isolating transformer whereby the secondary nominal voltage should not exceed 230V.

■ The electrical connection of the system may only be performed by a qualified electrician. Please follow the respective national regulations!

Safe handling

⚠ WARNING

This appliance is not intended for use by persons with limited physical, sensory or mental capacities or lacking experience and/or skills, unless such persons are accompanied and supervised by a person in charge of their safety or they have received precise instructions on the use of this appliance and have understood the resulting risks.
■ Children may only use this appliance if they are over the age of 8 and supervised by a person in charge of their safety, or if they have received instructions on the use of this appliance and have understood the resulting risks.
■ Children must not play with this appliance.
■ Supervise children to prevent them from playing with the appliance.

■ Cleaning and user maintenance must not be performed by children without supervision.
■ Turn off the appliance and remove the mains plug prior to any care and maintenance works.

⚠CAUTION

■ Create stability for the appliance prior to any work on or with the appliance to prevent accidents or damage.
In order to prevent accidents or injuries, mind the weight of the appliance during transport (see technical data).
In order to prevent accidents or injuries, mind the weight of the appliance when choosing the storage location (see technical data).

Other risks

⚠️DANGER

Danger of explosion

→ Do not pump corrosive, highly combustible or explosive fluids (e.g. petroleum, petrol, acids or nitro thinner).
→ Do not operate the device in fire or explosion-endangered surroundings.

⚠CAUTION

→ Water that has been delivered with this appliance is no drinking water!

ATTENTION

This can cause damage to the appliance.

→ Do not pump greases, oils and salt water.

→ Do not pump waste water from sanitary facilities and silty water with a lower flowability than clear water.
→ Do not pump water that has a higher temperature than 35° C.

http://www.kaercher.com/dealersearch