TCH6590ER - Heating DELONGHI - Free user manual and instructions

Product type	Ceramic space heater
Brand	DeLonghi
Model	TCH6590ER
Dimensions (L x W x H)	22 x 22 x 60 cm
Weight	3.5 kg
Power supply	220-240 V, 50 Hz
Maximum power	2000 W
Heating modes	Eco, Boost
Adjustable thermostat	Yes, from 7°C to 35°C
Programmable timer	Up to 24 hours
Oscillation	Yes
Remote control	Included
Safety	Automatic shut-off in case of overheating and tipping over
Cleaning	Dust the air intake grille regularly
Spare parts	Air filter, remote control
Warranty	2 years

Frequently Asked Questions - TCH6590ER DELONGHI

How to turn the device on and off?

Press the On/Off button on the control panel. To turn off, press again. You can also use the remote control.

How to adjust the temperature?

Use the + and - buttons to adjust the desired temperature. The adjustment range is from 7°C to 35°C.

How to use the timer?

Press the Timer button and select the number of hours (up to 24h). The device will turn off automatically after this time.

The device is not heating, what to do?

Check that the device is plugged in and that the set temperature is higher than the room temperature. Clean the filter if necessary. If the problem persists, contact customer service.

How to clean the filter?

Unplug the device. Remove the filter located at the back, dust it with a vacuum cleaner or wash it with lukewarm water and let it dry completely before putting it back.

The remote control is not working, why?

Check the batteries (replace them if necessary). Make sure no obstacle blocks the infrared sensor. If the problem persists, the remote control may be defective.

The device turns off automatically, is this normal?

Yes, it is a safety feature. The device turns off in case of overheating or tipping over. Let it cool down for a few minutes before turning it back on.

Can I use the device in a bathroom?

This device is not designed for use in a bathroom. Use it only in dry and well-ventilated rooms.

How to reset the device?

Unplug the device for 5 minutes, then plug it back in. If the device does not turn on, check the fuse or contact customer service.

Where to find spare parts?

Spare parts (filter, remote control) are available from your authorized dealer or from DeLonghi customer service.

USER MANUAL TCH6590ER DELONGHI

TERMOVENTILATORE A COLONNA CERAMICO TOWER CERAMIC HEATER RADIATEUR SOUFFLANT COLONNE CÉRAMIQUE KERAMIK-HEIZSÄULE KERAMISCHE ZUILVENTILATORKACHEL TERMOVENTILADOR CERÁMICO DE TORRE TERMOVENTILADOR CERÂMICO DE COLUNA KEPAMIKO AEPOÕEPMO ΔΑΠΕΔΟΥ KEPAMIЧЕСКИЙ ТЕПЛОВЕНТИЛЯТОР-СТОЙКА OSZLOPOS FÛT VENTILÁTOR KERÁMIA FÛT ELEMMEL TEPELNÝ SLOUPKOVÝ KERAMICKÝ VENTILÁTOR TERMOWENTYLATOR CERAMICZNY KOLUMNOWY SÕYLEFORMET KERAMISK VIFTEOVN KERAMISK PELARVÄRMEFLÄKT KERAMISK SÕJLEVARMLUFTSBLÆSER KERAAMINEN PYSTYMALLINEN TUULETINLÄMMITIN КОЛОНЕН КЕРАМИЧЕН ТЕРМОВЕНТИЛАТОР TERMOVENTILATOR CERAMIC TIP COLOANÃ

Tensione potenza	vedi targa caratteristica	Spenning se etikett se etikett
Voltage Wattage	See rating label	Jännite watt kts. arvokipi aminkalsuodet
Tension puissance	voir plaquette données	Feszültség teljesítmény	lásd adatlemez
Spannung Leistung	siehe Typenschild	Napięcie mocy	Zob. tabliczkę znamionową
Spänning Effekt	zie plaatje	Напряжение питания	смотри табличку характеристик
Tension Potencia	véase placa de características	Napětí Výkon	viz štítek charakteristik
Voltagem Potencia	ver placa de especificações	Napätie výkonu	Vid' štítok charakteristik
Táση Ioχís	βλέπε πινακίδα με характеристика	Napetost in moč	Glej napisno tablico
Spænding effekt	se typepladen	Напрежение /мощност	Виж табелката с качествата
Spänning effekt	se märkplåt	Tensiune putere	Vezi plăcuța cu caracteristici

ELECTRICAL CONNECTION (U.K. ONLY)

A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be cut off from the mains lead, and an appropriate plug fitted, as below.

WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard.

With alternative plugs not incorporating a fuse, the circuit must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug.

B) If your appliance is not fitted with a plug, please follow the instructions provided below:

IMPORTANT

The wires in the mains lead are coloured in accordance with the followin code:

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which si marked with the letter L or coloured red.

|

DESCRIZIONE

DESCRIPTION OF APPLIANCE

A Control panel

B Air outlet grille

C Base

D Pilot lamp

E Set time button

F Temperature adjustment

G MODE button

H STAND-BY button

I Oscillating button

L ON/OFF button

ELECTRICAL CONNECTION

• Before plugging the appliance into the mains socket, check that the mains power supply corresponds to the value indicated on the rating plate.
• THIS APPLIANCE COMPLIES WITH DIRECTIVE 89/336/EEC ON RADIO INTERFERENCE SUPPRESSION.

Installation

The appliance can be used on any rigid horizontal surface.

In order to avoid electre circuit overload, do not use the same socket for other appliances.

OPERATION AND USE

1. Make sure the appliance is off before plugging into the mains
2. Plug the appliance into an appropriate outlet.
3. To turn the appliance on, the switch (L) at the back must be in the I position. The appliance emits a beep. The pilot lamp(D) light also comes on and remains lit while power to the appliance is on.
4. Press button H to turn the appliance on.
5. The appliance starts up in LOW mode (minimum heat output). The display shows the current room temperature.
6. Press the MODE button (G) to switch to HIGH mode (maximum heat output). The display shows the current room temperature.
7. Press the MODE button (G) again to switch the appliance to AUTO mode.
   The display shows the temperature set point. Use the + and - buttons to set a different temperature. After a few seconds, room temperature is shown on the display.
8. Press the MODE button (G) again to switch the appliance back to LOW mode. When the MODE button is pressed continuously, the appliance switches through the following modes in sequence: LOW → HIGH → AUTO.
9. To turn the appliance off, press button H and place the switch (L) on the back in the 0 position.

MOTORISED OSCILLATING BASE

The appliance has a motorized swivelling base to distribute the air flow over a larger area. To activate the motorized base press the oscillate switch (I). The appliance swivels from right to left. To stop the appliance in the desired position, simply press button (I).

To turn the appliance off, hold button (H) down for a few seconds.

Adjusting the thermostat

1. Press the MODE button (G) until AUTO is displayed.
2. Use the + and - buttons (F) (or use the remote control) to increase or reduce the desired temperature. The thermostat will automatically maintain the temperature set and keep it constant.

3. When room temperature is 2^ C above the set temperature, the appliance goes off. The internal fan will stop after few seconds.

4. When room temperature drops below the set temperature, the appliance comes on automatically.

Note: if swing mode is active, press buttons + or - to change the set temperature, the swinging of the base will stop to allow a new temperature to be set. After the setting procedure has been completed, the swinging of the base will resume automatically.

Timer function

This function can be activated during any operating mode. The timer can be used to program the time the appliance remains in operation, from 1 to 8 hours.

Each time you press the button (E), the operating time increases by one hour.

When the timer has been set, the time decreases in steps of one hour and the time remaining is displayed. At the end of the set time the appliance goes off.

If you do not want to use the appliance with the timer, when the display shows 8 hours, press the button (E) again to return to manual operation.

Frost prevention mode

You can keep the room at a temperature of around 5^ C to prevent the room from freezing, with minimal energy consumption.

Press the MODE button (G) until AUTO is displayed. Press the button “-” to select a temperature set point of (5°C). When the room temperature drops below the set temperature, the appliance comes on automatically.

USING THE REMOTE CONTROL

The remote control should be handled with care, so avoid dropping it and never let it get wet

1. Press the STAND-BY button (H).

2. To use the oscillate (I), SET TIME (E), MODE (G) and temperature adjustment (F) buttons, see the "OPERATION AND USE" section.

3. To replace the batteries, remove the cover on the back of the remote control unit.

The remote control uses two AAA type alkaline batteries (included but packaged separately).

1. Do not mix used and new batteries with different values.

MAINTENANCE

- Always unplug the heater before cleaning.

- During the season when the appliance is in use, clean the air intake and exhaust grilles regularly using a vacuum cleaner.

- Never use abrasive powders or solvents.

Warnings

- D o not use this heater near showers, bathtubs, sinks, swimming pools, etc.

- Always use the heater in an upright position.

- Do not use the heater to dry laundry. Never obstruct the intake and outlet grilles (danger of overheating).

- The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

- The heater must be positioned at least 50 cm from furniture or other objects.

- Do not use the appliance near walls, furniture, curtains, etc.

- The use of extension leads is not recommended. However if they cannot be avoided, follow the instructions accompanying the extension lead and never exceed the power limit marked on the extension.

- CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.

- If the power cable is damaged, it must be replaced by the manufacturer, an authorised service centre or a qualified electrician in order to eliminate all risk.

- The appliance must not be positioned directly underneath a fixed power point.

- Do not use the appliance in rooms with a floor area of less than 4 m ^2 .

- The appliance is fitted with a tip-over switch which turns the appliance off if it falls over. To restart the appliance, simply place it upright again.

- When you turn the appliance on for the first time, operate it at maximum for at least two hours. During this time, you should ventilate the room to eliminate the "new" smell given off. It is normal for the appliance to make "squeaking" noises when first turned on.

The heater is fitted with a safety device which switches it off in the event of accidental overheating (eg. obstruction of air intake and outlet grilles, motor turning slowly or not at all). To reset, unplug the appliance from the mains socket for a few minutes, remove the cause of overheating then plug in again.

WARNING: In order to avoid overheating, never under any circumstances cover the appliance during operation, as this would lead to dangerous overheating.

CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.

Important information for correct disposal of the product in accordance with EC Directive 2002/96/EC.

At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service.

Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin.

FR

DESCRIPTION DE L'APPAREIL

BESCHRIJVING VAN HET APPARAAT

Symbol of a trash bin with crossed lines indicating no waste or restriction, and a solid black rectangle below (no text or labels)

Symbol of a trash bin crossed with two crossed lines, no text or labels present

Symbol of a trash bin with crossed lines indicating no waste or restriction, and a solid black rectangle below (no text or labels)