SensoTouch 3D HQ9100 - Razor PHILIPS - Free user manual and instructions

Product Type	Electric Shaver
Brand	Philips
Model	SensoTouch 3D HQ9100
Shaving System	Rotary shaving with 3D contour following heads
Number of Heads	3
Power Supply	Rechargeable Li-ion battery
Battery Life	Approximately 40 minutes of shaving
Charging Time	1 hour
Charging Voltage	100-240 V, worldwide compatible
Wet & Dry Use	Yes, suitable for wet and dry shaving
Cleaning	Washable under running water
Weight	Approximately 200 g
Dimensions	Approximately 180 x 60 x 60 mm
Display	None
Indicators	Power on/off LED
Travel Lock	Yes, press and hold power button for 3 seconds
Replaceable Heads	Yes, replacement heads available
Accessories Included	Protection cap, cleaning brush, power cord
Warranty	2 years (check local regulations)

Frequently Asked Questions - SensoTouch 3D HQ9100 PHILIPS

How do I clean the Philips SensoTouch 3D HQ9100 shaver?

Rinse the shaver heads under warm running water after each use. Do not use soap or detergents. Ensure the shaver is switched off and disconnected from the charger before cleaning. Clean the hair chamber and heads with the brush provided.

How often should I replace the shaving heads?

For optimal performance, replace the shaving heads every 12 months or when you notice a decline in shaving performance. Use only genuine Philips replacement heads.

How do I charge the shaver?

Connect the power cord to the shaver and plug into a power outlet. The charging indicator light will illuminate. Full charge takes 1 hour. Use only the provided adapter.

Can I use the shaver in the shower?

Yes, the shaver is suitable for wet and dry use. It can be used in the shower with shaving foam or gel. After use, rinse it thoroughly.

How long does the battery last on a full charge?

A fully charged battery provides approximately 40 minutes of cordless shaving. Charging time is about 1 hour.

What does the indicator light mean?

The indicator light shows the charging status. It illuminates while charging and turns off when fully charged. A low battery may flash. Refer to the manual for details.

How do I unlock the travel lock?

If the shaver is locked, press and hold the power button for 3 seconds until the indicator light flashes. The shaver will then operate normally.

Is the shaver suitable for wet shaving with foam or gel?

Yes, the shaver can be used with shaving foam, gel, or cream for a more comfortable wet shave. Rinse after use.

What accessories come with the shaver?

The package includes the shaver, protection cap, cleaning brush, and power cord. Some versions may include a travel pouch.

How do I replace the shaving heads?

Turn off and unplug the shaver. Press the release button to open the shaving unit. Remove the old heads by pulling them out. Insert new heads until they click. Close the unit.

USER MANUAL SensoTouch 3D HQ9100 PHILIPS

Read these instructions for use carefully before using the appliance and save them for future reference.

• Only use the powerplug supplied.
• The powerplug transforms 100-240 volts to a safe low voltage of less than 24 volts.
• The powerplug contains a transformer. Do not cut off the powerplug to replace it with another plug, as this will cause a hazardous situation.
• Do not use a damaged powerplug.
• If the powerplug is damaged, always have it replaced by one of the original type in order to avoid a hazard.
• Make sure the powerplug does not get wet.
• Store the appliance at a temperature between 5°C and 35°C.
• Always unplug the shaver before cleaning it under the tap.
• The appliance complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap.

Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt.

Using the appliance

Personal Comfort Control

- The Personal Comfort Control system allows you to adapt the shaver to your skin type.

- You can set the shaver to 'Normal' for a fast and comfortable close shave.

- You can set the shaver to 'Sensitive' for a comfortable close shave with optimal skin comfort.

- The 'S' position is best suited for sensitive skin.

- The 'N' position is best suited for normal skin.

- The in-between positions are suitable for skin types between normal and sensitive.

Shaving

I Put the appliance plug in the shaver.

2 Put the powerplug in the wall socket.

3 Switch the shaver on by pressing the on/off button once.

4 Move the shaving heads quickly over your skin, making both straight and circular movements.

ENGLISH6

• Shaving on a dry face gives the best results.
• Your skin may need 2 or 3 weeks to get accustomed to the Philishave system.

5 Switch the shaver off by pressing the on/off button once.

6 Put the protection cap on the shaver every time you have used it, to prevent damage.

Trimming

For grooming sideburns and moustache.

■ Open the trimmer by pushing the slide downwards.

The trimmer can be activated while the motor is running.

2 Close the trimmer with your index finger.

Cleaning and maintenance

Regular cleaning guarantees better shaving performance.

The easiest and most hygienic way to clean the appliance is to rinse the shaving unit and the hair chamber with hot water every time you have used the shaver.

Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt.

Every day: shaving unit and hair chamber

Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver.
2 Press the release button to open the shaving unit.
3 Clean the shaving unit and the hair chamber by rinsing them under a hot tap for some time.

Make sure the inside of the shaving unit and the hair chamber have been cleaned properly.

4 Rinse the outside of the appliance.

5 Close the shaving unit and shake off excess water.

Never dry the shaving unit with a towel or tissue as this may damage the shaving heads.

6 Open the shaving unit again and leave it open to let the appliance dry completely.

You can also clean the hair chamber without water by using the brush supplied.

Every six months: shaving heads

Open the shaving unit, turn the lock anticlockwise (1) and remove the retaining frame (2).
2 Clean the cutters and guards with the brush supplied.

Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored.

3 Put the shaving heads back into the shaving unit. Put the retaining frame back into the shaving unit and turn it clockwise.
4 Close the shaving unit.

Trimmer

Clean the trimmer every time you have used it.

Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver.
2 Clean the trimmer with the brush supplied.

3 Lubricate the trimmer teeth with a drop of sewing machine oil every six months.

Storage

- Put the protection cap on the shaver to prevent damage.

Replacement

Replace the shaving heads every two years for optimal shaving results.

Replace damaged or worn shaving heads with HQ9 Philishave shaving heads only.

I Switch the shaver off, remove the powerplug from the wall socket and pull the appliance plug out of the shaver.

2 Press the release button to open the shaving unit.

3 Turn the lock anticlockwise (1) and remove the retaining frame (2).

4 Remove the shaving heads and place new ones in the shaving unit.
Make sure that the projections of the shaving heads fit exactly into the recesses.
5 Put the retaining frame back into the shaving unit (1) and turn the lock clockwise (2).
6 Close the shaving unit.

Accessories

The following accessories are available:

• HQ8000 powerplug.
• HQ9 Philishave shaving heads.
• HQ110 Philishave shaving head cleaner (shaving head cleaning spray).

Guarantee & service

If you need information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV.

Troubleshooting

I Reduced shaving performance

▶ Cause 1: the shaving heads are dirty.
- The shaver has not been rinsed long enough or the water used was not hot enough.

- Clean the shaver thoroughly before you continue shaving. See chapter 'Cleaning and maintenance'.

▶ Cause 2: long hairs are obstructing the shaving heads.

- Clean the cutters and guards with the brush supplied. See chapter 'Cleaning and maintenance', section 'Every six months: shaving heads'.

▶ Cause 3: the shaving heads are damaged or worn.

- Replace the shaving heads. See chapter 'Replacement'.

2 The shaver does not work when the on/off button is pressed.

▶ Cause 1: the appliance is not connected to the mains.

- Put the powerplug in the wall socket.

3 The shaving unit has come off the shaver.

ENGLISH12

▶ Cause: the shaving unit has not been placed correctly.
- If the shaving unit becomes detached from the shaver, you can easily reattach it ('click').

Penting

Menggunakan alat

Kontrol Kenyamanan Pribadi

3 Putar kunci ke kiri (1) lalu lepaskan bingkainya (2).

Cạo râu

剃须

自我舒适度调节

1 将产品插头插入剃须刀。

2 将电源插头插入壁装插座。

3 按开/关钮来启动剃须刀。

用于修剪鬓角和小胡子。

附件

可选配以下附件：

5 按一下開/關按鈕關閉電鬍刀的電源。

修剪鬢角及髭鬍。

每次使用鬢角刀後，請進行清潔。

保管

蓋上電鬍刀保護蓋，以避免損壞。

更換

2 按下釋放按鈕，打開電鬍刀組。

제품 사용