Xanab - Radio SCOTT - Free user manual and instructions

Product Type	Portable Radio
Brand	SCOTT
Model	Xanab
Dimensions (L x D x H)	226 x 70 x 127 mm
Weight	0.55 kg
Power Source	AC 230V ~ 50Hz or DC 4.5V (3 x C size batteries)
Frequency Bands	MW 540-1600 kHz, FM 87.5-108 MHz, LW 150-280 kHz
Antenna	FM: Telescopic rod; MW/LW: Built-in ferrite bar
Speaker	3 inch, 8 ohm dynamic
Output Power	300 mW (10% THD)
Phone Jack	3.5 mm for earphone/headphone
Controls	Tuning knob, Band selector (MW/FM/LW), Volume/Power ON/OFF knob
Safety Features	Ventilation clearance 5 cm; Do not expose to dripping/splashing; No user-serviceable parts
Environmental Protection	Do not dispose with household waste; recycle per WEEE directive
Battery Disposal	Do not throw batteries in fire; follow local recycling guidelines
Operation Climate	Moderate climates only (not tropical)

Frequently Asked Questions - Xanab SCOTT

How do I power the radio?

You can power the radio via AC mains (230V ~ 50Hz) using the supplied cord, or with 3 C-size batteries (DC 4.5V). Ensure the voltage matches your local supply for AC operation.

How do I install batteries?

Open the battery compartment at the bottom and insert 3 C-size batteries (UM-2) with correct polarity as indicated. Always dispose of batteries properly and do not throw them in fire.

Which frequency bands does the radio support?

The radio supports MW (540-1600 kHz), FM (87.5-108 MHz), and LW (150-280 kHz). Use the band selector switch to choose the desired band.

How do I tune to a station?

Rotate the tuning knob slowly until you hear the desired station. For best FM reception, fully extend the telescopic antenna and adjust its direction.

Can I use headphones?

Yes, insert a 3.5 mm plug earphone or headphone into the phone jack. The built-in speaker will be automatically disconnected for private listening.

What is the output power?

The output power is 300 mW at 10% total harmonic distortion (THD). This is sufficient for personal listening in a room.

How do I clean the radio?

Unplug the radio from power. Wipe the exterior with a dry, soft cloth. Do not use liquid cleaners or allow moisture to enter the device. Ensure ventilation openings are not blocked.

What safety precautions should I follow?

Do not expose the radio to rain or moisture. Maintain at least 5 cm clearance around the device for ventilation. Do not place objects with liquids like vases on top. Refer servicing to qualified personnel only.

How do I reset the radio if it malfunctions?

If the radio malfunctions due to electrostatic discharge, unplug it from the mains supply and remove batteries if used. Wait a few seconds, then reconnect power.

How should I dispose of the radio at end of life?

Waste electrical products should not be disposed of with household waste. Recycle where facilities exist. Check with your local authority or retailer for recycling advice under the WEEE directive.

USER MANUAL Xanab SCOTT

INSTRUCTION MANUAL

CE

ATTENTION

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

ATTENTION

To reduce the risk of electric shock, do not remove the cover. There are no user serviceable parts inside the unit. Refer all servicing to qualified personnel.

The lightening flash with arrowhead symbol within the triangle is a warning sign alerting the user of "dangerous voltage" inside the unit.

The exclamation point within the triangle is a warning sign alerting the user of important instructions accompanying the product.

WARNING

To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.

IMPORTANT

DO NOT THROW BATTERIES IN FIRE!

THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING.

ENSURE A MINIMUM DISTANCE OF 5 CM AROUND THE APPARATUS FOR SUFFICIENT VENTILATION.

ENSURE THAT THE VENTILATION IS NOT IMPEDED BY COVERING THE VENTILATION OPENINGS WITH ITEMS, SUCH AS NEWSPAPERS, TABLE-CLOTHS, CURTAINS, ETC..

DO NOT PLACE NAKED FLAME SOURCES, SUCH AS LIGHTED CANDLES ON THE APPARATUS.

TAKE ATTENTION TO THE ENVIRONMENTAL ASPECTS OF BATTERY DISPOSAL.

USE THE APPARATUS ONLY IN MODERATE CLIMATES (NOT IN TROPICAL CLIMATES).

DO NOT EXPOSE THE APPARATUS TO DRIPPING OR SPLASHING.

DO NOT PLACE OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, ON THE APPARATUS.

The mains plug shall remain readily operable.

In case of misfunction due to electrostatic discharge the apparatus has to be reset by disconnecting it from mains supply.

LOCATION OF CONTROLS

1. Tuning knob
2. Power indicator
3. Band Selector Switch
4. Telescopic antenna
5. Phone jack
6. AC socket
7. Dial scale
8. Battery compartment

9. Speaker

10. Volume control and Power ON / OFF

POWER SUPPLY

AC POWER OPERATION

1. Before operating, please check carefully that the voltage as indicated on your set corresponds to the voltage of your local area.
2. Insert the AC power cord into a convenient standard AC outlet.

USING BATTERIES

Insert 3 pieces of C size batteries into the battery compartment at the bottom of the unit. Make sure the batteries are connected with the correct polarity.

USING THE RADIO

1. Switch on the set by rotating the Volume control and Power ON / OFF knob counter clockwise.
2. Turn the tuning knob until the desired station is heard.
3. To turn off the radio, rotate the VOLUME control and power ON/OFF knob clockwise until a slight click is heard.
4. Select either MW, FM or LW band with the band selector switch.

PHONE JACK

For private listening connect an earphone or headphone with a 3.5 mm plug to the phone jack. The built -in speaker will be automatically disconnected.

TELESCOPIC ANTENNA

Extend the telescopic rod antenna to its full length, adjust the direction and angle for best FM reception.

SPECIFICATIONS

Frequency range : MW 540 - 1600 kHz FM 87.5 - 108 MHz LW 150 - 280 kHz

Antenna : FM : telescopic rod antenna LW/MW : Built - in ferrite bar antenna

Speaker : 3 inch 8 ohm dynamic speaker

Output power : 300 mW (10% THD)

Phone jack : 3.5 mm

Dimensions : 226 (L) x 70 (D) x 127 (H) mm

Power source : AC : 230V \~ 50Hz DC : 4.5V 3 x UM 2 / SIZE " C "

Weight : 0.55 KGS

Where to place the item :

Today's furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an extensive range of cleaning products. Therefore, the possibility that some of these substances contain components that react adversely to the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the appliance can cause discoloring to furniture surfaces. If necessary, place the appliance on a non-slide surface.

If at any time in the future you should need to dispose of this product please note that Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive)