Missy WH A/60 - Range hood ELICA - Free user manual and instructions

Product Type	Range Hood
Brand	Elica
Model	Missy WH A/60
Width	60 cm
Installation Type	Wall-mounted (chimney)
Finish	White
Control Type	Electronic push buttons
Number of Speeds	3 + Boost
Extraction Rate (Max)	Approx. 650 m³/h
Noise Level (Max Speed)	65 dB(A)
Lighting	LED (2 x 2W)
Filter Type	Aluminum grease filter + optional carbon filter
Number of Filters	1 (grease filter)
Motor Wattage	200 W
Power Supply	220-240 V / 50 Hz
Energy Class	B
Annual Energy Consumption	Approx. 65 kWh/year
Dimensions (H x W x D)	60 x 60 x 50 cm (approx.)
Weight	15 kg
Duct Diameter	150 mm
Recirculation Mode	Possible (with carbon filter)
Grease Filter Cleaning	Dishwasher safe or hand wash
Carbon Filter Replacement	Every 3-6 months
Warranty	2 years (subject to conditions)

Frequently Asked Questions - Missy WH A/60 ELICA

How do I install the Elica Missy WH A/60 hood?

Installation must be carried out by a qualified technician. Ensure the hood is mounted at a minimum height of 65 cm above gas hobs and 50 cm above electric hobs. Follow the drilling template and secure the chimney correctly. For detailed steps, refer to the user manual section on installation.

How often should I clean the grease filters?

Grease filters should be cleaned every 2-3 months, or more frequently if you cook heavily. They can be washed in the dishwasher or by hand with warm soapy water. Ensure they are completely dry before reinstalling.

Does this hood support recirculation mode?

Yes, the Elica Missy WH A/60 can be used in recirculation mode with an optional carbon filter. The carbon filter absorbs odors and needs to be replaced every 3-6 months depending on usage.

What is the noise level of the hood?

The noise level varies by speed: approximately 45 dB(A) on the lowest speed and up to 65 dB(A) on the boost setting. It is considered average for a range hood.

How do I replace the LED lights?

The LED lights are integrated and should be replaced by a qualified technician. Do not attempt to replace them yourself unless specified in the manual. Contact customer support for assistance.

What is the extraction capacity of this hood?

The maximum extraction rate is approximately 650 m³/h on the boost setting. Normal speeds range from 200 to 450 m³/h. This is suitable for kitchens up to 20 m².

Can I use the hood without ducting?

Yes, you can use it in recirculation mode. You need to install a carbon filter and ensure the hood is properly vented into the room. The recirculation kit may be sold separately.

How do I reset the filter alarm?

After cleaning or replacing the filters, press and hold the reset button for 3 seconds until the indicator light turns off. The exact procedure may vary; check your user manual for details.

What is the warranty period?

Elica offers a standard 2-year warranty for manufacturing defects. Registration may extend the warranty. Keep your purchase receipt as proof.

Where can I download the user manual?

You can download the user manual for free from notice-facile.com or the official Elica website. The manual includes installation, operation, and maintenance instructions.

USER MANUAL Missy WH A/60 ELICA

EN Instruction on mounting and use

Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. This appliance is intended to be used in household and similar applications such as: - staff kitchen areas in shops, offices and other working environments; - farm houses; - by clients in hotels, motels and other residential type environments; - bed and breakfast type environments.

Note: The parts marked with the symbol "(*)" are optional accessories supplied only with some models or otherwise not supplied, but available for purchase.

Caution

• Before any cleaning or maintenance operation, disconnect hood from the mains by removing the plug or disconnecting the mains electrical supply. • Always wear work gloves for all installation and maintenance operations.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

- Children shall not be allowed to tamper with the controls or play with the appliance.

- Cleaning and user maintenance shall not be made by children without supervision.

- The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels.

- The hood must be regularly cleaned on both the inside and outside (AT LEAST ONCE A MONTH).

- This must be completed in accordance with the maintenance instructions provided. Failure to follow the instructions

provided regarding the cleaning of the hood and filters will lead to the risk of fires.

• Do not flambé under the range hood.
• For lamp replacement use only lamp type indicated in the Maintenance/Replacing lamps section of this manual.

The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances.

Any frying must be done with care in order to make sure that the oil does not overheat and ignite.

CAUTION: Accessible parts of the hood may become hot when used with cooking appliances.

- Do not connect the appliance to the mains until the installation is fully complete.

- With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities.

- The air must not be discharged into a flue that is used for exhausting fumes from appliance burning gas or other fuels.

- Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks.

- Never use the hood without effectively mounted grids.

- The hood must NEVER be used as a support surface unless specifically indicated.

- Use only the fixing screws supplied with the product for installation or, if not supplied, purchase the correct screws type.

- Use the correct length for the screws which are identified in the Installation Guide.

- In case of doubt, consult an authorized service assistance center or similar qualified person.

WARNING!

• Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.
• Do not use with a programmer, timer, separate remote control system or any other device that switches on automatically.

- This appliance is marked according to the European directive 2012/19/EC on Waste Electrical and Electronic Equipment (WEEE).

- By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.

• The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal.
• For further detailed information regarding the process, collection and recycling of this product, please contact the appropriate department of your local authorities or the local department for household waste or the shop where you purchased this product.

Appliance designed, tested and manufactured according to:

• Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC 62233. • Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO 5168; EN/IEC 60704-1; EN/IEC 60704-2-13; EN/IEC 60704-3; ISO 3741; EN 50564; IEC 62301.
• EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2; EN/IEC 61000-3-2; EN/IEC 61000-3-3. Suggestions for a correct use in order to reduce the environmental impact: Switch ON the hood at minimum speed when you start cooking and keep it running for a few minutes after cooking is finished. Increase the speed only in case of large amount of smoke and vapor and use boost speed(s) only in extreme situations. Replace the charcoal filter(s) when necessary to maintain a good odor reduction efficiency. Clean the grease filter(s) when necessary to maintain a good grease filter efficiency. Use the maximum diameter of the ducting system indicated in this manual to optimize efficiency and minimize noise.

Use

The hood is designed to be used either for exhausting or filter version.

Ducting version

The hood is equipped with a top air outlet B for discharge of fumes to the outside (exhaust pipe and pipe fixing clamps not provided).

Attention! If the hood is supplied with carbon filter, then it must be removed.

Filter version

In the case of not being able to discharge the fumes and the steam of cooking outside, the hood in the filter version can be used mounting the F deflector on the flue and one or more carbon filters (on the basis of the model possessed). The fumes and steam are recycled into the kitchen through upper grill H.

Attention! If the hood is not supplied with carbon filter,

then it must be ordered and mounted.

The models with no suction motor only operate in ducting mode, and must be connected to an external suction device (not supplied).

The connecting instructions are supplied with the peripheral suction unit.

Installation

Fig. 3

The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers.

If the instructions for installation for the gas hob specify a greater distance, this must be adhered to.

Electrical connection

The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation. If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III, in accordance with installation instructions.

WARNING!

Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled.

Mounting

Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood.

Do not tile, grout or silicone this appliance to the wall. Surface mounting only.

Operation

The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights.

Maintenance

Cleaning

Clean using ONLY a cloth dampened with neutral liquid detergent. DO NOT CLEAN WITH TOOLS OR INSTRUMENTS. Do not use abrasive products. DO NOT USE ALCOHOL!

Grease filter

Fig. 1

Traps cooking grease particles.

The grease filter must be cleaned once a month using non aggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease filter may discolor slightly, but this does not affect its filtering capacity. To remove the grease filter, pull the spring release handle.

Charcoal filter (filter version only)

Fig. 2

It absorbs unpleasant odors caused by cooking.

The saturation of the charcoal filter occurs after more or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter. In any case it is necessary to replace the cartridge at least every four months. The charcoal filter may NOT be washed or regenerated. Remove the grease filters. Fit the charcoal filters over the motor. Align the pins R on the cowl with the slots S, then turn the filter clockwise until it locks in place. Reverse the above procedure to remove the charcoal filters. Refit the grease filters.

Replacing lamps

Fig. 1

Disconnect the appliance from the electricity. Warning! Prior to touching the light bulbs ensure they are cooled down. Remove cover A to access the lamp housing A. Replace the damaged lamp. Use E14 3W max LED lamps only. For more details, check enclosed leaflet "ILCOS D" (alfanumeric position "1d"). If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance.

On some models ONLY:

A Non Return Backdraft Damper is included in the supply, as an optional accessory to be installed under certain installation conditions (i.e., if there is no protection against accidental backdraft of air from the outside). The damper must be installed inside the dedicated housing, inside of the Air Outlet Fitting, before installing the flue.

BG - Instructions for installation and use

- Waste Electrical and Electronic Equipment (WEEE).

RO - Installation and use instructions

SL - Installation and use instructions

Strictly follow the instructions provided in this manual. We disclaim any liability for accidents, malfunctions, or fire on the appliance resulting from failure to comply with the instructions in this manual. The kitchen hood has the function of extracting smoke and steam during cooking and is intended for household use only.