AJ3121 - Radio PHILIPS - Free user manual and instructions

Product Type	Clock Radio
Brand	Philips
Model	AJ3121
Color	Black
Dimensions (approx)	20 x 10 x 15 cm
Weight (approx)	0.5 kg
Power Supply	AC 100-240V, 50/60Hz
Battery Backup	1 x CR2032 for clock memory
Radio Bands	FM (87.5-108 MHz), AM (530-1600 kHz)
Display	LED, white digits
Alarm	Dual alarm with buzzer or radio
Snooze	Yes, 9 minutes
Sleep Timer	Up to 90 minutes
Speaker	Mono, 3.5 mm
Headphone Jack	3.5 mm
Controls	Rotary knob for tuning/volume, buttons for alarm/time set
Maintenance	Clean with soft dry cloth; do not use liquids
Safety	Keep away from water and heat sources
Repair	Contact Philips authorized service center
Spare Parts Availability	Contact Philips support or authorized dealers

Frequently Asked Questions - AJ3121 PHILIPS

How do I set the time on my Philips AJ3121?

Press and hold the CLOCK button until the hour digits flash. Use the TUNING knob to set the hour, then press CLOCK again to set minutes. Repeat for minutes.

Why is there no sound from the radio?

Check the volume level. Ensure the headphone is not plugged in (if inserted, speakers mute). Also confirm the radio is tuned to a station with signal.

How do I set the alarm?

Press the ALARM 1 or ALARM 2 button. The alarm time will flash. Use the TUNING knob to adjust hour and minute. Press the alarm button again to confirm. Select alarm source: BUZZER or RADIO.

How do I activate the snooze function?

When the alarm sounds, press the SNOOZE button (usually the large top button). The alarm will stop and sound again after 9 minutes.

What type of battery does the clock use for backup?

The clock uses a CR2032 lithium coin cell battery to keep time during a power outage. Replace it when the display is dim or time resets.

How do I clean my Philips AJ3121?

Unplug the unit. Use a soft, dry cloth to wipe the exterior. Do not use water, solvents, or abrasive cleaners.

Can I use headphones with this radio?

Yes, plug a 3.5 mm headphone into the jack on the side. The internal speaker will mute automatically.

Why does the radio not turn on?

Check the power cord is securely connected to the wall outlet. If using batteries for backup, ensure they are not dead. Try a different outlet.

How do I adjust the brightness of the display?

This model has a fixed brightness level. If it is too bright, you can place the radio at a distance or angle it away. No brightness control is available.

Where can I find the user manual for AJ3121?

You can download the PDF manual from the Philips support website or from notice-facile.com. Search for model AJ3121.

USER MANUAL AJ3121 PHILIPS

English

CONTROLS (see fig. 1)

① SET TIME /ALARM SET

- sets the clock time

- sets the alarm time

② HR / MIN

- adjusts the hours / minutes for clock / alarm / sleep time

③REPEAT ALARM / SLEEP OFF

- switches off the active alarm for a 9 minutes period

- switches off the radio sleep function

④ ALARM RESET

- stops the active alarm for 24 hours

⑤SLEEP

- activates the radio for sleep function

- adjusts the sleep period

⑥TUNING - tunes to radio stations

⑦ ALARM indicator - lights up when alarm is activated.

⑧FM/MW - selects FM/MW waveband

⑨VOLUME - adjusts the sound level

⑩RADIO / ALARM

OFF: switches off the radio/alarm

RADIO ON: switches on the radio

ALARM - RADIO: activates the radio for alarm

ALARM - BUZZER: activates the buzzer for alarm

⑪Power cord - connects to wall outlet

⑫Pigtail - improve FM reception

⑬ Battery door - opens to store a 9 volts 6F22 battery (not included) for clock memory backup.

INSTALLATION

POWER SUPPLY

1 Check if the power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center.
2 Connect the power cord to the wall outlet.
3 To disconnect the set from the power supply completely, remove the plug from the wall outlet.

For users in the U.K.: please follow the instructions on the lower left handed corner of the sheet.

CLOCK MEMORY BACKUP

The clock memory backup allows your alarm and clock time settings to be stored for up to a day when there is a power interruption e.g. power failure. The complete clock radio and display illumination will be switched off. As soon as the power supply returns, the display will indicate the correct time.

1 Remove the battery door to insert a 9 volts 6F22 type battery (not included) for backup.
2 Replace the battery door.

NOTE: If no backup battery is installed or the power interruption is prolonged, you will need to set the clock and alarm times again.

Batteries contain chemical substances so they should be disposed of properly.

Standby power consumption ....1.8 W

RADIO

You can use this set solely as a radio!

1 Adjust RADIO / ALARM to RADIO ON to switch on the radio.
2 Select your waveband by adjusting the FM/MW switch.
3 Adjust TUNING to tune to your desired station.
4 Turn the VOLUME control to adjust the volume level.
5 Adjust RADIO / ALARM to OFF to switch off the radio.
- When sleep function is activated, to switch off the radio, you also need to press SLEEP OFF button.

To improve reception:

FM: Extend and position the pigtail fully to obtain optimal reception.

MW: uses a built-in antenna inside the set. Direct the antenna by adjusting the position of your set.

SETTING THE CLOCK / ALARM TIME

The time is displayed using the 24-hour clock.

1 Hold down SET TIME / ALARM SET.
2 Press HR or MIN repeatedly, or hold down HR or MIN to adjust minute and/or hour.
3 Release SET TIME / ALARM SET and HR or MIN when you reach the correct setting.

→The set clock time will show on the display and start to run.

SELECTING THE ALARM MODE

To use the alarm, you must set the alarm time first. You can choose from two different alarm modes to wake you up: by radio or buzzer.

1 Select your choice of alarm mode by adjusting RADIO / ALARM to RADIO or BUZZER.

→ The alarm indicator (AL) will light up.

Helpful Hint:

• If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you.
• The buzzer is set at a fixed volume and cannot be adjusted.

SWITCHING OFF THE ALARM

There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24 hour alarm reset option will be automatically selected after 59 minutes, from the time your alarm time first goes off.

24 HOUR ALARM RESET

If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day:

• Press ALARM RESET during the alarm call.
  → The alarm indicator (AL) will remain on.

CANCELING THE ALARM COMPLETELY

To cancel the set alarm time before it goes off, or during the alarm call:

• Adjust RADIO / ALARM to OFF position.
  → The alarm indicator (AL) will light off.

REPEAT ALARM

This repeats your alarm call at 9-minute intervals.

1 During the alarm call, press REPEAT ALARM
2 Repeat if desired for up to 59 minutes.
→ The alarm indicator (AL) will remain on.

SLEEP

This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. This allows you to lie back, listen and fall asleep. The maximum sleep time is 1 hour and 59 minutes.

Setting SLEEP

1 Set RADIO / ALARM to OFF position.
2 Set the sleep time to activate sleep function by selecting on the following ways:
- Simply press SLEEP to set your sleep time to 59 minutes.
- Hold down SLEEP, and press MIN repeatedly to adjust sleep time from 59 minutes downward.
- Hold down SLEEP and press HR to get one more hour sleep time (1:59) → To cancel sleep, press SLEEPOFF.

SAFETY INFORMATION

• Install the unit near the AC outlet and where the AC power cord plug can be easily reached.
• Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnet device shall remain readily operable.
• Place the set on a hard and flat surface so that the system does not tilt.
• If you do not intend to use the set for a long time, withdraw the power plug from the wall outlet. In addition to this, it is advisable to remove the battery from the clock radio. This will prevent any danger of leakage and the clock radio will not be damaged.
• Do not expose the set, batteries to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.
• The apparatus shall not be exposed to dripping or splashing.
• Adequate ventilation with a minimum gap of 15cm between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up.
• The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc..
• No objects filled with liquids, such as vases, shall be placed on the appartus.
• No naked flame sources, such as lighted candles, should be placed on the apparatus.
• To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.

CAUTION

Use of controls or adjustments or performance of procedures other than herein may result in unsafe operation.

This set complies with the radio interference requirements of the European Community.

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center.

WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock.

Problem

- Possible Cause

- Remedy

No sound/power

- Volume not adjusted

- Adjust the volume

Occasional crackling sound during FM broadcast

- Weak signal

- Adjust the position of the Pigtail

Continuous crackling/hiss disturbance during MW broadcast

– Electrical interference from TV, computer, fluorescent lamp, etc.

- Move set away from other electrical equipment

The alarm does not function

– Alarm time not set and or alarm mode not selected

- Set the alarm time and / select alarm mode

– Volume too low for RADIO

- Adjust the volume

– Radio alarm not adjusted to radio station

- Tune to a radio station

ENVIRONMENTAL INFORMATION

We have reduced packaging to the minimum for easy separation into two materials: paper and cardboard.

Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe local regulations on the disposal of packing materials and old equipment.

Disposal of your old product

Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.

When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC.

Please inform yourself about the local separate collection system for electrical and electronic products.

Please act according to your local rules and do not dispose of your old products with your normal household waste. The correct disposal of your old product will help prevent potential negative consequences for the environment and human health.

Meet Philips at the Internet

http://www.philips.com

AJ3121

Printed in China PDCC-JH-ZC-0716