TX-1000AE - Cash register Posiflex - Free user manual and instructions

USER MANUAL TX-1000AE Posiflex

TX-1000A/1000AE Fanless POS Box User Manual

Package Contents

√ POS box....(x 1)
√ Power adaptor....(x 1)
√ Power cord....(x 1)

FCC NOTES

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

CE CLASS A WARNING

This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment may cause radio interference.

AVERTISSEMENT CE CLASSE A

Warranty will terminate automatically when the machine is opened by any person other than the authorized technicians. The user should consult his/her dealer for the problem happening. Warranty voids if the user does not follow the instructions in application of this merchandise. The manufacturer is by no means responsible for any damage or hazard caused by improper application.

LIMITES DE GARANTIE

This equipment is not suitable for use in locations where children are likely to be present.

CONSIGNES DE SÉCURITÉ

Power cord shall be connected to a socket-outlet with earthing connection

ATTENTION

Risk of explosion if battery is replaced by an incorrect type. Dispose of expended battery in accordance with local disposal regulations.

AVERTISSEMENT DE BATTERIE

Views of the TX-1000A/1000AE

Front View of TX-1000A

V of TX-1000A Micro SD Card Slot Power Status LED Indicator Power Button MICRO SD POSIFLEX Micro USB Port

Front View of TX-1000AE

V 01 TX-1000AE Micro SD Card Slot Power Status LED Indicator Power Button 24V PoweredUSB POSIFLEX Micro USB Port

Rear View

I/O Interface

Bottom View

Off View Rubber Pad Service Window Rubber Pad

View of Rear I/O Interface of TX-1000A/1000AE

1 2 3 4 5 6 7 8 9 10 USB3 USB4 USB5 USB1 USB12 USB4 USB5 USB5 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4 USB4

1 Mic-in & Line-out Combo
3 COM ports (DB9)
5 USB 3.0 port
7 LAN port (RJ45)
9 CR port

2 COM ports (RJ50)
4 12V poweredUSB (Only for TX-1000AE)
6 USB 2.0 ports
8 HDMI ports
10 12 VDC-IN power jack

Connecting Power Adapter and I/O Cables

Please follow the steps described below to connect power adapter and I/O cables.

1. Connect power adapter to DC-IN power connector on the I/O plate
2. Connect another end of power adapter to the electrical outlet.

CAUTION: On doing insertion or extraction of a cable connector, please always hold the connector head itself instead of pulling the cable wire. Doing this could damage the cables and ports, which is considered as an artificial damage and is not covered by the warranty. The means of power cord should be connected to a socket-outlet with earthing connection.

There are two HDMI ports for TX-1000A/1000AE. Please refer to the below table to connect the 1st monitor (main monitor) and the 2nd monitor.

	1^st Monitor (Main Monitor)		2^nd Monitor
	Display	Touch	Display	Touch
TX-1000A	HDMI 1	USB 1	HDMI 2	USB 2-6
TX-1000AE	HDMI 1	Powered USB 1 or USB 1	HDMI 2	USB 2-6

Audio-out Control For HDMI1:

You can find the APP named “AudioOutSwitch” in your TX-1000A/1000AE system. This APP is for POS monitor without built-in speaker which connected through HDMI1 interface. Therefore, if there is no built-in speaker in your 1 ^st monitor, you can utilize this APP to switch the audio out from the 1 ^st monitor to the TX POS box.

Switch To Speaker : OFF

Switch To Speaker : ON

Switch to Speaker: OFF

→ Click the button. When it shows OFF, it means the audio would NOT come out from the TX POS box.

Switch to Speaker: ON

→ Click the button. When it shows ON, it means the audio would come out from the TX POS box.

For HDMI2:

There is no audio out through HDMI2 interface.

Mounting the TX-1000A/1000AE on the Wall (Optional)

Please follow the steps described below to mount TX-1000A/1000AE onto the wall using WB-4200 wall-mount kits.

1. Refer to WB-4200 installation guide to fix the wall mount bracket onto the wall using plastic anchors and screws.

Simple gray rectangular shape with four corner circular markers, no text or symbols present.

1. Insert four screw bolts into the 4 screw bolt holes.

Close-up of a black electronic component with four circular buttons and mounting holes (no text or symbols visible)

1. Align 4 screw bolts to four mounting holes of the wall-mount bracket as shown in the figure. Then slide down the system along the rail until it is locked into place with a click sound.

Four identical grayscale square panels with small circular cutouts, arranged in a 2x2 grid (no text or symbols)

Powering ON/OFF TX-1000A/1000AE

Power ON TX-1000A/1000AE

Press down the power button and hold down the power button for at least 3 seconds to power on TX-1000A/1000AE.

Power OFF TX-1000A/1000AE

In most cases, push the power button again to power off the system. However, if TX-1000A/1000AE halts for unknown reasons, please be advised to hold the power more than 10 seconds to initiate a forced shutdown.

Close-up of a black POSIFLEX projector with a circular lens (no visible text or symbols)

Power Status LED Indicator

Power LED indicator is mainly responsible for notifying users of the current system status by emitting various LED signals. The chart provided below will offer helpful information that you need to interpret LED status.

LED	Status	Description
Power	Solid green	System power ON
	Solid red	System standby

Installing Optional Peripheral Devices

TX-1000A/1000AE can work with multiple optional peripheral devices, such as LCD monitor, cash drawer and the like. Before installing an optional peripheral device, make sure that the system is powered off and the external power source is removed from the POS box to prevent electric hazard. For the detailed instruction, refer to each of the user manuals of the optional peripheral devices.

Operation Environment

To prevent TX-1000A/1000AE from overheating, it is suggested to position your terminal in a well-ventilated working environment. In doing so, please be advised to keep the POS box at least 25mm away from other devices to ensure the machine is properly cooled down and functioning normally.

Specifications

	TX-1000A/1000AE
CPU	Rockchip RK3399
System Memory	4GB DDR4
Storage Port	32GB / 64GB / 128GB eMMC + micro SD card slot
Power Supply	12V/40W power adaptor as default12V/150W power adaptor with PoweredUSB
OS support	Android 10 w/GMS
Serial Port	2 x DB-9 COM ports + 1 x RJ-50 COM port + COM5/6 pin headers in service window5V/12V support on all COM ports
Standard USB Port	5 x USB 2.0 + 1 x USB 3.0 port
LAN Port	1 x 10 /100 /1000 Mb
Display Port	2 x HDMI port
CR Port	1 port, controlling 2 CRs
DC Jack	1 port
Expansion Slot	1 x M.2 socket (M.2 2230 / E key) for WiFi/BT module
Audio	1 x Mic-in & Line-out combo jack + 1 x internal speaker
LED Indicator	power status LED
PoweredUSB port	TX-1000A: N/ATX-1000AE: 1 x 24V + 2 x 12V
Dimension(W x D x H in mm)	220 mm x 202 mm x 56 mm
Weight	1.2 kg
Regulation Rules	FCC/CE
Environmental Requirements	Operating : 0°C - 40°C, 20%RH - 90%RHStorage : -20°C - 60°C, 10%RH - 90%RH

Outline Dimension

Front view of a portable electronic device with indicator lights and ports (no visible text or symbols)

220 75 75

56 201.8

※ The product information and specifications are subject to change without prior notice. To get the detailed information on TX-1000A/1000AE, please check this model from Posiflex Global Website (http://download.posiflex.com/en-global/Download/download).