HEA1187 - Fridge DAEWOO - Free user manual and instructions

USER MANUAL HEA1187 DAEWOO

White DAEWOO portable heater with ventilation slots and control buttons (no visible text or symbols on body)

Mini Convector Heater

450W WITH OVERHEAT PROTECTION

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed. These instructions should be saved for future reference:

• Read and familiarise yourself with all operating instructions before using this Mini Convector Heater.
• Before plugging your unit into the mains, visually check that the unit is intact and has not suffered any transit damage.
• WARNING: In order to avoid overheating, do not cover the heater.
• Do not install the appliance directly below an electrical socket.
• Do not use this heater with a programmer, timer, separate remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
• Do not use this heater with an extension cable.
• Check that the voltage indicated on the data plate corresponds with that of the local network before connecting the appliance to the mains power supply.
• Close supervision is required when using this appliance near children.
• Never leave this appliance within reach of children.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
• Children of less than 3 years should be kept away unless continuously supervised.
• Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
• CAUTION — some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
• This product shall also not be installed in a bath, shower or a swimming pool
• Do not immerse the appliance or its cord in water or any other liquids.
• Do not leave the appliance unattended during use.
• Do not leave the appliance unattended whilst connected to the mains supply.
  • Always use this appliance on a solid, level, non-flammable surface.
• Do not use this appliance outdoors.
• It is imperative to unplug the power cord after the appliance has been used,

before it is cleaned and whilst being repaired.

• Repairs to electrical appliances should only be performed by a qualified electrician. Improper repairs may place user at serious risk.
• Do not operate this appliance with a damaged plug or cord, after a malfunction or after being dropped or damaged in any way.
• Regular, periodic checks should be carried out on the mains cable to ensure no damage is evident. Should there be any signs of damage the appliance should not be used.
• If the power cable is damaged, it should only be replaced by the manufacturer or a suitable qualified after-sales-service in order to avoid a hazard
• Do not allow the mains cable to hang over sharp edges or come in contact with hot surfaces.
• Do not run the mains cable under carpets, rugs, etc.
• Allow the unit to cool before storage.
• Before cleaning, disconnect the appliance from the mains supply and allow to cool.
• Never place the appliance near to flammable material or high pressure containers. (e.g., Paper, wood, petrol, solvents, spray canisters etc.)
• This appliance is intended for household use only and should not be used for industrial purposes.
• Do not use any accessories or attachments with this appliance other than those supplied or recommended by supplier.
• Do not use this appliance for anything other than its intended use.
• Do not push objects into any openings as damage to the appliance and/or electric shock may occur.
• Ensure appliance is situated in an open area, do not allow it to come in contact with Cupboards, Curtains, wall coverings, clothing or other flammable materials.
• The appliance should not be installed in areas which have a fire-risk, such as garages, stables or wooden sheds; this is applicable also for rooms in which highly inflammable gasses or dust can develop. Danger of fire!!
• Even at the lowest setting level the unit is in use. In order to switch off the frost protector pull out the power plug.
• Unplug after each use. Grasp the plug, not the cord.

NB During the first few minutes of initial use, you may notice a slight odour and a little smoke. This is normal and will quickly disappear, It is the coating applied to the heating elements to prevent any corrosion during transit.

Description of parts

Heat Outlet Rear Mounting Bracket Heat Indicator Lamp Adjustable Thermostat On/Off Switch Air Inlet Feet

Assembling your Mini Convector Heater

Fitting the Feet

Before using this heater, the feet must be fitted to the unit. These are attached to the base of the heater using the four self-tapping screws provided, take care to ensure that they are located correctly in the holes at either end of the base of the appliance:

Technical diagram of a mechanical component with a screwdriver and tool, showing internal structure and alignment (no text or symbols)

Wall Mounting Your Mini Convector

Before wall mounting your Mini Convector, please be aware of the minimum distances from the walls, ceiling and floor as shown below:

Ceiling 0.5m Heater Wall 0.3m 0.3m Wall 0.2m Floor

Once the desired mounting position has been chosen, fasten the mounting bracket to the wall as follows.

WARNING Before drilling the wall, ensure that there are no hidden mains cables or water pipes in the area to be drilled - do not install the appliance directly below an electrical socket.

Important: this heater must either be wall mounted or have the feet fitted as described in this manual – under no circumstances should heater be operated standing directly on the floor or other surface.

1. Remove the bracket from the heater.
2. Draw a horizontal line on the wall in the desired mounting position. Mark two points 150mm apart along the line where the centre of the screw holes will be.

150mm Screw hole centres Horizontal Line

1. Use the wall plugs and fixing screws supplied to fix the bracket to the wall.

2. Use a spirit level to ensure that the mounting bracket is fixed horizontally, adjust the bracket if necessary.

3. Re-attach the heater to the wall bracket.

NB This Mini Convector Heater must not be permanently wired to the mains.

Operating Your Mini Convector Heater

1. Insert the mains plug into the nearest mains socket.
2. Press the On/Off switch at the bottom right hand side to the on position by pressing 'I', the switch will illuminate to show the unit is powered up.
3. Rotate the Thermostat clockwise to increase the room temperature, rotate anticlockwise to decrease the temperature.
4. The heat indicator lamp will go on and off during use to show that the set temperature is being maintained – this is quite normal.

Frost Protection

This heater is fitted with an Anti-Frost device, this operates the heater automatically when the room temperature drops below 10^ C. Note: The Anti-frost function operates when the thermostat is set to the lowest level.

Hint on setting the correct temperature

1. Set the heater to the desired heat setting as above.
2. Rotate the Thermostat to the maximum position and allow the room to warm up. Once the desired room temperature has been reached turn the Thermostat anticlockwise until the heater just clicks off then turn it back up clockwise very slightly. The Thermostat will now maintain the room temperature, if necessary, further increasing or decreasing the thermostat control may be required to 'fine tune' the ideal room temperature.

Care and Use of your Mini Convector Heater

• Always disconnect the heater from the mains power supply before cleaning.
- Clean outside of the heater with a clean damp cloth. Never clean with harsh or abrasive cleaners.
- Do not submerge any part of heater in water or any other liquids.

Technical Data

Electrical Connections

This appliance is fitted with a fused three-pin plug to BS 1363. If the plug has to be removed, it should be cut off and carefully disposed of immediately. To avoid a possible shock hazard, do not insert the discarded plug into a mains socket.

Fitting a new plug

The mains lead must be connected as shown below. The wires are coloured with the following code - Brown wire = Live (L), Blue wire = Neutral (N), Green & Yellow = Earth (E).

Connect Green & Yellow to Earth (E)

Connect Blue to Neutral (N)

E L N 13A Ensu lead

Connect Brown to Live (L)

Ensure the outer sheath of the mains lead is securely held by the cable clamp

• The Blue wire must be connected to the terminal marked N or coloured Black.
• The Brown wire must be connected to the terminal marked L or coloured Red.
• The Green and Yellow wire must be connected to the terminal marked E or coloured Green.
• Check that there are no cut or stray strands of wire inside the plug.
• Use a 13 Amp BS 1362 fuse, only use BSI or ASTA approved fuses.
• If you are in any way unsure which plug or fuse to use, always refer to a qualified electrician.
• After replacing or changing a fuse on a moulded plug, the cover must be refitted to the plug; the appliance must not be used without a fuse cover.

WARNING: Do not wrap the cord around the heater for storage.

GUARANTEE

This product is guaranteed for twelve months from the date of original purchase. If any defect should occur due to faulty materials or workmanship, please return it to the store it was purchased from.

You will need to have your receipt of purchase to hand. The guarantee is subject to the following provisions:

• It is only valid within the boundaries of the country of purchase.
- The product must be correctly installed and operated in accordance with the instructions contained in the User Manual.
• The product must be used solely for domestic purposes.
• The guarantee will be rendered invalid if the product is re-sold or has been damaged by inexpert repair.
• The manufacturer disclaims any liability for incidental or consequential damages.
• The guarantee is in addition to, and does not diminish, your statutory or legal right

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.

CE

Europasonic (UK) Ltd

Manchester M3 1JS

www.europasonic.com