MC-8207 - TV Antenna RetroSound - Free user manual and instructions
Find the device manual for free MC-8207 RetroSound in PDF.
User questions about MC-8207 RetroSound
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your TV Antenna in PDF format for free! Find your manual MC-8207 - RetroSound and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. MC-8207 by RetroSound.
USER MANUAL MC-8207 RetroSound
Parts List (parts will vary depending on product purchased)
text_image
Antenna Cable Antenna Base Antenna Adapter Nut Spacers Antenna Mast Antenna Nut Rubber Gasket Slanted BezelRockerStep #1 Connect Antenna Cable to Antenna Base
Connect the Antenna Cable to the Antenna Base by threading the cable onto the bottom of the Antenna Base.
text_image
Antenna Cable Antenna Base
text_image
Antenna Cable with Antenna Base attachedPlace one of the two Spacers on the Antenna Base by lining up the notches on the Spacer with the Antenna Base.
text_image
Antenna Cable with Antenna Base attached Spacer align notches on Spacer and Antenna BaseStep #3 Add the Rocker
Place the Rocker onto the Spacer with the rounded side down. (this allows the Antenna Base to match the angle of the Slanted Bezel)
text_image
FENDERPlace the antenna assembly through the opening on the fender.
With the antenna assembly placed through the fender, add the Rubber Gasket and then the Slanted Bezel.
text_image
Bezer. FENDER
natural_image
Technical line drawing of a mechanical component with threaded shaft and mounting base (no text or symbols)Step #5 Add the Antenna Nut
Add the Antenna Nut onto the top of the antenna assembly. DO NOT OVERTIGHTEN.
text_image
FENDER
natural_image
Technical line drawing of a mechanical component with no visible text or symbolsStep #6 Assemble the Antenna Mast
Assemble the Antenna Mast by threading the Antenna Adapter into the bottom of the Antenna Mast. The fine threads go into the mast. Then thread the Nut onto the end of the Antenna Adapter. DO NOT OVERTIGHTEN.
flowchart
graph LR
A["Start"] --> B{Checkmark}
B --> C["Next Step"]
Antenna Adapter Antenna Adapter & Antenna Mast
natural_image
Simple line drawing of a mechanical component with an arrow indicating direction (no text or symbols)NutAntenna Mast
natural_image
Pure technical line drawing of a mechanical component with no text or symbolsCompleted Mast Assembly
Step #7 Complete the Installation
Complete the installation by threading the Antenna Mast assembly into the Antenna Base.
text_image
FENDER
natural_image
Technical line drawing of a mechanical component with a cylindrical shaft and dome-shaped base (no text or symbols)Completed Installation
MANUFACTURING
7470 Commercial Way,
Henderson, NV 89011