Wooden C108S - Coffee maker Izzy - Free user manual and instructions

USER MANUAL Wooden C108S Izzy

Black and white photo of a JZZY coffee maker with clear glass lid (no visible text or symbols)

Technical diagram of a portable coffee maker with labeled parts including hopper, kettle, and blender

We thank you for having chosen an appliance from the IZZY range.

Safety Interlocks

Please read these instructions carefully before using the appliance and save them for future reference. Please keep the sales receipt for guarantee purposes (please see below “Guarantee and Customer Service”). IZZY is not responsible for non-compliance of the instructions.

When using electrical appliances, basic safety precautions should always be followed:

• Make sure your electricity supply is the same as the one shown on the underside of the appliance.
  • Always plug your device into an outlet that is earthed. Failure to comply with this requirement may result in electric shock and possible serious injury.
• Never leave the appliance unattended when it is operating.
• Close supervision is necessary when your appliance is being used near children or infirm people. Ensure that they do not play with the appliance.
• This appliance is not intended for use by people with reduced physical, sensory or mental capabilities, children or those with lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

- Switch off and unplug:

• Before filling with water
• Before cleaning
• After each use

- Allow the appliance to cool down completely before putting on or taking off parts and before cleaning and storing the appliance.

- Never use the appliance for any other use than indicated.

- The device is intended for indoor use. Do not use the device outdoors. - The device is intended only for domestic use. Any other use will cancel the warranty.

• Always use the coffee maker on a secure, dry level surface.

- Do not use or place the device or parts in places of high humidity or where it may get wet.

- Watch out for steam, never lift the tank lid during the brewing cycle.

- Never touch the plate or surrounding area.

• Always lift the lid using the tab at the front.

- Do not touch the hot parts.

- Do not let the power cord of the appliance hang over the edge of a table or bench top or touch any hot surface.

- Never leave the power cable wrapped during use. Unwind it completely.

- Never use highly corrosive or abstractive cleaning agents. Never use metal scouring pads for cleaning.

- Never let the power unit, cord or plug get wet.

- If the appliance does get wet, immediately remove the power cord from the wall outlet and do not put your hands in the water. Never run the wet appliance and contact one of the authorized BENRUBI service centers.

- Do not let the cord touch hot parts.

- Never place this appliance on or near a hot gas or electric burner or where it could touch a heated appliance.

• Always make sure there is water in the tank before switching on.

- This coffee maker is only suitable for use with the type of carafe supplied.

- Do not leave the appliance switched on with an empty carafe on the hotplate.

- Never put the carafe in the microwave.

- Do not move the appliance when it is operating.

- Do not touch the appliance with wet or damp hands.

- Do not use an extension power cord.

- Check the power cord periodically for possible damages.

- If the power cord or the plug of the appliance have been damaged, do not use the appliance and contact an authorized BENRUBI Service Center.

- In case of a possible damage, do not attempt to repair the appliance by yourself. Please contact one of the authorized BENRUBI service centers.

- Any repair made by an unauthorized BENRUBI Service Center

CANCELS THE GUARANTEE.

• Any misuse of the device cancels the warranty.
• Only use original spare parts.
  • The appliance conforms to EU directive 2014/30/EU on Electromagnetic Compatibility, the 2014/35/EU Low Voltage Directive, the 2011/65/EU RoHS Directive, the directive 2009/125/EC for eco-design and the EC regulation no. 1935/2004 on materials intended to contact with food.

SAVE THESE INSTRUCTIONS

Parts of the Appliance

Technical diagram of a coffee maker with numbered parts for identification

1. Lid
2. Lid tab
3. Water flow (shower)
4. Water tank
5. Water gradient
6. Power button "On/Off"
7. Glass carafe 1.25lt
8. Hotplate
9. Filter holder
10. Permanent filter

Before the First Use

• Wash the parts of the appliance. See “care and cleaning”.
• Run two full tanks of water (without coffee) through the coffee maker to clean it out. See “Use of the coffee maker”.

Using your Coffee Maker

1. Lift the lid (1) using the tab (2) at the front of the coffee maker.
2. Fill the water tank (4) with the desired amount of water. Do not fill above the MAX level.
3. Use cold water. We recommend using filtered water as it reduces limescale and prolongs the life of your coffee maker. Never use ware or frizzy water.

4. Ensure the filter holder (9) is positioned correctly.

5. Fit either the permanent filter (10) supplied or a paper filter into the filter holder (9).

6. Add the coffee using the spoon supplied (approximately 1 tablespoon (7gr.) per cup depending on your taste).

7. Close the lid (1) and put the glass carafe (7) on the hotplate.

8. Plug in.

9. Turn on the coffee maker by pressing the power button ON/OFF (6). The power indicator light will turn on.

Note: You can take out the carafe, pour and serve at any time. The coffee maker will stop dripping automatically for 30 seconds.

1. Remove the carafe from the heating plate at least one minute after the preparation of coffee is completed. When the carafe is empty, turn off and unplug the appliance.

Notes:

The amount of brewed coffee after the brewing process will always be slightly less than the amount of water placed into the coffee maker, since some water is absorbed by the coffee ground evaporates. Add a little extra water at the beginning so that you end up with the exact number of cups desired.

If you have not used the appliance for a while, run one full tank of water (without coffee) through to clean it out.

The coffee maker will turn off automatically, after 40 minutes of the completion of brewing.

Tips for Great-Tasting Coffee

• A clean coffee maker is essential for making great-tasting coffee. Regularly clean the coffee maker as specified in the “Cleaning and Maintenance” paragraph.
  • Always use fresh, cold water in the coffee maker.
• Fine-cut coffee ensures better filtration, intense aroma and rich flavor. If the coffee is not grounded well enough, slightly put more required amount of coffee per cup to ensure the same taste performance.
• Keep coffee in a cool and dry place. When you open the package of coffee, keep it tightly closed

in the refrigerator so as to maintain its freshness.

• For optimal effect, buy whole coffee beans and grind them just before the filtering process.
• Do not use the same coffee for the second time, as this would destroy its aroma.
• Not recommended reheating coffee. Coffee has the maximum aroma, immediately after preparation.
• Small oil stains on the surface of the filtered coffee are due to the extraction of oil from the coffee beans. The oil may also be due to heavy roast coffee.

Descaling

1. Buy a suitable descaler.
2. Descale the machine following the instructions on the package.
3. After descaling, run at least three full tanks of water (without coffee) through the coffee maker to clean it out.
4. Wash the parts. See "Care and cleaning" section.

Care and Cleaning

• Always switch off, unplug and allow the appliance to cool before cleaning.
- Don't wash parts of the appliance in the dishwasher.
- Clean all removable parts of the device after each use with warm soapy water.
- Clean the outer parts of the device with a soft, damp cloth.

CAUTION: Do not immerse the coffee maker in water or any other liquid.

• Do not clean the inside of the water tank with a cloth while as possible remnants of the fabric fibers may clog the coffee maker.
• For stubborn stains, use a synthetic sponge with a light detergent. Do not use wire and abrasive cleaners.
• Water droplets may be created in the region over the filter holder and drip onto the base of the product during operation. Wipe the area with a clean, dry cloth after each use of the device.
• Use a damp cloth to gently wipe the heating plate. Never use abrasive detergents for cleaning.

Technical Characteristics

Model: Coffee Maker Wooden C108S

Rated voltage / Frequency: 220-240V\~50-60Hz

Power: 800 W

Max 950 W

Carafe capacity: 1.25 Liters (10-12 cups)

Important Information for Correct Disposal of the Product in Accordance with EC Directive 2002/96/EC

At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources.

As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin.

Guarantee & Customer Service

- BENRUBI Company guarantees its products for any manufacturing defect or defective materials for a period of two (2) years from the date of purchase or delivery by presenting purchase receipt. If your product malfunctions or you find any defects, please revert to the retail location you have purchased it from or contact an authorized BENRUBI Service Centre. To find the nearest authorized BENRUBI Service Centre, visit our website www.benrubi.gr. It is in the discretion of BENRU Company to replace or repair the defective product.

- The warranty does not cover damages resulting from normal wear, breakage, improper installation or maintenance of the product, mishandling, abnormal working conditions, failure to implement the instructions, conversion or repair of the product by an unauthorized technician who does not belong to the BENRUBI Service Centers.

Also, the warranty does not cover the following indicative factors:

• Stains, discoloration or scratches.

• Burns due to exposure to heat or flame.

- Damage from thermal shock (sudden temperature change or change of voltage).

FOR MORE INFORMATION PLEASE CONTACT:

(NEW) H. BENRUBI & FILS SA

27 Aghiou Thoma str, GR15124, Maroussi – Athens, Tel./Customer Support: [phone]

e-mail: [e-mail]