BR-2B65A - Speaker SSV Works - Free user manual and instructions

USER MANUAL BR-2B65A SSV Works

WARRANTY INFORMATION:

All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against defects in material or workmanship. All Kicker Speakers are covered by a limited 1 year warranty against defects in material or workmanship. All Kicker Amplifiers are covered by a limited 2 year warranty against defects in material or workmanship. Labor for replacement of defective components is not covered. Contact SSV Works for further warranty information.

Please read and understand these instructions completely before installation to avoid possible injury, or damage to the accessory or vehicle.

TOOLS NEEDED FOR INSTALLATION

•T25, T30 Torx Driver
•#1 Phillips Screwdriver

PARTS LIST IMAGES

3D rendering of a black octagonal mechanical component with a red internal line, no visible text or symbols

Passenger Rear Door Pod

Exterior view of a black octagonal mechanical component with internal components and a red pin (no text or symbols visible)

Driver Rear Door Pod

Two black metal bracket components with holes, shown side by side (no text or symbols)

Bracket Pack

Close-up of a black screw with a T-shaped head and threaded shaft (no text or symbols visible)

(x2) M6 x Screw

Simple black ring shape inside a square frame (no text or symbols)

(x2) M6 Washer

Close-up of a black screw with a flat head and threaded shaft (no text or symbols visible)

(x2) #1 Phillips Screw

DISASSEMBLY

Close-up of a car's side panel showing the wheel and seat, with a red arrow pointing to the wheel (no text or symbols visible)

A. Remove the screw located at the bottom of the speaker enclosure.

Close-up of a car seat with three purple circular annotations highlighting specific components (no text or symbols present)

B. Removing the two screws securing the bracket to the vehicle. Then remove the two screws securing the bracket to the enclosure.
Note: These 4 factory screws will be re-used for the SSV pods. *This image is of passenger side.

INSTALLATION

Hand holding a small black object with two purple circles on top, placed on a wooden surface (no text or symbols visible)

A. Secure the drivers side bracket to the driver side pod using the factory two screws.

Close-up of a hand inserting a small component into a car's seat panel (no visible text or symbols)

B. Hold the pod up near its mounting location and connect the factory harness.

Close-up of a car's wheel assembly with a black plastic component and a finger adjusting it (no visible text or symbols)

C. Snap the speaker pod harness cover onto the pod making sure the harness exits the cover through one of the two reliefs.

Close-up of a car interior showing a mechanical component with a screwdriver inserted, no visible text or symbols

D. Use the provided Philips screw to secure the cover in place. E. Loosely assemble the bottom of the pod to the frame of the vehicle using the provided M6 screw and washer.

INSTALLATION

Close-up of a car's seatbelt component with a red circular mark and label 'E' (no readable text or symbols)

E. Loosely assemble the bottom of the pod to the frame of the vehicle using the provided M6 screw and washer.

Close-up of a car's engine compartment with two circular annotations highlighting specific parts (no readable text or symbols)

F. Install the two-factory bolts securing the pod to the vehicle.
Note: Image is of passenger side.

Close-up of a hand inserting a metal tool into a car door panel (no visible text or symbols)

G. Fully tighten the bottom screw located at the bottom of the pod.

Repeat all steps for the opposite side.