EG - Synthesizer 2hp - Free user manual and instructions
Find the device manual for free EG 2hp in PDF.
User questions about EG 2hp
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Synthesizer in PDF format for free! Find your manual EG - 2hp and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. EG by 2hp.
USER MANUAL EG 2hp
EG is a full featured two-stage envelope generator. In addition to a colossal range from 3ms to 11 minutes per stage, EG features the ability to switch between linear and exponential curves on the fly, a built-in attenuator, and CV over attack and decay. Boasting more features than modules five times its size, EG can fill any envelope-sized gap in your system.
• Full featured two stage envelope generator
- Wide range from 3ms to 11 minutes per stage
• CV over attack and decay
• Linear and exponential shapes
- Attenuator on output
Table of Contents
Installation/Specifications 4
EG 5
General Functions Overview 6
Installation
To install, locate 2 HP of space in your Eurorack case and confirm the positive 12 volts and negative 12 volts sides of the power distribution lines. Plug the connector into the power distribution board of your case, keeping in mind that the red band corresponds to negative 12 volts. In most systems, the negative 12 volt supply line is at the bottom. The power cable should be connected to the EG with the red band facing the front of the module.
Specifications
Format: 2 HP Eurorack module
Depth: 47mm (Skiff Friendly)
text_image
EG 1 2 3 4 5 6 7 8 9 TRIG ATTACK DECAY LINEAR EXPO AMP OUT 2hp1. TRIG:
Trigger input
An envelope will emit from OUT when a trigger or gate signal is received by the TRIG input
Threshold: 2.5V
2. ATTACK CV:
Control voltage input for ATTACK
Range: 0V - 5V
3. ATTACK:
Sets the attack time of the envelope
If the knob is far left, the attack time will be as fast as possible If the knob is far right, the attack time will be as slow as possible
4. DECAY CV:
Control voltage input for DECAY
Range: 0V - 5V
5. DECAY:
Sets the decay time of the envelope
If the knob is far left, the decay time will be as fast as possible If the knob is far right, the decay time will be as slow as possible
6. RESPONSE TOGGLE:
Toggle that will switch between two response curves
If the toggle is up, the response curve will bet set to linear If the toggle is down, the response curve will be set to exponential
7. AMP:
Amplitude control for the envelope emitted from OUT
If the knob is far left, the envelope will be fully attenuated (0V)
If the knob is far right, the envelope will be full scale (10V)
8. ENVELOPE LED:
LED indication of the envelope emitted from OUT
9. OUT:
Envelope output
Each stage of the envelope can range in length from 3ms to 11 min
Range: 0V - 10V