ES-RL40 - Electric razor PANASONIC - Free user manual and instructions

Product type	Electric razor
Brand	Panasonic
Model	ES-RL40
Dimensions (approx.)	15.2 cm x 5.1 cm x 3.8 cm
Weight	160 g
Power supply	Rechargeable battery (Ni-MH), 100-240 V AC
Charging time	8 hours
Usage time (approx.)	30 minutes
Blade type	Stainless steel, hypoallergenic
Cutting system	Pivot action with linear motor
Wet/dry use	Yes, with washable blades
Cleaning method	Rinse under running water
Replacement blade model	Panasonic WES9013P
Replacement foil	Panasonic WES9087
Safety features	Automatic voltage adjustment, safety lock for travel
LED indicator	Charging status
Country of origin	Japan

Frequently Asked Questions - ES-RL40 PANASONIC

How do I clean my Panasonic ES-RL40 razor?

Remove the foil and cassette, rinse them under running water. Do not use soap or detergents. Dry thoroughly before reassembling.

How long does the battery last on a full charge?

A full charge provides approximately 30 minutes of cordless shaving, enough for about 10 shaves.

Can I use the razor while charging?

No, the ES-RL40 cannot be used while plugged in. Always fully charge before use.

How often should I replace the blades and foil?

It is recommended to replace the foil every 12 months and the blade cassette every 18 months for optimal performance.

Is the razor suitable for wet shaving with gel?

Yes, the razor is waterproof and can be used with shaving gel or foam. Rinse thoroughly after wet use.

What voltage does the charger support?

The charger supports 100-240 V AC automatically, making it suitable for travel worldwide.

How do I know when the battery is low?

The LED indicator will blink slowly when battery is low, and will turn off when charging is complete.

Can I use the razor without the foil?

No, never operate the razor without the foil. It protects the skin and ensures proper cutting.

What is the best way to store the razor?

Store in a dry place with the protective cap on. Avoid prolonged exposure to direct sunlight or high humidity.

Where can I buy replacement parts?

Replacement foils and blades (models WES9087 and WES9013P) are available from authorized Panasonic dealers or online.

USER MANUAL ES-RL40 PANASONIC

Operating Instructions

( 家用 电动剃须刀

(Household) AC/Rechargeable Shaver

型号

Model No. ES-RL40

中文 2

English 7

Exterior view of a modern electric shaver with black and silver casing (no visible text or symbols)

Before operating this unit, please read these instructions completely and save them for future use.

重要事项

卍次

▶ 使用剃须刀

注意

Illustration of a hand holding an object with arrows indicating motion or force (no text or symbols)

清洁

清洁剃须刀

Illustration of a hand holding a spray can with a magnified view showing the spray effect (no text or symbols)

Technical diagram of a mechanical assembly with numbered components for identification

环境保护与资源回收

此剃须刀含二枚镍氢电池。

The outer foil is very thin and can be damaged if not used correctly. Check that the foil is not damaged before using the shaver. Do not use the shaver if the foil etc. is damaged as you will cut your skin.

▶ Charging the shaver

• Do not use any power cord or AC adaptor other than this adaptor (RE7-58).
• Plug in the adaptor into a household outlet where there is no moisture and handle it with dry hands.
  • The shaver may become warm during use and charging. However, this is not a malfunction.
• Do not charge the shaver where it will be exposed to direct sunlight or other heat sources.
• Hold the adaptor when disconnecting it from the household outlet. If you tug on the power cord, you may damage it.
• The supply cord cannot be replaced. If the cord is damaged, the appliance should be scrapped.
• Adequate ambient temperature for charging is 0-35 °C.

▶ Cleaning the shaver

Warning

Disconnect the power cord from the shaver before cleaning it in water to prevent electric shock.

• Keep both the inner blades inserted. If only one of the inner blades is inserted, the shaver may be damaged.
• If you clean the shaver with water, do not use salt water or hot water. Do not soak the shaver in water for a long period of time. Wipe it with a cloth dampened with soapy water. Do not use thinner, benzine or alcohol.

▶ Storing the shaver

• Disconnect the power cord when storing the shaver. Do not bend the power cord or wrap it around the shaver.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
• Please properly store or dispose the plastic bag of the appliance to avoid any accidents, such as infants suffocation, etc. Keep the plastic bag away from infants.
• Keep these operating instructions in a safe place.

Parts identification

A

E

A Protective cap

B Outer foil section

① System outer foil

② System outer foil release buttons

③ Foil frame

© Inner blades

D Main body

④ Foil frame release buttons

⑤ 0/1 switch

⑥ Switch lock button

⑦ Charge indicator lamp

⑧ Trimmer

⑨ Trimmer handle

E Adaptor (RE7-58)

⑩ Power cord

⑪ Appliance plug

F Travel pouch

G Cleaning brush

Charge

Charging the shaver

Perform the following steps to charge the shaver if it seems to lose the speed.

You can fully charge the shaver in 1 hour.

- A full charge will supply enough power for approx. 14 shaves of 3 minutes each.

1 Insert the appliance plug into the shaver.

2 Plug in the adaptor into a household outlet.

- When charging the shaver for the first time or when it has not been in use for more than 6 months, please charge it for 8 hours (in order to activate the rechargeable battery). If you charge the shaver with the batteries completely discharged, the charge indicator lamp may not glow immediately. However, the lamp will glow normally after charging for a few minutes.

Cord shaving

If you insert the appliance plug to the shaver and plug in the adaptor into a household outlet, you can use it even if the battery capacity is low.

- If the shaver does not work, continue charging it for approx. 1 minute.

About the lamp

While charging

Glows red.

After charging is completed

Blinks once every second.

Shave

Using the shaver

1 Depress the switch lock button and slide the 0/1 switch upwards.

2 Hold the shaver as illustrated above and shave.

Start out shaving by applying gentle pressure to your face. Stretch your skin with your free hand and move the shaver back and forth in the direction of your beard. You may gently increase the amount of pressure as your skin becomes accustomed to this shaver. Applying excessive pressure does not provide a closer shave.

Using the trimmer

Slide the trimmer handle up. Place at a right angle to your skin and move downwards to trim your sideburns.

Illustration of a hand holding an object with motion arrows indicating movement (no text or symbols)

Caution

Do not use the trimmer without a foil frame and a system outer foil attached. Doing so may result in injury.

Clean

Cleaning the shaver

1. Disconnect the power cord from the shaver.
2. Apply some hand soap and some water to the outer foil.
3. Turn the shaver on.
4. Turn the shaver off after 10-20 seconds.
5. Remove the outer foil section and turn the shaver on.
6. Clean the shaver and the outer foil section with running water.
7. Wipe off any drops of water with a dry cloth.

5

Illustration of a hand holding a flashlight and a close-up of its base, showing no text or symbols.

1. Dry the outer foil section and the shaver completely.
2. Attach the outer foil section to the shaver.

The mark on the left means suitable for cleaning under an open water tap.

Warning

Disconnect the power cord from the shaver before cleaning it in water to prevent electric shock.

Replacing the system outer foil and the inner blades

system outer foil	once every year
inner blade once	every two years

▶ Replacing the system outer foil

1. Press the system outer foil release buttons and lift the system outer foil upwards as illustrated.
2. Insert the system outer foil by pushing it downwards until it clicks.

▶ Replacing the inner blades

1. Press the foil frame release buttons and lift the outer foil section upwards as illustrated.
2. Remove the inner blades one at a time as illustrated.

- Do not touch the edges (metal parts) of the inner blades to prevent injury to your hand.

1. Insert the inner blades one at a time until they click as illustrated.

1 2 3

Cleaning with the brush

Clean the inner blades using the short brush by moving it in direction (A).

Clean the system outer foil, the shaver body and the trimmer using the long brush.

• Do not move the short brush in direction (B) as it will damage the inner blades and affect their sharpness.
• Do not use the short brush to clean the outer foils.

Removing the built-in rechargeable batteries

Remove the built-in rechargeable batteries before disposing of the shaver. Please make sure that the batteries are disposed of at an officially designated location if there is one. Do not dismantle or replace the batteries so that you can use the shaver again. This could cause fire or an electric shock. Replace them at an authorized service center.

• Disconnect the power cord from the shaver when removing the batteries.
• Perform steps ① to ⑦ and lift the batteries, and then remove them.

Technical diagram of a mechanical device with numbered components for identification

For environmental protection and recycling of materials

This shaver contains Nickel-Metal Hydride batteries. Please make sure that the batteries are disposed of at an officially assigned location, if there is one in your country.

SPECIFICATIONS

Product name AC/Rechargeable Shaver
Product model ES-RL40
Rated input	100-240V~ 110mA50-60Hz
Rated output	3.6V--- 0.8A
Motor voltage	2.4V---
Charging time Approx.	1 hour
Place of origin China
Date of production	See engraving on the commodity.
Execution standard	Chinese standardGB4706.1 appendix BGB4706.9
	Company standardQ/ SXDGWB 6

Specifications are subject to change without notice. This product is intended for household use only.

English

Panasonic

保修证

保修条款

(Address): Wanbao Base, Shiguang Road,

Panyu District, Guangzhou

电话 (Tel): [phone]

传真 (Fax): [phone]

邮政编码(Post Code):511495

原产地：中国

中国印刷

Printed in China

ES0000000000 X0010-0

发行：2010年0月

⑤ CH, EN