How do I reactivate my Tiiwee X1 alarm system after changing the batteries?

Question

Accepted Answer

The Tiiwee X1 alarm system is equipped with a built-in non-replaceable lithium battery. Therefore, user battery replacement is not normally intended and may lead to operational difficulties. Here are the steps to follow to try to reactivate your alarm after a battery intervention:

1. Turn on the X1 siren

Press the On/Off button located on the X1 siren for about 5 seconds. You should hear a short beep and see the LEDs light up successively. If this does not happen, the device has not been reactivated.

2. Check the protection strip

If you have opened the device, make sure that the battery protection strip, usually located at the back in the panel, has been properly removed. Removing this strip normally triggers a beep and the automatic powering on of the device.

3. Reset the system

Once the device is on, you can activate it using the remote control by pressing the Activation button. A confirmation beep should indicate that the system is ready.

⚠️ Important

The internal battery is not designed to be replaced by the user. Any incorrect handling may damage the battery or internal connectors, rendering the device unusable.
If your alarm does not reactivate despite these steps, it is possible that the battery was damaged during the change.

In summary, after an unplanned battery change, make sure you have removed the protection strip and properly turned the device back on. Use the remote control to reactivate the system. If the problem persists, the internal battery may be defective.

User manual Tiiwee : user manuals and guides in PDF

Models Tiiwee most viewed

Browse manuals Tiiwee by appliance type

Recent questions about devices Tiiwee