Question 1

Where is the circuit breaker on the SDMO VARIO 2000I generator?

Accepted Answer

The circuit breaker of the SDMO VARIO 2000I generator is an essential component for electrical protection, particularly against overloads and short circuits. Here are the key details regarding its location and operation:

Location of the circuit breaker

The circuit breaker is generally located on the control panel of the generator, near the electrical outlets.
On the VARIO 2000I, it may be integrated in the form of a thermal or magnetothermal switch, often identifiable near the main controls.

Operation and indications

In case of overload or short circuit, the circuit breaker automatically trips to cut off the electrical supply.
An overload indicator may light up to indicate this tripping, which stops the generator.
To restore operation, you must first eliminate the cause of the overload, then reset the circuit breaker by switching it back to the ON position.

Practical tips

Before handling the circuit breaker, ensure that the generator is turned off and that electrical loads are disconnected.
The circuit breaker protects your generator and devices, so it is important not to bypass it or force its operation.

In summary, the circuit breaker of the SDMO VARIO 2000I is located on the control panel, near the outlets, in the form of a magnetothermal or thermal protection switch. It ensures electrical safety by cutting off the current in case of a problem.

Question 2

What do the red light on and green light flashing mean on the SDMO VARIO 2000I generator, with an engine running at full speed?

Accepted Answer

When the red light is on and the green light is flashing on your SDMO VARIO 2000I generator, accompanied by an engine running at full speed, it generally indicates a problem requiring immediate attention. Here are the most common causes and actions to take:

1. Check the oil level

An insufficient oil level can trigger the red light. Check the engine oil level and refill if necessary, following the manufacturer's recommendations.

2. Engine overheating

An engine running at full speed may be overheating. Ensure that the generator is placed in a well-ventilated area, with no obstruction of the air vents or radiator.

3. Electrical overload

An excessive load connected to the generator can cause abnormal operation. Check that the power of the connected devices does not exceed the maximum capacity of the VARIO 2000I.

4. Resetting the generator

Turn off the power, wait a few minutes, then restart the device. This can sometimes resolve temporary errors.

If the problem persists after these checks, it is advisable to consult a qualified professional for a thorough diagnosis and appropriate repair.

Question 3

What is the starting procedure for the SDMO NEO 3000 2600W generator?

Accepted Answer

To properly start your SDMO NEO 3000 2600W generator, first check that the generator is properly grounded using a 10 mm² copper wire connected to a ground stake. Also, ensure that the engine oil level is correct and that the air filter is clean, then place the unit on a flat and stable surface outdoors or in a well-ventilated area.

Before the initial start or after a stop of more than 10 minutes, or if the fuel level has dropped by at least half of the tank, you need to pressurize the fuel tank. To do this, first place the tank vent slider in the START position, then pump the pressure pump (located under the tank) several times. This step is important to ensure a reliable start.

Now, proceed with the starting by following these precise steps: place the tank vent slider in the RUN position, open the fuel tap located at the base of the tank, then set the choke to the

User manual SDMO : user manuals and guides in PDF

Models SDMO most viewed

Browse manuals SDMO by appliance type

Recent questions about devices SDMO