How to activate the water dispenser after replacing the water filter on a GE GFE26GGHBB refrigerator?

Question

Accepted Answer

To activate the water dispenser of your GE GFE26GGHBB refrigerator after replacing the RPWFE water filter, a purging step is essential to eliminate trapped air in the system. Immediately after installing the new filter, press and hold the water dispenser lever for 2 to 3 consecutive minutes. During this time, water will flow into the collection tray. It is normal to observe a change in the color of the water during this initial system purge.

Once the purge is complete, discard the first 6 full glasses of water dispensed. This step removes residual impurities from the filter and the water circuit. After discarding these 6 glasses, the water should be clear and safe for consumption.

If your GE GFE26GGHBB refrigerator has a water filter indicator light, press and hold the Reset Filter button located on the control panel for about 3 seconds to reset the indicator after replacement.

It is very important to avoid using the hot water dispenser until all the air is completely cleared from the system, as trapped air can cause hot water splashes that may result in burns.

If the water dispenser still does not work after following these steps, it means there may still be air in the water line. Continue to press the dispenser lever at 30-second intervals until water flows steadily without interruption. Your dispenser should then operate normally.

User manual GE : user manuals and guides in PDF

Models GE most viewed

Browse manuals GE by appliance type

Recent questions about devices GE