How to activate automatic watering on the NEDIS WIFIWP10GY pump?

Question

Accepted Answer

To activate automatic watering on the NEDIS WIFIWP10GY pump, you need to use the Nedis SmartLife mobile application. Automatic watering is only available through this application and cannot be configured with the physical buttons on the pump.

Step 1: Connect the pump to WiFi

Plug the micro-USB A cable into the micro-USB charging port of the pump.
Plug the other end of the cable into a USB power supply 5.0 VCC; 1.0 A.
Press and hold the WiFi button to activate pairing. The WiFi LED blinks every 1.5 seconds, indicating that the pump is searching for a WiFi network.
Make sure to connect the pump to a 2.4 GHz WiFi network (the pump does not support 5 GHz).

Step 2: Add the pump in the Nedis SmartLife application

Open the Nedis SmartLife application on your smartphone.
Press the + button to add a new device.
Select the type of device corresponding to the watering pump.
Follow the instructions in the application to connect the pump to your WiFi network.
Rename the pump after finding it for easier identification.
After confirmation, you can control the pump with your smartphone.

Step 3: Configure automatic watering

In the application, set the desired watering frequency by selecting a delay between 1 hour and 7 days.
Set the watering duration by selecting a duration between 6 seconds and 30 minutes.
Press Auto Run to start the automatic watering program.

Once automatic watering is confirmed, the working status changes to Auto. The pump starts the countdown to the first watering, displaying the date and time of the next watering in the

User manual NEDIS Pump : user manuals and guides in PDF

Models NEDIS Pump most viewed

Other categories NEDIS

Recent questions about Pump NEDIS