Question 1

How to start the INDESIT EWC 81252 W FR washing machine?

Accepted Answer

To start your INDESIT EWC 81252 W FR washing machine, follow these simple steps:

Load the laundry: Open the washing machine door and place your laundry inside without overloading it.
Add detergent: Open the detergent drawer and pour the recommended amount of detergent into the designated compartment. Also add fabric softener if desired.
Close the door: Make sure the door is securely closed for the machine to operate.
Select a program: Turn the selector to choose the washing cycle suitable for your laundry (cotton, synthetic, delicate, etc.).
Set the options: Adjust the temperature, spin speed, or other options according to your needs.
Start the wash: Press the Start/Pause button to begin the cycle.

The machine will then start its washing cycle. Once completed, it will stop automatically.

Question 2

How do I drain the water from my INDESIT EWC 61252 WFR.M washing machine in case of a power outage?

Accepted Answer

In case of a power outage, your INDESIT EWC 61252 WFR.M washing machine has a drainage hose that allows you to drain the water manually. If the water level exceeds the opening of the door, you must first drain it through this hose before you can access the machine.

Start by unplugging the power cord for safety reasons. Then check that the water level is below the opening of the door. If it is not, unroll the drainage hose over a bucket or basin and let the water flow slowly until the desired level is reached.

To access the drain filter (located at the bottom front of the machine), remove the front panel by first pressing towards the center, then pushing down on each side. Prepare a container to collect the water: unscrew the filter cover by turning it counterclockwise. A small amount of water will naturally escape.

Once the cover is removed, clean the inside of the pre-chamber to remove lint, fibers, and small debris that may have accumulated. After cleaning, screw the cover back on tightly in a clockwise direction to ensure a proper seal, then reassemble the front panel making sure to push the hooks into the slots provided before pushing it against the appliance.

These steps will allow you to completely drain your washing machine without electrical power, preventing any overflow or accumulation of stagnant water that could lead to leaks or unpleasant odors.

Question 3

How to clean the detergent drawer of the INDESIT EWC 81252 W FR washing machine?

Accepted Answer

To clean the detergent drawer of your INDESIT EWC 81252 W FR washing machine, follow these simple steps:

1. Remove the detergent drawer

Pull the drawer completely out. Depending on the model, you may need to press a button or a release tab to remove it fully.

2. Clean the drawer

Rinse the drawer under warm water to remove detergent residues.
Use a soft toothbrush or a cloth to scrub the compartments and remove stubborn deposits.

3. Clean the drawer housing

Inspect and also clean the inside of the drawer housing in the machine, removing any buildup of residues with a damp cloth or a small brush.

4. Dry and replace

Wipe the drawer and the housing thoroughly with a clean, dry cloth, then replace the drawer by sliding it back in until it clicks into place.

5. Perform a cleaning cycle

For optimal maintenance, run an empty wash cycle at high temperature to eliminate any traces of detergent or mold.

Regular cleaning of the detergent drawer helps ensure the proper functioning of your machine and prevents bad odors or blockages.

Question 4

What should I do if my INDESIT EWC 61252 washing machine is flashing orange and won't start?

Accepted Answer

When your INDESIT EWC 61252 washing machine displays an orange flashing light and refuses to start, it generally indicates a malfunction detected by the electronics. This situation can be related to several factors, from the simplest to the more technical. Here is the complete procedure to diagnose and resolve the issue.

First step: reset the system

Unplug the washing machine from the electrical outlet by pulling on the plug (do not pull on the cord).
Wait at least 1 minute for the electronics to reset.
Plug the cord back into the outlet and wait for the ON/OFF light to flash slowly in green to confirm that the machine is powered on.
Load the laundry and try to start a cycle: press ON/OFF.

If the orange flashing persists after this first attempt, proceed to the following checks.

Check the door and power supply

Make sure the door is properly closed and locked. A poor closure prevents the cycle from starting. Close the door firmly until you hear a click.
Check that the electrical outlet is supplying power by testing with another device (lamp, fan, etc.). If the outlet does not work, test another outlet or check your circuit breaker.
Ensure that the ON/OFF button has been pressed: a green light should flash slowly on the ON/OFF button.

Check the water and drainage

Open the water supply tap: check that the tap located upstream of the washing machine (on the wall) is fully open.
Check the inlet and drainage hoses: make sure no hose is bent, crushed, or clogged. The drainage hose should be positioned at a height between 65 and 100 cm from the floor.
Clean the pump filter by removing the front panel of the washing machine to access the pump's pre-chamber. Unscrew the cover and remove any small objects or debris that may have fallen in (coins, buttons, lint).

Check the drum loading

Ensure that you do not exceed the maximum capacity. For the EWC 61252 model with a capacity of 6 kg, do not load beyond that. An overload prevents starting and the balancing system cannot function.
Make sure the drum is completely empty before loading. Some forgotten items can trigger error codes.

If after following all these steps the machine continues to flash orange and does not start, it is likely a technical failure (faulty door sensor, malfunctioning electronic system, or blocked pump). In this case, contact an authorized INDESIT service center providing the model number (EWC 61252 W FR) and the serial number indicated on the nameplate at the back of the washing machine. Never attempt to repair the appliance yourself, as this could void the warranty.

Question 5

How to resolve a problem with the softener drawer drainage on an INDESIT XWA 71452 WFR washing machine?

Accepted Answer

If the softener drawer of your INDESIT XWA 71452 WFR washing machine is not draining properly, several causes may be responsible for this issue. Here’s how to proceed to resolve it:

1. Cleaning the softener drawer

Remove the softener drawer and clean it thoroughly. Residues of product or limescale can block the drainage channels. Use hot water and a soft brush to remove any buildup.

2. Checking the drainage hose

Inspect the small hose or channel that connects the softener drawer to the drum. It may be clogged with residues. Clean it gently to ensure a clear passage.

3. Checking the filling level

Do not overfill the softener drawer. An overflow can prevent the product from draining properly during the wash cycle.

4. Checking the machine filter

If your model is equipped with a filter, check that it is not clogged. A dirty filter can slow down or block the flow of water and softener.

5. Testing the wash cycle

After these checks, start a wash cycle to see if the problem persists. Sometimes, a complete cycle helps to unblock the system.

By following these steps, you should be able to resolve the drainage issue of the softener drawer on your INDESIT XWA 71452 WFR washing machine.

Question 6

What does a continuous beep on the INDESIT XWA 71452 WFR washing machine mean and how can it be resolved?

Accepted Answer

A continuous beep on your INDESIT XWA 71452 WFR washing machine is an alert signal that may indicate several issues. Here are the most common causes and solutions to check:

1. Door Check

Ensure that the washing machine door is properly closed. An incorrect locking or a poorly closed door often causes a continuous beep to signal that the machine cannot start.

2. Water Supply

Check that the water taps are open.
Ensure that the water inlet hoses are not bent, twisted, or blocked.
A lack of water or insufficient pressure can trigger a continuous beep.

3. Drum Overload

Excess laundry in the drum can prevent the washing machine from functioning properly and generate an alert beep. Try reducing the load to see if the beep stops.

4. Technical Issue or Internal Error

If none of the above checks resolve the issue, it may be an internal technical error. In this case:

Unplug the device for a few minutes, then plug it back in to attempt a reset.
If the beep persists, it is advisable to contact a qualified professional for a thorough diagnosis.

These steps often help identify and resolve the cause of the continuous beep on your INDESIT XWA 71452 WFR washing machine.

Question 7

What is the duration of the extra rinse cycle on the INDESIT EWC 81252 W FR washing machine?

Accepted Answer

The extra rinse cycle on the INDESIT EWC 81252 W FR washing machine is designed to add an additional rinse to remove more detergent residues, ideal for sensitive skin or garments requiring thorough rinsing.

The exact duration of this cycle may vary depending on the selected washing program and the load of laundry. Generally, the extra rinse lasts between 10 and 20 minutes.

To know the precise duration while in use, you can check the control panel of your machine, which displays the remaining time for the current cycle. This information helps you better manage your time while washing.

Question 8

Why does my INDESIT EWC 81252 W FR washing machine not switch from rinse to spin?

Accepted Answer

If your INDESIT EWC 81252 W FR washing machine is stuck in the rinse phase without transitioning to spin, several checks need to be performed in this order.

First, check the selected program. Some programs on your machine do not include automatic spinning: you need to intervene manually by pressing the START/PAUSE button for the draining and spinning cycle to start. Refer to the program table to check if your current cycle includes spinning, especially for rinse or bleaching programs that sometimes require manual action.

Next, check the installation of the drain hose. The hose must be connected at a height between 65 and 100 cm from the floor. If it is bent, stretched, or positioned too low (less than 65 cm), water will not drain properly, preventing the transition to spinning. Also, ensure that the end of the hose is not submerged in water (for example, if it is soaking in a drain pipe or a bucket), as this causes a siphoning effect that blocks the transition to spinning.

Inspect the drainage pipe for blockages. A drain hose or drainage pipe blocked by lint, limescale, or debris will prevent water from draining. Clean the hose by disassembling it if necessary, and check the ventilation opening of your wall drain (it should not be blocked).

Balance the laundry load. Your EWC 81252 washing machine has an automatic balancing system: before spinning, it attempts to evenly distribute the laundry. If the load is severely unbalanced (for example, a single heavy garment or tangled laundry), the machine will attempt to rebalance before spinning at a reduced speed. If the imbalance is too excessive, it will prefer to redistribute the laundry rather than spin. Restart the cycle with a better-distributed load, mixing large and small items.

Restart the machine if an error code appears. If the OPTION and START/PAUSE lights are flashing rapidly with an error code (for example, F-01), turn off the device by holding the ON/OFF button for at least 3 seconds, unplug it, wait about 1 minute, then plug it back in and restart the cycle.

If the problem persists after these checks, the drain pump or a water level sensor may be faulty, and the machine will need to be repaired by a certified technician.

Question 9

How to remove the detergent drawer from the INDESIT EWC 81252 W FR washing machine?

Accepted Answer

To remove the detergent drawer from your INDESIT EWC 81252 W FR washing machine, follow these simple steps:

Open the detergent drawer by gently pulling it towards you until it is completely out.
Locate the locking mechanism inside the drawer. This is usually a small lever or clip that holds the drawer in place.
Press this lever or clip while pulling the drawer towards you to unlock it.
Remove the drawer completely by pulling it outwards.

This operation allows for easy cleaning of the detergent drawer and helps prevent clogs or residues. If the drawer seems stuck, make sure you are pressing the unlocking mechanism properly and avoid using excessive force to prevent damaging the drawer.

Question 10

Why is the 'Rinse Plus' indicator light on my INDESIT WIDL 126 washing machine still on and the cycle won't start?

Accepted Answer

When the 'Rinse Plus' indicator light is on your INDESIT WIDL 126 washing machine and the cycle won't start, it may indicate a malfunction related to several possible causes. Here are the steps to check to try to resolve this issue:

1. Check the door

Make sure that the washing machine door is properly closed and locked. If the door is not securely locked, the machine will not be able to start the cycle.

2. Check the water supply

Check that the water tap is open.
Ensure that the water inlet hose is not kinked or blocked.
Make sure that water is flowing properly into the machine.

3. Clean the drain filter

A clogged drain filter can prevent the cycle from running properly. Clean the filter by following these steps:

Unplug the machine.
Locate the drain filter (usually at the bottom front).
Open the compartment and remove the filter.
Clean it thoroughly under water.
Put it back in place.

4. Reset the machine

Perform a simple reset:

Unplug the machine from the electrical outlet.
Wait about 5 minutes.
Plug the machine back in and try to start a cycle.

5. Check for error codes

Some models display error codes via the indicator lights. Check if your machine displays a specific code associated with the 'Rinse Plus' light to better target the problem.

If after these checks the machine still does not start and the 'Rinse Plus' light remains on, it is possible that there is a technical issue requiring the intervention of a qualified technician, such as a fault in the electronic module, pressure switch, or drain pump.

User manual INDESIT Washing machine : user manuals and guides in PDF

Models INDESIT Washing machine most viewed

Other categories INDESIT

Recent questions about Washing machine INDESIT