How do I operate the TRONIC TLG 300 C2 laminator?

Q: How do I operate the TRONIC TLG 300 C2 laminator?

The TRONIC TLG 300 C2 laminator offers two modes: hot lamination (80 or 125 microns) and cold lamination (up to 200 microns). To start, plug in the device and press the ON/OFF switch. The COLD LED lights up. Then select your mode using the switch: set to 80 MIC for standard pouches, 125 MIC for high-gloss photos, or COLD for lamination without heat. For hot lamination: After selecting your setting (80 or 125 MIC), the device heats up. The corresponding LED blinks during heating and then lights up continuously. We recommend waiting 2 to 3 additional minutes after the indicator light turns on, especially for thin films, to achieve uniform lamination. In the meantime, prepare your document: insert it into a pouch (maximum width 230 mm) with at least 2 mm of space on each side. Lamination procedure: Slowly push the pouch into the front slot, sealed side facing forward , following the format indicators (A4/A5). After a few centimeters, the device will automatically grab it. Release the pouch as soon as it is taken. After it exits, let it cool for at least 1 minute before touching it. To improve the result, you can weigh the hot pouch down with a book or binder to achieve a perfectly smooth surface. For cold lamination: After hot lamination, allow the device to cool completely before switching to COLD mode. The process is the same, but without the risk of burns. Cold pouches can accept a thickness of up to 200 microns. Important points: The device has an anti-jam switch (ABS) if the pouch is inserted at an angle. Each pouch can only be used once. Never insert an open or angled pouch. For best results, only use pouches suitable for your mode (hot or cold) and the selected setting.

Question

Accepted Answer

The TRONIC TLG 300 C2 laminator offers two modes: hot lamination (80 or 125 microns) and cold lamination (up to 200 microns). To start, plug in the device and press the ON/OFF switch. The COLD LED lights up. Then select your mode using the switch: set to 80 MIC for standard pouches, 125 MIC for high-gloss photos, or COLD for lamination without heat.

For hot lamination: After selecting your setting (80 or 125 MIC), the device heats up. The corresponding LED blinks during heating and then lights up continuously. We recommend waiting 2 to 3 additional minutes after the indicator light turns on, especially for thin films, to achieve uniform lamination. In the meantime, prepare your document: insert it into a pouch (maximum width 230 mm) with at least 2 mm of space on each side.

Lamination procedure: Slowly push the pouch into the front slot, sealed side facing forward, following the format indicators (A4/A5). After a few centimeters, the device will automatically grab it. Release the pouch as soon as it is taken. After it exits, let it cool for at least 1 minute before touching it. To improve the result, you can weigh the hot pouch down with a book or binder to achieve a perfectly smooth surface.

For cold lamination: After hot lamination, allow the device to cool completely before switching to COLD mode. The process is the same, but without the risk of burns. Cold pouches can accept a thickness of up to 200 microns.

Important points: The device has an anti-jam switch (ABS) if the pouch is inserted at an angle. Each pouch can only be used once. Never insert an open or angled pouch. For best results, only use pouches suitable for your mode (hot or cold) and the selected setting.

User manual TRONIC Laminator : user manuals and guides in PDF

Models TRONIC Laminator most viewed

Other categories TRONIC

Recent questions about Laminator TRONIC