Question 1

How to turn on and print with my Epson WorkForce WF-2930 printer?

Accepted Answer

Turning on the Epson WorkForce WF-2930

To start using your printer, follow these steps:

Unpack the printer and remove all shipping protection elements.
Plug the power cord into an electrical outlet and press the power button located at the front of the device.
The printer will perform an automatic initialization (about 1 to 2 minutes).
Fill the ink cartridges in the appropriate slots (usually black, cyan, magenta, and yellow for this multifunction model).
Load paper into the feed tray up to the maximum fill mark.

Printing with the Epson WF-2930

Three methods are available:

From a computer: Install the Epson printer drivers (available on the Epson website). Open your document, select 'Print' and choose 'Epson WorkForce WF-2930'.
Direct printing: Some models allow direct printing from a USB stick or memory card via the control panel.
Network printing (Wi-Fi): You can connect the printer to your Wi-Fi network to print without a USB cable (configuration required via the device menu).

The control panel has an LCD screen that will guide you through the initial settings. For more specific details, refer to the complete manual on this page.

Question 2

How do I remove the alert message asking to remove the waste paper box if it is empty?

Accepted Answer

On the Epson SureLab SL-D1000 printer, the waste paper box collects the scraps of paper cut during printing on roll paper. The printer has a detection system to monitor the filling of this box and displays an alert when it is time to empty it. If you receive an alert message while the box is empty or insufficiently filled, it is possible that the sensor is malfunctioning.

Sensor reset procedure:

Make sure the printer's power light is on (and not blinking).
Locate the waste paper box on the right side of the printer.
Remove the waste paper box by pulling it forward until it clicks.
Once the box is removed, the status light blinks: this is normal.
Reinsert the waste paper box completely until you hear a locking click.
Wait a few seconds and check that the status light turns off.

This action resets the filling sensor. If the alert message disappears, the issue was a simple desynchronization of the sensor.

Checking the alert threshold:

If you do not want to be alerted so frequently, you can adjust the alert threshold via the control panel menu. Go to Settings > Paper Settings > Remaining Alert and set the numeric value according to your preferences.

If the problem persists:

The waste paper box sensor may be defective. This can also happen if the sensor remains dirty. In this case, you can try gently cleaning the sensor (box insertion area) with a dry cloth. If the message continues to appear despite removal-reinsertion and after resetting, contact Epson technical support or an authorized dealer for sensor replacement or technical assistance.

Question 3

Where can I find a detailed exploded view of the EPSON SureColor SCS80600L printer?

Accepted Answer

A detailed exploded view of the EPSON SureColor SCS80600L printer allows you to visualize the different parts and components of the device, which is useful for maintenance or repair.

To obtain this exploded view:

Check the technical documents provided by EPSON, often available on their official website in the support or download section.
Look for service manuals or maintenance guides specific to this model, which generally contain exploded diagrams.
If not available online, contact EPSON customer service or an authorized service center to request this information.

These detailed exploded views are not always included in consumer user manuals, but they are essential for technicians and can be provided upon request.

User manual EPSON Printer : user manuals and guides in PDF

Models EPSON Printer most viewed

Other categories EPSON

Recent questions about Printer EPSON