How to resolve the issue of the wireless pointer not working on the Peerless-AV NT653 remote control?

Question

Accepted Answer

If the wireless pointer of your Peerless-AV NT653 Magic Remote is not working while the regular buttons are operational, several steps can resolve this issue.

Step One: Check and Replace the Batteries
First, check the condition of the Magic Remote batteries by replacing them with new ones. Weak batteries affect the operation of the wireless pointer and may prevent the remote from communicating properly with the TV. Ensure that the batteries are correctly installed in the designated compartment.

Step Two: Reset the Remote Control
Remove the batteries from the Magic Remote, then quickly press all the buttons for a few seconds to drain any residual energy. Then reinstall the batteries and test the pointer. This action resets the remote control's memory and may correct minor software malfunctions.

Step Three: Re-register the Magic Remote with the TV
Point the remote control at the TV, press and hold the GUIDE button until the on-screen instruction appears. The TV will cancel and then re-register the Magic Remote. This procedure restores the connection between the remote and the TV receiver.

Step Four: Eliminate Electromagnetic Interference
Wireless devices such as Wi-Fi routers, microwave ovens, cordless phones, or Bluetooth devices can create interference with the Magic Remote. Move these devices away from the TV or relocate the Wi-Fi router away from the TV. Also, ensure that no object is blocking the line of sight between the remote and the infrared sensor located under the Peerless-AV logo at the center of the screen.

Step Five: Restart the TV
Turn off the Peerless-AV NT653, unplug it from the electrical outlet for about 30 seconds, then plug it back in and turn it on. This hardware reset of the device may correct wireless signal reception issues.

Important Information about the Pointer's Operation
Remember that the Magic Remote has an operating range of about 10 meters. Shake the Magic Remote from left to right while pointing it at the TV to make the pointer follow your movement. If the pointer does not appear, shake the remote from left to right to make it reappear. To reset the pointer if it does not respond correctly, move it to the edge of the screen.

If after these steps the wireless pointer still does not work and the regular buttons on the remote function normally, the Magic Remote may be defective or the TV receiver may have an issue. Contact Peerless-AV customer service for further assistance or a remote replacement.

User manual Peerless-AV Television : user manuals and guides in PDF

Models Peerless-AV Television most viewed

Other categories Peerless-AV

Recent questions about Television Peerless-AV