What is the role of the height sensor on the DREAME D10 vacuum robot and how can I ensure its proper functioning?

Question

Accepted Answer

The drop sensor of the DREAME D10 vacuum robot is an essential component located underneath the robot that detects changes in floor level. Its main role is to prevent the robot from falling down stairs, ledges, or any other place where the height varies abruptly. When the sensor detects a void, it sends a signal to the navigation system to stop or reverse the robot, thus ensuring its safety and durability.

To ensure the proper functioning of the sensor, it is crucial to keep it clean and free of dust, debris, or hair. According to the D10 manual, always use a dry cloth (and never a wet one) to clean the sensor, as water may damage the sensitive components inside the robot and the base. Regularly clean the drop sensors, especially after passing over dirty or dusty surfaces.

If you notice that the robot goes over stairs or ledges without detecting them, turn it off immediately and carefully clean the sensors. Before each use, check the cleaning area by removing small obstacles that may obstruct the sensor. As an additional precaution, place physical barriers (doors, gates) at the edges of stairs and ledges to secure the robot during operation.

In case of persistent malfunction, restart the robot by keeping it powered off for a few seconds, then turn it back on. Never use the robot on wet or very uneven surfaces, as this affects the reliability of detection. Keep it on dry, flat indoor surfaces for optimal operation of the safety system.

User manual DREAME Robot vacuum : user manuals and guides in PDF

Models DREAME Robot vacuum most viewed

Other categories DREAME

Recent questions about Robot vacuum DREAME