How to install the Ellermeyer Beline SP Furia car seat in a car?

Question

Accepted Answer

The Ellermeyer Beline SP Furia car seat is installed only with the 3-point seat belt of your vehicle. Before starting, ensure that your car has a 3-point seat belt (fixed or with retractor) approved according to UN/ECE standard No. 16. The installation varies depending on the age group and weight of the child.

Installation for group 1 (children from 9 to 18 kg) with harness: Place the seat firmly against the rear bench of the vehicle and lower the headrest to the maximum. Pull the vehicle seat belt until it is completely slack. Pass both strands (lap and diagonal) through the openings of the cover and the shell, ensuring that the lap strand goes under the armrest of the car seat and that the diagonal strand rises vertically between the backrest and the head support. Pull the belt through the opposite openings and ensure that it goes behind the car seat harness. Check that the diagonal strand goes through the red guide of the backrest.

Fasten the vehicle seat belt, ensuring that it is not twisted. Push the car seat firmly against the vehicle bench and tighten the belt as much as possible by pulling the lap strand and the diagonal strand towards the retractor. Open the harness buckle by pressing the red button and pull the adjustment strap so that the shoulder straps are properly tightened against your child. The space between the harness and the child should not exceed the thickness of a finger.

Installation for groups 2-3 (children from 15 to 36 kg) without harness: First, ensure that the harness is completely removed. Place the seat firmly against the rear bench of the vehicle and seat the child on it. Adjust the adjustable headrest so that the belt guides are positioned as close as possible to the child's shoulders to ensure maximum side protection. The diagonal strand of the belt should pass through the headrest strap guide and under the opposite armrest, while the lap strand goes under the armrests. Fasten the vehicle seat belt, checking that it is properly tightened and not twisted.

Always install this seat on the rear bench of the vehicle, preferably in the center for optimal safety. Before each use, check that the vehicle seat belt is properly fastened and that there are no debris or obstacles in the belt passages. If you have any doubts regarding the installation or correct use of the seat, consult the manufacturer for assistance.

User manual Ellermeyer Car seat : user manuals and guides in PDF

Models Ellermeyer Car seat most viewed

Recent questions about Car seat Ellermeyer