How to solve the problem when the KONIG CSBTTRNSM100 music receiver does not appear on my devices during Bluetooth pairing?

Question

Accepted Answer

The KONIG CSBTTRNSM100 is a Bluetooth audio transmitter, and if it does not appear in the available devices list on your phone or headphones, several checks are necessary before you can pair it.

Start by checking the power supply of the transmitter. Make sure the USB connector of the CSBTTRNSM100 is properly plugged into a USB port of a TV, audio device, or USB power adapter. The device must be powered on to be detected. Also, check that the 3.5 mm audio cable is correctly connected at both ends: one end to the headphone output of your audio source (TV or audio device) and the other to the audio input connector of the CSBTTRNSM100.

To activate pairing mode, press the pairing button on the CSBTTRNSM100 for 1 to 2 seconds. The LED indicator should start blinking every 5 seconds, indicating that the transmitter is actively searching for a Bluetooth device to pair with. It is only in this state (blinking light) that the CSBTTRNSM100 will be visible on your device.

On your phone, tablet, or Bluetooth headphones, enable device search. For pairing the first device, first press the pairing button on your Bluetooth device (refer to its manual), then check in the Bluetooth settings that the CSBTTRNSM100 appears in the list of discovered devices. On the next connection, both devices will automatically recognize each other. To pair a second device, first reset the transmitter by pressing and releasing the pairing button: the light will start blinking again and the transmitter will search for nearby A2DP devices.

Maintain a maximum distance of 10 meters between your Bluetooth device and the CSBTTRNSM100. Also, stay away from sources of interference such as microwaves, Wi-Fi routers, or other Bluetooth devices. If the device remains invisible, turn off the CSBTTRNSM100 by unplugging the USB connector, wait a few seconds, and then plug it back in. Do the same with your phone or headphones by restarting them.

When the connection is established, the LED indicator stays constantly on (no longer blinking). If after these steps the CSBTTRNSM100 still does not appear, there may be a hardware issue or incompatibility with your Bluetooth device. Check that your device supports the A2DP protocol (for music) and that Bluetooth version 3.0 or higher is compatible. As a last resort, contact Nedis customer service to verify the support for your device model.

User manual KONIG Music receiver : user manuals and guides in PDF

Models KONIG Music receiver most viewed

Other categories KONIG

Recent questions about Music receiver KONIG