Q: How to switch the FM 27 M from automatic mode to manual mode?

Automatic mode vs manual mode: The FM 27 M oven has an analog timer that allows for automatic cooking programs (with delayed start and stop). To switch to manual mode Turn the timer knob to the left (counterclockwise) until a specific symbol appears in the display window . The oven then switches to manual operation mode. Use the function selector (B) to choose the cooking mode and the thermostat (C) to set the temperature. To completely deactivate If you want to turn off the oven, return the timer knob to the 0 position . Tip: Manual mode allows you to immediately control the temperature and functions without programming delays.

Question 1

Why does the circuit breaker (RCD) trip when I turn on the Ariston FM 51 R oven?

Accepted Answer

If the circuit breaker trips shortly after turning on your Ariston FM 51 R oven, it generally indicates an electrical problem or an overload at startup. Here are the checks to perform:

Preliminary Checks

Make sure the oven is connected via a residual current device (RCD) that complies with standards. The FM 51 R oven consumes 2100 W at 230V: a dedicated and properly sized electrical circuit is essential.
Check that no other high-power appliances are operating at the same time on the same circuit (for example, an electric heater, a washing machine, etc.). The cumulative consumption may trip the RCD.

Eliminating Common Causes

Residual Moisture: Before the first use, the manual recommends running the empty oven for 30 minutes at maximum thermostat with the door closed, then ventilating the room. This phase may release moisture or protective substances that, when in contact with hot elements, can cause a temporary short circuit.
Check the power cord: Ensure it is not damaged, pinched, or exposed to moisture. The manual specifies that the cord sheath should not exceed 50 °C above ambient temperature.
Clean the interior: Transport residues or dust can create faulty contacts. Clean the oven cavity before the first use.

If the problem persists

A circuit breaker that repeatedly trips suggests an internal electrical leak. Your installer or a licensed electrician should check the electrical insulation of the oven and the compliance of your installation. This type of fault is a hardware failure or an electrical installation problem that cannot be resolved by the user alone.

Question 2

How to replace the bulb of the Ariston Thermo FZ 61.1 IX oven?

Accepted Answer

To replace the bulb of your Ariston Thermo FZ 61.1 IX oven, follow these simple steps:

Unscrew the glass cover of the lamp housing
Unscrew the faulty bulb
Install a replacement bulb of the same type (25 W, E14 base)
Reattach the cover in place

The replacement bulb for this model is a 25 W bulb with an E14 base, available as an Ariston spare part.

Question 3

How to perform a manual reset of the FM 27 M oven?

Accepted Answer

The FM 27 M has two simple reset methods:

Reset by power cut (more effective)

Unplug the oven or turn off its circuit breaker
Wait 30 seconds to 1 minute
Plug it back in
The display of the timer will then blink on 0.00 - this is the sign that the reset has been performed

Reset the time of the electronic timer

Press both buttons on the timer simultaneously for up to 4 seconds to access the time setting
Use the +/- buttons to set the correct time
Confirm and the timer will return to normal

After the reset, your oven will return to its default state and is ready to operate in manual mode.

Question 4

Where is the fuse located in the FM 27 M oven?

Accepted Answer

The manual for the FM 27 M does not specify the location of the internal fuse. This component is generally located behind the control panel and is not accessible without disassembly.

Important for your safety:

Any intervention on internal electrical components must be carried out by a qualified technician, as indicated in the manual
Even with the device unplugged, there is a risk of electric shock (charged capacitors)
Self-intervention voids the 2-year warranty

What you can check safely:

The residual current circuit breaker in your home's electrical panel (accessible and safe)
The power cable for visible damage

For any internal intervention or fuse replacement, contact an authorized repair service or a qualified electrician.

Question 5

The FM 27 M oven does not turn on - what should I do?

Accepted Answer

Before contacting customer service, check these simple points:

Check the power supply

Is the oven properly plugged in? Check that the wall outlet works (test with another device).
Has a circuit breaker tripped? Check your electrical panel.

Consult the control panel

Is the function selection lever (B) in standby position? Turn it to a cooking mode (static heat, baking, pizza, etc.).
The temperature dial (C) must be set above 60°C minimum.
Observe the indicator light (E) - it should briefly light up when turned on. Its absence may indicate an internal electrical problem.

Check the safety system

The door locking system may sometimes prevent startup. Close the door completely.
The internal overheating protection may have triggered. Unplug the oven for 2-3 minutes, then plug it back in.

Check the fuse

The fuse is located behind the control panel of your FM 27 M. Do not attempt this check yourself - the electrical risk is real and internal intervention voids the 2-year warranty.

If nothing works

An internal failure is likely (blown fuse, faulty electronic timer, or thermostat issue). Contact an authorized Ariston technician who can safely access the internal components.

Question 6

How to switch the FM 27 M from automatic mode to manual mode?

Accepted Answer

Automatic mode vs manual mode: The FM 27 M oven has an analog timer that allows for automatic cooking programs (with delayed start and stop).

To switch to manual mode

Turn the timer knob to the left (counterclockwise) until a specific symbol appears in the display window.
The oven then switches to manual operation mode.
Use the function selector (B) to choose the cooking mode and the thermostat (C) to set the temperature.

To completely deactivate

If you want to turn off the oven, return the timer knob to the 0 position.

Tip: Manual mode allows you to immediately control the temperature and functions without programming delays.

Question 7

How can I tell if a 4-pin timer is compatible with my Ariston Thermo FO 52 oven that had a 6-pin timer?

Accepted Answer

For your Ariston Thermo FO 52 oven, compatibility depends less on the number of pins than on the functions they support. A 4-pin timer will only be compatible if it supports the two essential electrical circuits: the power supply and the oven's stop control circuit. On your original 6-pin model, the additional pins were likely used for extra functions (delayed programming, enhanced sound signal, or specific control for convection heat).

Essential checks before replacement:

Consult the wiring diagram provided with the new timer to identify its L (live), N (neutral), and control contacts
Compare the rated voltage (generally 220-240V) and amperage with your appliance
Ensure that the new model can handle a power circuit (the oven's heating element) in addition to the control circuit
Note the exact reference of the old timer (engraved on the casing) and contact Ariston service for a certified part

Practical advice: Even if only two wires seem to be used on your old timer, this does not guarantee that the 4 pins of the replacement model will suffice. The unused pins on the old model may have been safety or regulation pre-wiring. To avoid malfunctions or risks of thermal overload, it is strongly recommended to purchase a timer specifically designed for the FO 52 model from an authorized Ariston dealer or an approved after-sales service.

Question 8

Can the ventilation of the Ariston Thermo FO 52 oven operate if the fuse is blown?

Accepted Answer

If the fuse of the Ariston Thermo FO 52 oven is blown, it means that the main electrical circuit is interrupted. In this case, no electrical component, including the ventilation, will be able to operate.

Here are some important points:

Role of the fuse: It protects the oven from electrical overloads by cutting off the current when necessary.
Ventilation: It depends on the electrical supply provided by the circuit protected by the fuse.
Consequence of a blown fuse: The power is cut off, so the ventilation cannot turn on.

In summary, if the fuse is blown, the ventilation of the oven will not work. It is necessary to replace the fuse to restore the normal operation of the appliance.

Question 9

Why won't my Ariston Thermo FO 52 oven turn on after connecting a timer?

Accepted Answer

The most common issue when an Ariston Thermo FO 52 oven does not turn on after connecting the timer is that the end of cooking timer button (I) is not positioned on the symbol 9. This symbol corresponds to the manual operation mode without programmer. First, check this position: turn the button I until the symbol 9 aligns with the fixed mark on the control panel.

If the oven turns on correctly after this adjustment, the issue is resolved. If the problem persists, check the electrical connections of the timer. Ensure that the three wires are properly connected to the terminals of the connection block: the blue wire (N), the brown wire (L), and the yellow-green wire (earth). The connections should be tight and free of corrosion.

Also, check that the oven's power cable is properly plugged into the wall socket and that the socket is functioning (test with another device if possible). Ensure that the main switch of the electrical circuit has not tripped and that the oven's internal fuse is not blown.

If after positioning the button I on the symbol 9 and checking all electrical connections the oven still does not turn on, the timer may be defective. Try using another compatible timer to confirm. If in doubt or if the problem persists, contact a qualified technician for an accurate diagnosis and safe repair of the appliance.

Question 10

What are the two wires of the Ariston Thermo FO 52 oven timer for?

Accepted Answer

The two wires of the Ariston Thermo FO 52 oven timer ensure the electrical operation of this control device. The first wire is the power supply that provides the necessary energy for the timer mechanism to function. The second wire is the control (or signal) wire that establishes the connection between the timer and the oven's control circuit, allowing the heating elements to be activated or deactivated at the end of the programmed time.

In practice, when you operate the timer button by turning it clockwise, you set the desired duration in minutes. Once the time has elapsed, the timer closes or opens this control circuit (depending on the type of timer), which automatically cuts off the oven's power supply and stops the cooking process. You are then alerted by an audible signal.

These two wires must remain properly connected to the oven's terminal block to ensure reliable operation. In case of timer failure, the oven can still operate manually by positioning the indicator on the “9” symbol of the timer knob, which disables the end-of-cooking programming function.

User manual Ariston Thermo Oven : user manuals and guides in PDF

Models Ariston Thermo Oven most viewed

Other categories Ariston Thermo

Recent questions about Oven Ariston Thermo