How to reactivate the Nelson SmartZone EZ 8582 sprinkler timer after winter?

Question

Accepted Answer

To reactivate your Nelson SmartZone EZ 8582 sprinkler timer after the winter period, start by checking the power supply. Make sure the timer is properly connected to the power source via the included adapter. If your device is equipped with a 9V alkaline battery (strongly recommended to maintain the clock in case of a power outage), check that it is properly in place or replace it with a new one. Use only a 9V alkaline battery; NiCad batteries are prohibited as they can leak or explode. After installing the battery, press the black reset button located on the back of the front panel of the timer.

Inspect the device for any damage caused by cold, moisture, or corrosion during the winter. Clean the contacts if necessary to ensure a good connection. Wait a few seconds after powering on for the backlit LCD screen to turn on and display the main menu. Check that the timer responds to commands by pressing the buttons.

It is essential to set the date and time on the timer, as this information may be lost after a long period of inactivity (especially if no battery was installed). Turn the large dial to the DATE position. Press the ADJUST buttons to scroll to the current date, then set the time in the same way. A correctly set date is crucial for the timer to function properly, especially if you are using interval programming or odd/even scheduling.

Reconfigure your 8 programmable watering zones according to the current needs of your garden for the new season. You can program up to 3 start times per program. Set the watering duration for each zone: it can range from 1 to 240 minutes depending on your needs. Adjust the intervals and watering times based on local weather conditions and the water needs of spring or summer.

Perform a complete manual test of the system by manually watering each zone, starting with zone 1. Check that all watering stations are functioning correctly and that the flow is steady. Monitor the operation of the timer for the first 3 to 5 days to ensure it correctly applies the programs you have configured. Note that your SmartZone EZ has non-volatile memory that has retained all your previous programs even during the winter shutdown, provided that the timer had a power source at some point.

If you encounter a problem when restarting, unplug the power for 30 seconds and then plug it back in, or press the reset button again. Replace your 9V alkaline battery at least once a year, ideally before the watering season, to ensure the clock is maintained in case of a temporary power outage.

User manual Nelson Irrigation timer : user manuals and guides in PDF

Models Nelson Irrigation timer most viewed

Other categories Nelson

Recent questions about Irrigation timer Nelson