HTX-2 - Receiver Wet Sounds - Free user manual and instructions
Find the device manual for free HTX-2 Wet Sounds in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Marine Amplifier |
| Brand | Wet Sounds |
| Model | HTX-2 |
| Channels | 2 |
| RMS Power (4Ω) | 120W x 2 |
| RMS Power (2Ω) | 200W x 2 |
| Amplifier Class | Class-D |
| Frequency Response | 20Hz - 20kHz |
| Input Voltage | 12V DC (10-16V) |
| Dimensions (W x H x D) | 10.5 x 1.5 x 6.0 inches |
| Weight | 5.0 lbs |
| Features | MOSFET power supply, variable high/low-pass filters, bass boost, remote level control |
| Protection | Thermal, short circuit, over-current |
| Mounting | Marine-grade, weather-resistant |
| Warranty | 2 years limited |
| Recommended Fuse | 30A (not included) |
| Certifications | CE, RoHS |
Frequently Asked Questions - HTX-2 Wet Sounds
What is the recommended power and ground wire gauge for the HTX-2?
For runs up to 4 feet, use 8 AWG wire; for longer runs, use 4 AWG to ensure adequate current delivery.
Can I bridge the HTX-2 to a single subwoofer?
Yes, the HTX-2 can be bridged into a single channel at 4Ω, delivering approximately 400W RMS.
What type of input signal does the HTX-2 accept?
It accepts speaker-level or line-level inputs via RCA or high-level input harness.
How do I adjust the crossover settings?
Use the onboard switches to select high-pass, low-pass, or full-range mode, and adjust the crossover frequency from 50Hz to 250Hz using the rotary dial.
Is the HTX-2 weather-resistant for marine use?
Yes, it features a conformal coated circuit board and sealed connections for moisture resistance.
What is the minimum impedance per channel?
The amplifier is stable down to 2Ω per channel stereo, and 4Ω when bridged.
Does the HTX-2 include remote level control?
Yes, a wired remote level controller is included for adjusting volume from the helm.
How can I troubleshoot if the amplifier goes into protect mode?
Check for short circuits, low battery voltage (below 10V), overheating, or improper speaker impedance. Reset by turning off and on.
What is the recommended installation location?
Mount in a dry, ventilated area away from direct water spray, allowing at least 2 inches of clearance for cooling.
Can the HTX-2 be used with a factory head unit?
Yes, it can accept high-level inputs from a factory stereo; use the included harness or optional line output converter.
User questions about HTX-2 Wet Sounds
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Receiver in PDF format for free! Find your manual HTX-2 - Wet Sounds and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. HTX-2 by Wet Sounds.