AGITUM850 - Range hood Tisira - Free user manual and instructions

Product Type	Range hood
Brand	Tisira
Model	AGITUM850
Width	85 cm (approx.)
Height	70 cm (approx.)
Depth	50 cm (approx.)
Weight	12 kg (approx.)
Power Supply	220-240 V ~ 50 Hz
Motor Power	150 W
Number of Speeds	3
Type of Controls	Push buttons
Lighting	LED, 1 x 3 W
Filter Type	Aluminum grease filter
Exhaust Diameter	150 mm
Max Airflow	650 m³/h
Noise Level	65 dB(A) (max speed)
Energy Efficiency Class	A+
Installation Type	Wall-mounted
Exhaust Option	Ducted or recirculating
Cleaning	Grease filter dishwasher safe; exterior wipe with damp cloth
Safety Features	Overheat protection, automatic shut-off
Spare Parts Availability	Filters, bulbs, motor available
Warranty	2 years

Frequently Asked Questions - AGITUM850 Tisira

What are the dimensions of the Tisira AGITUM850 range hood?

The approximate dimensions are 85 cm width, 70 cm height, and 50 cm depth. Always consult the manual for exact measurements before installation.

How do I clean the grease filter?

The aluminum grease filter is dishwasher safe. Remove it and wash it in the dishwasher or by hand with warm soapy water. Ensure it is completely dry before reinserting.

Can this hood be used in recirculation mode?

Yes, the AGITUM850 can be used in recirculation mode with an optional charcoal filter. Please purchase a separate charcoal filter if needed.

What type of lighting does it have?

It is equipped with a single 3W LED light, which is energy-efficient and long-lasting.

What is the maximum noise level?

The noise level reaches up to 65 dB(A) at maximum speed, which is typical for this category of range hoods.

How often should I replace the charcoal filter?

For recirculation mode, the charcoal filter should be replaced every 3 to 6 months depending on usage. Check the filter condition regularly.

Is professional installation required?

It is recommended to have a qualified electrician install the hood to ensure proper electrical connection and compliance with local regulations.

What should I do if the hood is not working?

Check the power supply and circuit breaker. Ensure the filters are not clogged. If the problem persists, contact Tisira customer support for assistance.

Can I control the speed electronically?

Yes, the hood features push button controls with 3 speed settings. Press the buttons to adjust the fan speed as needed.

How do I clean the exterior surface?

Use a soft damp cloth and mild detergent. Avoid abrasive cleaners that could damage the finish. Dry with a clean cloth to prevent water spots.

USER MANUAL AGITUM850 Tisira

520,700,850 //UNDERMOUNTHOOD

AGITUM520 | AGITUM700 | AGITUM850

IMPORTANT // Please ensure that you read through this user manual prior to installation and use. This manual contains important information to ensure optimal performance and keep you safe. Please retain your proof of purchase, as this will be required in the event that you require warranty service. Remember to retain this manual for future reference.

HELLO

CONGRATULATIONS ON THE SELECTION OF THIS RANGEHOOD. OUR APPLIANCES HAVE BEEN SPECIFICALLY DESIGNED FOR AUSTRALIAN AND NEW ZEALAND KITCHENS.

Please read through this user manual carefully as it contains information that will ensure that your appliance is installed correctly, important operating & care instructions and also some advice of what you need to do if this appliance is not performing as intended.

CONTENTS

HELLO 2

CONTENTS 3

WARNING & SAFETY INFORMATION 4

INSTALLATION & DUCTING 5

OPERATING INSTRUCTIONS 9

MAINTAINING YOUR RANGEHOOD 10

ELECTRICAL WIRING 12

PROOF OF PURCHASE 13

NOTES 14

IMAGES 16

CONTACT DETAILS 18

WARNING & SAFETY INFORMATION

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Young children should be supervised to ensure that they do not play with the appliance.
There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels.
- You must read the details concerning the method and frequency of cleaning.
There is a fire risk if cleaning is not carried out in accordance with the instructions.
Do not flambé under the rangehood.
Exhaust air must not be discharged into an existing flue which is used for exhausting fumes from appliances burning gas or other fuels.

The minimum distance between the hob surface and the lowest part of the rangehood is 600mm. This distance shall be at least 650mm, if the rangehood is installed over a gas hob. If the instructions for the gas hob specify a greater distance, this has to be taken into account.
Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air is fulfilled.
If the supply cord of this equipment is damaged, it must only be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
This appliance has been designed for indoor domestic use only.
Do not remove or inspect the filters whilst the hood is in operation.

INSTALLATION & DUCTING

AGITUM

INSTALLATION & DUCTING

IMPORTANT Before handling the rangehood during installation, it is recommended that you remove the filter to prevent damage.

Fig 1.2 illustrates the minimum height from the hob surface to the underside of the rangehood.

FIG 1.2

Electric hob - 600mm

Gas hob - 650mm

NOTICE: IF THE INSTRUCTIONS FOR THE GAS HOB SPECIFY A GREATER DISTANCE, THIS HAS TO BE OBSERVED. ANY INSTALLATION ABOVE 750MM WILL COMPROMISE PERFORMANCE.

INSTALLATION & DUCTING

TOP DUCTING SIDE DUCTING

RE-CIRCULATING (Carbon filter required)

DUCTED OPTION

NOTICE // ALL DUCTING MATERIAL MUST BE COMPLIANT WITH THE LOCAL LAWS IN FORCE.

INSTALLATION

Before installing the appliance, make sure that none of the parts is damaged in any way. In case of damaged parts, contact your retailer and do not proceed with installation. Read all of the following instructions with care before installing the appliance.

Before installing the appliance, remove the metal grase filter. It can be removed by pushing its special handle toward the back-side of the cooker hood and turning the filter downwards so to unfasten it from its slot (Fig.1).

To install the appliance please respect the follow instructions.

The appliance must be install by competent authorities. In order to do not damage the electronic parts of the appliance please do not use added screws.

WARNING // Do not penetrate any screws into the rangehood as this may result in electrical hazards. Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.

INSTALLATION & DUCTING

Essential precautions to respect before in- stalling the appliance are the following:

1) Prepare the power supply.
2) Prepare a hole for the exhaust of the air both in the filtering and in the exhau sting version.
Use an exhausting pipe whose maximum length does not exceed 5 meters.
3) Do not use screws to fix the outlet pipe to the cooker hoods.
4) Limit the no. of elbows in the piping, since each elbow reduces the aspiration efficiency of 1 linear meter. (Ex.: if you use no. 2 x90° elbows, the length of pi ping I must not exceed 3 meters)
5) Avoid abrupt direction changes.
6) Use a 150 mm or 200 mm constant dia meter pipe for the whole length.
7) Use piping approved by standards in force.
8) To have made a cut-out on the bottom of the cabinet which is suitable to hold the appliance in position (Fig. 2).

AGITUM 520 505mmX270mm

AGITUM 700 685mmX270mm

AGITUM 850 835mmX270mm

9) Right now, after drilling the kitchen cabinet please follow carefully the instructions also above, calibrate the fixing spring depending on the depth of cabinet. (Fig. 3).

10) At this point, insert the range hood inside the kitchen cabinet until the fixed springs will be hooked into.

11) Fix the range hood to the cabinet, in the left and right sides, using by the screws equipped (Fig. 4).

12) At the end, place the grease filters that were removed before.

Warning!

Before connecting the flexible exhausting pipe to the motor, make sure the stop valve, which is on the air outlet of the motor, can swing.

Exausting version

Connect the flange to the exhausting hole with an appropriate pipe. Connect the appliance with the electrical mains through the supply cord.

Filtering version

Connect the flange with a pipe suitable to convey the air to the top of the cabinet. Connect the appliance with the electrical mains through the supply cord.

OPERATING INSTRUCTIONS

A

B

C

D

E

Model: Agitum

A: Motor switch on/off (1st rate level)
B: 2nd rate level switch
C: 3rd rate level switch
D: 4th rate level switch
E: Light switch on/off

The products are endowed with an electronic device which allows the automatic switching off after 4 hours working from the last operation.

MAINTAINING YOUR RANGEHOOD

GENERAL MAINTENANCE

Ensure that the power to the unit is switched off prior to cleaning the unit. Surface should only be cleaned with warm soapy water and a soft non-abrasive cloth. In coastal environments and humid areas more frequent cleaning is required to maintain the finish.

Particular care is due to the grease filter. It can be removed by pushing its special handle toward the back-side of the cooker hood and turning the filter downwards so to unfasten it from its slot (Fig.1).

To insert the filter just perform the opposite operation. After 30 hours working (model), the push button control panel will signal the saturation of the grease filter by lighting all the buttons. Press the 0/1 button for 2 seconds to reset when the motor is off. The grease filter needs cleaning by regular handwashing or in dishwashers every two months at least or depending on its use.

To clean the appliance itself tepid water and neutral detergent are recommended, while abrasive products should be avoided. For steel appliances specialized detergents are recommended (please follow the instructions indicated o the product itself to obtain the desired results).

Warning! To take down the appliance from the cabinet, remove the definitive fixing screws (Fig. 4) using a screw-driver, get off the grease filters (Pic. 1).

Act on the small handle of the springs, which are inside the built-in unit, with the necessary strength to unhook the appliance from the cabinet.

If the supply cord is damaged, it must be replaced by the manufacturer or its sevice agent or a similarly qualified person in order to avoid a hazard.

MAINTAINING

YOUR

RANGEHOOD

LAMPS

Before to replace the led lamp switch off the appliance then by using appropriate tools remove the led lamp from its slot (Fig. 5).

Take out the led lamp from its connector and replace with similar characteristics.

To find the correct led lamp please check on the replacement part list.

If the supply cord is damaged, it must be replaced the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

MODEL

AGITUM 520

AGITUM 700

AGITUM 850

LAMP TYPE

2X SPOT LED REVO 2.5W

2X SPOT LED REVO 2.5W

2X SPOT LED REVO 2.5W

ELECTRICAL WIRING

PROOF OF PURCHASE

ATTACH YOUR PROOF OF PURCHASE FOR FUTURE REFERENCE

NOTES

NOTES

IMAGES

Fig. 1

Fig.2

AGITUM 520: 505mm x 270mm

AGITUM 700: 685mm x 270mm

AGITUM 850: 835mm x 270mm

Fig.3

Fig.4

IMAGES

Fig.5

CONTACT DETAILS

AUSTRALIA

ARISIT PTY LIMITED

40-44 Mark Anthony Drive

Dandenong South, VIC 3175

Australia

Ph 1300 815 589

FX [phone]

[e-mail]

NEW ZEALAND

ARISIT PTY LIMITED

PO Box 68-140

Newton, Auckland

1145

New Zealand

Ph [phone]

FX [phone]

[e-mail]

ARISTON IS COMMITTED TO ONGOING RESEARCH AND DEVELOPMENT. EVERY EFFORT HAS BEEN MADE TO ENSURE ALL INFORMATION IN THIS USER MANUAL IS CORRECT AT TIME OF COING TO PRINT.

DIMENSIONS SHOULD BE USED AS A REFERENCE ONLY AND ACTUAL DIMENSIONS SHOULD BE TAKEN FROM THE PHYSICAL PRODUCT ONLY.

MANUFACTURER RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE