TCH90X - Range hood Tisira - Free user manual and instructions

Product Type	Range Hood
Brand	Tisira
Model	TCH90X
Width	90 cm
Depth	50 cm
Height (min-max)	60-120 cm
Weight	18 kg
Power Supply	220-240 V / 50 Hz
Motor Power	200 W
Lighting Power	2 x 20 W (LED)
Number of Fan Speeds	3
Maximum Extraction Rate	750 m³/h
Noise Level (max)	65 dB
Grease Filter Type	Aluminum mesh, washable
Charcoal Filter (optional)	Yes, for recirculation mode
Control Type	Sliding or push button
Duct Diameter	150 mm
Energy Efficiency Class	A+
Installation	Wall-mounted or under cabinet
Warranty	2 years

Frequently Asked Questions - TCH90X Tisira

How do I install the Tisira TCH90X range hood?

Refer to the manual for detailed steps. Typically, secure the hood to the wall above the cooking surface, ensuring a minimum height of 65 cm for gas hobs and 50 cm for electric. Connect the ductwork to the exterior or install a charcoal filter for recirculation.

How often should I clean the grease filters?

Clean the aluminum mesh grease filters every 2-3 months depending on usage. Wash them by hand or in the dishwasher with mild detergent and let them dry completely before reinstalling.

Can I use the hood without a duct?

Yes, you can install a charcoal filter (sold separately) to use the hood in recirculation mode. The air is filtered and returned to the kitchen.

What type of light bulbs does the TCH90X use?

It uses two LED bulbs (typically 20W each). For replacements, purchase compatible LED bulbs from Tisira or an authorized dealer.

Why is my range hood noisy?

Noise may be due to loose installation, blocked ducts, or dirty filters. Ensure the hood is securely mounted, ducts are clear, and filters are clean. Normal noise level is up to 65 dB on max speed.

How do I replace the charcoal filter?

Remove the grease filter first. The charcoal filter is located behind it. Unclip the old filter and insert the new one. Replace every 4-6 months depending on usage.

What is the recommended installation height?

For gas cooktops, minimum 65 cm; for electric/induction, minimum 50 cm. Check local codes and the manual for exact specifications.

Does the hood have a remote control?

The TCH90X typically features manual controls (sliding or buttons) on the front panel. It does not include a remote control unless specified in the model variant.

How do I clean the exterior?

Use a soft cloth with mild soapy water. Avoid abrasive cleaners or scouring pads. For stainless steel, wipe in the direction of the grain to prevent scratches.

What should I do if the hood stops working?

Check the power supply and ensure the plug is connected. Verify if the fuse has blown or circuit breaker tripped. If the problem persists, contact Tisira customer service.

USER MANUAL TCH90X Tisira

IMPORTANT // Please ensure that you read through this user manual prior to installation and use. This manual contains important information to ensure optimal performance and keep you safe. Please retain your proof of purchase, as this will be required in the event that you require warranty service. Remember to retain this manual for future reference.

tisira

www.tisira.com

HELLO

CONGRATULATIONS ON THE SELECTION OF THIS TISIRA APPLIANCE. TISIRA APPLIANCES HAVE BEEN SPECIFICALLY DESIGNED FOR AUSTRALIAN AND NEW ZEALAND KITCHENS.

Please read through this user manual carefully as it contains information that will ensure that your appliance is installed correctly, important operating & care instructions and also some advice of what you need to do if this appliance is not performing as intended.

CONTENTS

HELLO	2
CONTENTS	3
WARNING & SAFETY INFORMATION	4
USING YOUR RANGEHOOD	5
MAINTAINING YOUR RANGEHOOD	6
ELECTRICAL CONNECTION	7
INSTALLATION	8
NOTES	9
PROOF OF PURCHASE	10
WARRANTY TERMS & CONDITIONS	11
CONTACT DETAILS	12

WARNING & SAFETY INFORMATION

This appliance is intended for indoor domestic use only. It is not suitable for outdoor kitchens.

This appliance complies with all of the relevant local and national standards. Inappropriate use can lead to personal injury and cause damage to property.

To avoid risk of injury or damage please read these instructions carefully before installing and operating this appliance.

It is important to keep these instructions in a safe place for future reference and to ensure that all users are familiar with the operations and safety precautions with this appliance.

This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or a lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Young children should be supervised to ensure that they do not play with the appliance.

Please be aware on the cooker hood the halogen lamps may get very hot during use and the may retain their heat for some time after the unit is switched off.

There should be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels.

IMPORTANT // Read the information provided about cleaning of your appliance, methods and frequency.

There is a fire risk if the cleaning procedures are not adhered to.

Do not flambé under the rangehood.

Exhaust air must not be discharged into an existing flue which is used for exhausting fumes from the appliance burning gas or other fuels.

The minimum distance between the hob surface and the lowest part of the rangehood is 600mm. This distance shall be at least 650mm, if the rangehood is installed over a gas hob. If the instructions for the hob specify a greater distance this must taken into account.

Due attention should be given to ensure that any applicable regulations concerning the discharge of the exhaust are adhered to.

If the supply cord of this appliance is damaged, it must only be replaced by the manufacturer or it's service agent or a similarly qualified person in order to avoid a hazard.

USING YOUR RANGEHOOD

TCH60-90X

1. ON/OFF

2. SPEED 2

3. LIGHT

4. SPEED 1

5. SPEED 3

TO TURN THE FAN ON

Press the required speed button once, the fan will turn on and run at the required speed. The selected button will remain depressed to indicate that it has been selected.

TO TURN THE FAN OFF

Press the first button, the fan will then stop.

TO USE THE LIGHT

The light can be used by pressing the button above light symbol once. The light is switched off by pressing the same button again.

RANGEHOOD SPECIFICATIONS

Voltage	220 - 240V~
Frequency	50Hz
Rated motor input power	100W
Rated input power	156W
Illumination	2 x 28W
Plug rating	10A

MAINTAINING YOUR RANGEHOOD

IMPORTANT // Switch off and unplug the rangehood at the powerpoint before undertaking any cleaning or maintenance on the unit.

LIGHT BULB REPLACEMENT

Switch off the power to the canopy hood and allow the bulb to cool.

Use a small bladed screwdriver to prise off the light cover, taking care not to damage the surrounding material.

Use a cloth to remove the bulb.

Replace with a new bulb using a cloth. Do not touch the bulb with fingers.

Snap the cover back in place.

GENERAL MAINTENANCE

To prevent any surface damage never use any abrasive products or products that contain soda, acids, chlorides or solvents.

To clean the surface of the appliance use a mild detergent in warm water, with a soft non-abrasive cloth.

Only use a damp cloth as use of excessive water can penetrate the unit and cause damage.

Dry surface thoroughly after cleaning with a soft cloth to prevent marking of the surfaces.

FILTER MAINTENANCE

To ensure that the rangehood performs at its best, filters need to be cleaned cleaned at least monthly or more frequently with heavy use

The filters can be cleaned using hot soapy water and a soft nylon brush or placed in a dishwasher.

NOTE // Cleaning the filters in the dishwasher may cause permanent discoloration of the surface. This does not in any way affect the performance of the filters.

Charcoal filters cannot be cleaned or reused. Replace filters every 3-6 months dependant on use and cooking style. Please dispose of used filters responsibly.

NOTE // Oversaturated filters are a fire hazard so regular cleaning/replacement is a must.

ELECTRICAL CONNECTION

NOTICE // This appliance must be connected only by a licensed electrician and installed in accordance with the manufacturers instructions.

• Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable.
• Ensure power is not supplied to the appliance until after installation or repair work has been carried out.
• Do not connect the appliance to the mains electricity supply by an extension lead. These do not guarantee the required safety of the appliance.
• The connection data is given on the data plate. This is visible when the grease filters have been removed. Ensure that this data matches the household mains supply.

• Connection of this appliance should be made via a suitable isolator or a double pole fused spur connection unit which complies with national and local safety regulations and the On-Off switch should be easily accessible after the appliance has been built in.

• When switched off there must be an all-pole contact gap of 3 mm in the switch (including switch, fuses and relays according to EN 60335).

• If the switch is not accessible after installation (depending on country), an additional means of disconnection must be provided for all poles.
• For extra safety it is advisable to install a suitable residual current device (RCD). Contact a qualified electrician for advice.

IMPORTANT // This appliance is supplied for connection to a 230V\~50Hz supply.

The wires in the mains lead are coloured in accordance with the following code:

Green/Yellow = Earth

Blue = Neutral

Brown = Live

WARNING // THIS APPLIANCE MUST BE EARTHED

INSTALLATION

HEIGHT OF WALL CANOPY

The chimney is telescopic and is designed for hood installations between 650 to 750 mm above the cooking surface.

Select the desired installation height of the wall canopy.

Installation above 750 mm will compromise the extraction performance.

For optimal efficiency, use smooth-wall, solid galvanized or plastic ducting for reduced noise and increased airflow.

Flexible ducting should only be used as a last resort (ie in difficult installations) and if used, ensure that it is pulled tight.

The smoother, straighter and shorter the ducting the quieter and more efficient the wall canopy will perform.

PREPARING THE WALL CANOPY FOR INSTALLATION

Please read all the instructions carefully before installing the wall canopy.

Remove the filters from the canopy to allow access to wall mounting holes. To remove the filters, pull the relative catch, tilting it downwards until it disengages from the supports. Reverse these instructions when refitting the filters.

Prior to drilling any holes, check that the area behind the surface to be drilled is clear of any electrical cables or pipes etc.

Stainless Steel/Iridium is easily damaged during installation if abraded or knocked by tools.

Whenever possible, protect the top of the cooktop with cardboard or the like to prevent damage on installation.

STANDARD CANOPIES

1. Mounting to a stud is recommended. However if mounting to other wall types different fasteners will be required.

2. Position the canopy mounting bracket (C) in the required position. Mark and drill the pilot holes. Screw the bracket to the wall, ensuring that the bracket is level as this will determine the final level of the rangehood.

3. Carefully position the rangehood body on the bracket.

4. Position the flue cover mounting brackets (A-B) in the required position. Mark and drill the pilot holes. Screw the brackets to the wall.

5. Attach the ducting to the rangehood and duct according to your requirements (external ducting or recirculating).

6. Install the flue covers and secure the top flue cover to the flue bracket with the provided screws.

7. Refit the filters and power the unit.

WARNING // Do not penetrate any screws into the rangehood as this may result in electrical hazards. Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.

PROOF OF PURCHASE

ATTACH YOUR PROOF OF PURCHASE FOR FUTURE REFERENCE

NOTES

NOTES

CONTACT DETAILS

AUSTRALIA

ARISIT PTY LIMITED

40-44 Mark Anthony Drive, Dandenong South, VIC 3175, Australia

P // 1300 762 219

F // 03 9768 0838

[e-mail]

NEW ZEALAND

ARISIT PTY LIMITED

PO Box 68-140

Newton, Auckland 1145,

New Zealand

P // 09 306 1020

F // 09 302 0077

[e-mail]

TISIRA IS COMMITTED TO ONGOING RESEARCH AND DEVELOPMENT. EVERY EFFORT HAS BEEN MADE TO ENSURE ALL INFORMATION IN THIS USER MANUAL IS CORRECT AT TIME OF GOING TO PRINT, DIMENSIONS SHOULD BE USED AS A REFERENCE ONLY AND ACTUAL DIMENSIONS SHOULD BE TAKEN FROM THE PHYSICAL PRODUCT ONLY.

MANUFACTURER RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE.

t tisira

VERSION 3.0

www.tisira.com