CAEN-4X1 - Electronic Equipment Crestron - Free user manual and instructions

Product Type	4x1 HDMI Switcher
Dimensions (W x H x D)	17.3 x 1.7 x 6.5 in (44.0 x 4.3 x 16.5 cm)
Weight	2.5 lb (1.1 kg)
Power Supply	100-240V AC, 50/60 Hz, 0.5A
Inputs	4 x HDMI
Outputs	1 x HDMI
Maximum Resolution	4K@60Hz (4:4:4)
HDCP Support	HDCP 2.2
EDID Management	Built-in EDID emulation
Control Methods	Front panel buttons, IR remote, RS-232
Mounting	1U rackmount (brackets included)
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	10% to 90% (non-condensing)
Power Consumption	15W (max)
Warranty	3 years limited
Cleaning Instructions	Wipe with a soft, dry cloth. Do not use liquids.
Certifications	FCC, CE, UL

Frequently Asked Questions - CAEN-4X1 Crestron

What is the Crestron CAEN-4X1?

The Crestron CAEN-4X1 is a professional 4x1 HDMI switcher that routes four HDMI sources to a single display.

What is the maximum resolution supported?

It supports up to 4K@60Hz (4:4:4) with HDCP 2.2.

How do I control the switcher?

You can control it via front panel buttons, an IR remote, or RS-232 commands.

Does it support audio extraction?

The CAEN-4X1 does not have analog audio outputs; audio is embedded in the HDMI signal.

Can I mount it in a rack?

Yes, it is 1U rackmountable and includes mounting brackets.

What power supply does it require?

It uses a 100-240V AC power supply, 50/60 Hz, with a typical consumption of 15W.

How do I clean the device?

Wipe the housing with a soft, dry cloth. Do not use any liquids or solvents.

Is it compatible with Crestron control systems?

Yes, it integrates seamlessly with Crestron control systems via RS-232 or infrared.

What is HDCP and does this device support it?

HDCP (High-bandwidth Digital Content Protection) is a copy protection standard. The CAEN-4X1 supports HDCP 2.2.

How long is the warranty?

Crestron offers a 3-year limited warranty on this product.

USER MANUAL CAEN-4X1 Crestron

The Creation® CAEN Series of Automation work areas are designed to house Canadian lighting shades control devices. CAEN enclosures are available in an assortment of shades, suitable for surface or fluid-warm installation. Fact model has been designed to provide a clean and manageable installation with abundant provisions for who termination and electrical shockouts.

Additional Resources

Visit the product page on the Croedron website (www.croedron.net) for additional information and the latest firmware updates. Use a CR reader application on your mobile device to expand the CR image.

Dimensions

The overall dimensions for the CAEN enclosures are shown in the following illustration and tabis.

NOTE: The HACC occupies two module spaces in a double-wide enclosure and one module space in a single-wide.

NOTE: Four keyholes are located within the enclosure and should be used for surface mounting.

CALV Church Dimensions, 100 and 500 Views

Dimensions

DIMENSIONS: CAD=TKI CAD=TKI CAD=KAC=KAC=KN=KAC=KN=1
X 62 in	32 in	38-78 in	38-78 in	29-12 in	16-96 in
	(1.075 mm)	(1.375 mm)	(857 mm)	(857 mm)	(456 mm)	(421 mm)
X 32-1/16 in	2-1/16 in	2-1/16 in	2-1/16 in	2-1/16 in	2-1/16 in
	(900 mm)	(900 mm)	(900 mm)	(911 mm)	(911 mm)	(915 mm)
X 40 in	30 in	32-78 in	34 in	18-58 in	10-78 in
	(1.425 mm)	(1.425 mm)	(1325 mm)	(1325 mm)	(425 mm)	(377 mm)
X 135-1/2 in	16-88 in	26-12 in	16-38 in	16-28 in	10-38 in
	(1.325 mm)	(1.325 mm)	(1225 mm)	(1225 mm)	(330 mm)	(330 mm)
X 23-1/2 in	14-88 in	26-12 in	14-38 in	14-28 in	14-14 in
	(1.325 mm)	(1.325 mm)	(1640 mm)	(1325 mm)	(326 mm)	(387 mm)
X 3-1-2 in	1-88 in	2-1/12 in	1-38 in	1-24 in	1-11/16 in
	(1.325 mm)	(1.325 mm)	(940 mm)	(940 mm)	(456 mm)	(456 mm)
X 14-2-1/2 in	10-78 in	20-12 in	10-78 in	10-78 in	10-78 in
	(1.325 mm)	(1.325 mm)	(1275 mm)	(1275 mm)	(376 mm)	(376 mm)
X5	20-12 in	20-78 in	20-78 in	9-78 in	9-78 in
	(2.325 mm)	(2.325 mm)	(1275 mm)	(1275 mm)	(376 mm)	(376 mm)
X 6-2-1/2 in	2-84 in	2-1/12 in	2-84 in	2-84 in	2-84 in
	(900 mm)	(900 mm)	(900 mm)	(900 mm)	(376 mm)	(376 mm)
X 14-3-1/2 in	1-48 in	1-48 in	1-48 in	9-10 in	9-10 in
	(1.325 mm)	(1.325 mm)	(1275 mm)	(1275 mm)	(376 mm)	(376 mm)
Cover Balance	1/16 in	1/16 in	1/16 in	1/16 in	1/16 in
	(1 mm)	(1 mm)	(1 mm)	(1 mm)	(1 mm)
Cover height (in)	10-84 in	10-84 in	10-84 in	10-84 in	10-84 in
	(1.325 mm)	(1.325 mm)	(1208 mm)	(1208 mm)	(425 mm)	(425 mm)
Cover VAC=37 in	16-28 in	27-28 in	16-38 in	16-18 in	10-18 in
	(900 mm)	(900 mm)	(900 mm)	(900 mm)	(456 mm)	(456 mm)
Angle Angle	42 in	55 in	26 in	19 in	1 in
	(2.525 kg)	(2.525 kg)	(2.525 kg)	(2.525 kg)	(1.8 kg)	(1.8 kg)
Maximum Angle (in)	200 in	100 in	100 in	55 in	34 in	26 in
	(400 kg)	34.5 kg	(45.4 kg)	(45.4 kg)	(14.5 kg)	(14.5 kg)

1. The lower keyhole are not symmetrically spaced within single-wide enclosure.
2. Work employ is the weight of an empty enclosure with cover.

Installation

A licensed electron must mount the enclosure in accordance with all rational and basic codes. Refer to the table for the weight of a fully loaded enclosure.
When choosing components to place at the website, refer to the below to ensure that the maximum weight capacity is not exceeded. Each component's product page on the Chevron website lists the component's weight.
Use the screw holes shown in the "Mounting Details" diagrams to mount the CLT series terminal blocks. Install shade control devices and accessories according to their installation guide.
CAUTION: These endor real future equipment, this area to be air-coated. Therefore, mount in a well-ventilated area. The ambient temperature range should be 32°F to 104°F (8°C to 40°C). The relative humidity should range from 10% to 90% (non-condensing). Furthermore, show adequate clearance in front of the vented cover for servicing and ventilation.
NOTE: Unless otherwise indicated, the system sanctioned in this guide is modular, requiring assembly in the field by a licensed electrician. In accordance with all national and local codes.
If a U. Listed panel is required, Crestron offers this service through its U. Listed panel shop. This includes complete in factory system configuration and assembly by Crestron for an additional item.
NOTE: Install components into the lowest available spaces and continue toward the top of the enclosure.
NOTE: Enclosures are intended for indoor use only.
NOTE: (When it is moving, 5/8 in 2 mm drywall is posted.)

Wiring

Class 1 and Class 2 field where must be kept separate. Refer to the following illustrations showing single-wice and double-wice wiring details. Areas for high voltage (Class 1) wiring are shown along the top and side of the unit. The lower area is reserved for low-voltage (Class 2) wiring.

CAUTION: All power leads must be protected by 15- or 20-amp circuit breakers (not included).

NOTE: Low copper concentrations only - rated 60°C

NOTE: install slowing in accordance with all local and national electrical books.

NOTE: Two soap maccings are supplied. It required, meet the bushings to the

knockouts at the bottom of the enclosure to prevent damage to low voltage wiring.

Tighter-SIT-CU-series terminal block screw and grouting terminal black screw to the torque specified in the "Toruma Data" table.

CAUTION: Failure to properly tighten the screws may result in poor electrical connection and overheating of the terminals.

Енг. и Гови

	CLT TERMINAL BLOCKS	GROUNDING TERMINAL BLOCKS
Wes. Boros	22-10	14-10	8	8-4
Torq. 9 (in-8)	8	35	42	40

Below are typical products in a CAEN enclosure:

- CLX-series module

• CLI-series terminal blocks

- CSA-PWB-TRI LOCK-2 and CSA-PWB-TRI LOCK-3 terminal block for shades

• CSA-PAS105-HUB-LNLT power supply for choices

- CAEN-BLOCK terminal block

- PACZM processor

• Grounding terminal block

Morning Dallas - Single-Field C#

graph TD
    A["Mount CL1 to these holes"] --> B["Arrow"]
    C["Mount CLX to these holes"] --> D["Arrow"]

CRESTRON

Wang Lickas Single Web Open

graph TD
    A["Volume CT to Class 2 Hole"] --> B["Class 1"]
    A --> C["Class 2"]
    A --> D["Class 3"]
    E["Mount CLX to Class 4 Hole"] --> B
    E --> C
    E --> D

The product is loaded to app add a 31 ^® Standard and requires to lead by the eleven lens

La Costa Rica Inc. Ca maritati e homine, a vino, no novee et no novees (1) are indiree e incenivities.

Economica Inc.

Federal Communications Commission (FCC) Compliance Statement

The device comps with cost 15 of the F20 (8) sec. Open on an object to the following cost (see [7]. The day on may turn cause terms of interference and (8) this device must accept any other means required, including interference that may cause unexplained acceleration

CAUTION: Changes of materialize not to properly applied by the material new accessible in compliance could void the user's authority to operate the equipment.

NOTE: The assignment has been loaded and found to comp with the links for a class of digital data, present to part 15 of the FOG Rules. These limits are designed to provide reasonable protection against formal interference in a residential installation on. The equipment generates noise, use, and can be made in frequency energy and first installed and used in accordance with the instructions, may cause harmful interference to write communication one. However, there is the guarantee that interference will not exceed a position measured if the work present those causes formal interference to find or reduce any respect, which can be adherent from buying the work present all work on. The user is encouraged to try to connect the interference by using or more of the following measures:

- Horsen of the above finance group employees

- Increased the separation between the arrangement and raised

- Connect the equipment, No and Tel on a road different from that to which he receives

-

• Consult the dealer or an expert outlet met a TV station for help

Industry Canada (IC) Compliance Statement

2411388-3 (3) KMB-SiR

the product warranty can be found at ANA/CHINA CONVENT

The specific patents that cover Creation products are listed at poerta creation site

Berlin Computer products contain open course software. For specific information, please visit

(2) 2017年1月1日

Steuern and the Greaten logo are other trademarks or registered trademarks of Greaten Electronics, Inc. in the United States and/or other countries. U.S. and the U.S. logo are other trademarks or registered

Insideration of Uncrewment Laboratories, Inc. in the United States and other countries. Other trade marks, registers and product marks, and trade marks may be used in this document to refer to other the entities during the marks and names of the products. Greatman also namely proprietary interest in the marks and names of others. Greatman is not responsible for errors in typeography or photoography. This document was written by the Technical Publications department at Greatman.

©2017 Croedron Electronics, Inc.

Creation Electronics, Inc. Installation Guide - DOC 5040F

15 Vass Dwa Rockkajr, NJ 076-7 (2002052)

Tel: 988 CREDITON 06.17 Fax: [phone], Survey