ABT-MFP-20 - Freezer American BioTech Supply - Free user manual and instructions
Find the device manual for free ABT-MFP-20 American BioTech Supply in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Freezer |
| Brand | American BioTech Supply |
| Model | ABT-MFP-20 |
| Capacity | 20 cu ft (566 L) |
| Temperature Range | -20°C to -30°C |
| Temperature Control | Digital microprocessor with LED display |
| Alarm System | High/Low temperature alarm with audible and visual alerts |
| Refrigerant | R-404A |
| Voltage / Frequency | 115V / 60Hz |
| Power Consumption | 850 W |
| Dimensions (W x D x H) | 28 x 30 x 78 inches (71 x 76 x 198 cm) |
| Weight | 250 lbs (113 kg) |
| Shelves | 4 adjustable wire shelves |
| Door Type | Solid door with lock |
| Interior Light | LED interior light |
| Defrost Type | Manual defrost |
| Insulation | High-density polyurethane foam |
| Certifications | UL, CE |
Frequently Asked Questions - ABT-MFP-20 American BioTech Supply
What is the recommended ambient temperature range for operating the ABT-MFP-20 freezer?
The recommended ambient temperature is between 10°C and 30°C (50°F to 86°F). Avoid placing the freezer in direct sunlight or near heat sources.
How do I set the desired temperature on the ABT-MFP-20?
Press the 'SET' button on the control panel, use the arrow keys to adjust the temperature, and press 'SET' again to confirm. The display will show the current set point.
What does the alarm indicator mean?
The alarm indicator flashes when the internal temperature deviates from the set range by more than 5°C (9°F). Check for door left open, power failure, or excessive load.
How often should I defrost the freezer?
Defrost the freezer when ice buildup exceeds 1/4 inch (6 mm). For manual defrost models, turn off the unit, remove all contents, and allow ice to melt naturally. Do not use sharp tools.
Can I use an extension cord with the ABT-MFP-20?
No, do not use an extension cord. Plug the freezer directly into a dedicated grounded outlet. Extension cords can cause voltage drop and overheating.
What is the correct procedure for cleaning the freezer?
Unplug the freezer, remove contents, and clean interior with a mild detergent and warm water. Rinse and dry thoroughly. Do not use abrasive cleaners or solvents.
How do I replace the door lock?
The door lock is a standard key lock. To replace, remove the two screws securing the lock housing, pull out the old lock, and install the new one. Contact technical support for spare parts.
What should I do if the freezer is not cooling?
Check that the power cord is plugged in, the circuit breaker is not tripped, and the temperature setting is correct. Ensure the condenser coil is clean. If the problem persists, call service.
Is the ABT-MFP-20 suitable for storing vaccines?
Yes, the ABT-MFP-20 is designed for laboratory use and maintains stable temperatures suitable for vaccine storage. However, always monitor temperature with a calibrated data logger.
How do I calibrate the temperature display?
Calibration should be performed by a qualified technician. Access the calibration mode by pressing and holding the 'SET' key for 5 seconds, then adjust offset using arrow keys. Refer to the service manual.
User questions about ABT-MFP-20 American BioTech Supply
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Freezer in PDF format for free! Find your manual ABT-MFP-20 - American BioTech Supply and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. ABT-MFP-20 by American BioTech Supply.