PLW 3 A1 - Laser level POWERFIX - Free user manual and instructions

Product Type	Laser Spirit Level
Model	PLW 3 A1
Brand	POWERFIX
Dimensions	15.7 x 2.8 x 5.7 cm
Weight	Approx. 170 g (with batteries)
Power Supply	3 V DC (2 x 1.5 V AAA/Micro batteries)
Laser Class	Class 2
Laser Power	P max: < 1 mW
Laser Wavelength	650 nm
Precision	1 mm/m
Measuring Tape Length	3 m
Functions	Horizontal and vertical alignment, length measurement
Spirit Levels	Two vials (horizontal and vertical)
Laser Output	Cross line (horizontal and vertical)
Safety Features	Laser warning label, automatic retraction of measuring tape
Intended Use	Indoor domestic use only
Battery Type	AAA/Micro, 2 pieces
Cleaning	Soft lint-free cloth, soft brush for laser exit
Storage	Dry, dust-free environment
Warranty	3 years (with proof of purchase)

Frequently Asked Questions - PLW 3 A1 POWERFIX

How do I replace the batteries in the PLW 3 A1?

Loosen the screw on the battery compartment cover with a crosshead screwdriver, remove the cover, insert 2 new AAA/Micro batteries with correct polarity, replace cover and tighten screw.

Is the laser beam safe for eyes?

The laser is Class 2, with P max < 1 mW. Never look directly into the beam or point it at people or animals. Avoid reflective surfaces.

Can I use the laser level outdoors?

No, the device is intended for indoor domestic use only. Exposure to extreme temperatures, humidity, or direct sunlight may damage it.

How do I align the laser horizontally?

Hold the appliance with the narrow side against the wall so that both spirit levels face forward. Switch on the laser (position I), then adjust until the air bubble in the horizontal spirit level (4) is centered. Switch off when done.

What should I do if the measuring tape does not retract smoothly?

Never allow the tape to rewind uncontrolled. Hold the end and guide it back slowly. If it jams, check for debris or damage. For repairs, contact authorized service.

How do I clean the laser exit opening?

Use a soft brush to gently clean the laser exit opening (6). For outer surfaces, use a soft lint-free cloth. Avoid aggressive detergents or abrasives.

What is the precision of the laser level?

The precision is 1 mm/m. This means over a distance of 1 meter, the deviation is maximum 1 mm.

How do I dispose of the device and batteries?

Do not dispose of the device with household waste; follow local regulations for electronic waste. Batteries must be taken to a collection site or retail store. Dispose of packaging in an environmentally responsible manner.

Can the laser level be used for commercial purposes?

No, the product is designed for domestic use only. Commercial use voids the warranty.

What is the warranty period and how to claim?

Warranty is 3 years from purchase date. Keep the receipt. For claims, contact the service department by phone (UK: 0871 5000 700, IE: 1850 930 412). Post-free despatch is assured only after phone contact.

USER MANUAL PLW 3 A1 POWERFIX

Blue measuring tape with a yellow measurement tape, placed on paper with a pink 'LASER' banner in the background (no readable text on tape or paper)

Chaser Spirit Level

Operating

instructions

Laservesivaaka

Käyttöohje

Vattenpass med laser

Bruksanvisning

DK Laser vaterpas

Index

Introduction 2

Information for these operating instructions 2

Copyright....2

Intended use 2

Safety instructions 3

Risk of personal injury and property damage 3

Danger from laser radiation....3

Interaction with batteries 4

Items supplied 4

Appliance description 4

Initial use .... 5

Inserting/exchanging batteries 5

Using the measuring tape 5

Using the Laser Pointer 6

Aligning the laser beam horizontally 6

Aligning the laser beam vertically 6

Cleaning and Care 6

Disposal....7

Disposal of the appliance 7

Disposing of the batteries 7

Appendix 7

Technical data....7

Warranty 8

Service....8

Importer....8

GB IE

Introduction

Information for these operating instructions

These operating instructions are a component of the Laser Spirit Level PLW 3 A1 (hereafter designated as the appliance) and they provide you with important information about the intended use, set up and operation of the appliance.

The operating instructions must be constantly kept available close to the appliance. They are to be read and applied by everyone assigned to operate the appliance. Keep these operating instructions and hand them over with the appliance to any future owners.

Copyright

This documentation is copyright protected.

Any copying or reproduction, including as extracts, as well as the reproduction of images, also in an altered state, is only permitted with the written authorisation of the manufacturer.

Intended use

This Laser Spirit Level is intended for the measurement of lengths and for the horizontal and vertical alignment of objects, e.g. pictures. This appliance is suitable only for indoor use and is intended only for domestic applications. The appliance is not meant for commercial use. No liability will be accepted for damage resulting from incorrect or improper usage, the application of force or unauthorised modifications. Claims of any kind resulting from damage caused by improper use, incompetent

repairs, unauthorized modifications or the use of non-approved spare parts will not be acknowledged.

WARNING

Risks from unintended use!

Risks can arise if the appliance is used for unintended purposes and/or other types of use.

Use the appliance exclusively for its intended purposes.

Observe the procedures described in these operating instructions.

Claims of any kind resulting from damage caused by improper use, incompetent repairs, unauthorized modifications or the use of non-approved spare parts will not be acknowledged.

The operator alone bears liability.

Safety instructions

GB IE

Risk of personal injury and property damage

Before use check the appliance for visible external damage. Do not take into operation an appliance that is damaged or has been dropped.

This appliance is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiencies in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used.

Children should be supervised to ensure that they do not play with the ■ appliance.

Do not expose the appliance to extreme temperatures, severe vibrations, high mechanical loads, direct sunlight or high humidity. If you do, the appliance could be damaged.

Never open the appliance housing. Personal injury and damage to the appliance could be the result.

Repairs should only be carried out by authorized specialist companies or by the Customer Service department.

Do not allow the measuring tape to rewind itself without control.

Danger from laser radiation

WARNING

Risk of injury from laser beams! The laser beam can cause serious eye damage.

This appliance contains a Class 2 laser.

NEVER ▶ look directly into the laser beam.

▶ NEVER direct the laser beam at other people or animals.
▶ NEVER direct the laser beam at surfaces or objects that can reflect light.

Caution: If operating and adjustment facilities or procedures other than those specified here are employed, they may result in hazardous radiation exposure.

▶ ALWAYS switch the laser beam off whenever the appliance is not in use.

GB IE

Interaction with batteries

WARNING

Risks from improper use!

For safe handling of batteries observe the following safety instructions:

Do not throw batteries into a fire.

Never short-circuit batteries.

Do not attempt to recharge batteries.

Regularly check the condition of the batteries. Leaking battery acid can cause permanent damage to the appliance. Special caution should be shown when handling damaged or leaking batteries. Danger from acid burns! Wear protective gloves.

Store batteries in a place inaccessible to children. When swallowed seek immediate medical attention.

Do not use new and depleted batteries together.

If you do not intend to use the appliance for an extended period, remove the batteries.

Items supplied

Laser Spirit Level ●

2 x 1.5 V Batteries Type AAA/Micro

This operating manual ●

NOTICE

Check the contents to ensure everything is available and for signs of visible damage.

If the contents are incomplete, or have been damaged due to defective packaging or transportation, contact the Service Hotline.

Appliance description

1 Measuring tape
2 Restrainer
3 Spirit level (vertical alignment)
4 Spirit level (horizontal alignment)
5 On/Off switch
6 Laser exit opening
7 Battery compartment

Initial use

GB IE

Inserting/exchanging batteries

Loosen the screw of the battery compartment cover with a crosshead screw-driver and remove the battery compartment cover.

Insert the 2 Type AAA/Micro batteries resp. replace the used batteries with new ones.

Pay heed to the correct polarity, as shown in the battery compartment 7.

Replace the battery compartment cover and retighten the screw.

Using the measuring tape

WARNING

The measuring tape retracts automatically.

Do not allow the measuring tape 1 to rewind itself without control, instead, guide it back by hand. There is also a risk of personal injury!

NOTICE

With the measuring tape 📋 you can read off measurements of length in the metric system or in the Anglo/American system. The upper scale shows lengths in feet and inches, the lower scale in meters and centimeters.

Slide the restrainer 2 to the position UNLOCK.

Pull the measuring tape ⚙ out to the required length.

Secure the measuring tape ⚙, by sliding the restrainer 2 to the position LOCK.

When you roll the measuring tape ● back up or wish to adjust it to a new length, hold the end firmly and slide the restrainer 2 to the position UNLOCK.

Now allow the measuring tape 🔑 to roll back slowly, without releasing it.

GB IE

Using the Laser Pointer

Aligning the laser beam horizontally

Hold the appliance with the narrow side to the wall, so that the spirit levels ③ and ④ are facing forward.

Place the On/Off switch⑤ at the position I to switch the laser on. A laser beam cross appears.

Align the Laser Spirit Level such that the air bubble in the spirit level ④ lies exactly in the middle of the markings.

Place the On/Off switch 5 at the position 0 to switch the laser off.

Aligning the laser beam vertically

Hold the appliance with the narrow side to the wall, so that the spirit levels ③ and ④ are facing forward.

Place the On/Off switch 5 at the position I to switch the laser on. A laser beam cross appears.

Align the Laser Spirit Level such that the air bubble in the spirit level ③ lies exactly in the middle of the markings.

Place the On/Off switch 5 at the position 0 to switch the laser off.

Cleaning and Care

With the exception of battery exchanges this appliance is maintenance-free.

IMPORTANT

To avoid damage to the appliance, ensure that moisture cannot penetrate it during cleaning.

Do not use aggressive detergents or abrasive materials.

These could damage the upper surfaces.

Clean the outer surfaces with a soft and lint-free cloth.

Clean the laser exit openings ⑥ with a soft brush.

Store the Laser Spirit Level in a dry and, if possible, dust-free environment.

Disposal

Disposal of the appliance

Do not dispose of the appliance in your normal domestic waste. This product is subject to the European Directive 2002/96/EC-WEEE (Waste Electrical and Electronic Equipment).

Dispose of the appliance through an approved disposal centre or at your community waste facility. Observe the currently applicable regulations. In case of doubt, consult your local disposal facility.

Disposing of the batteries

Do not dispose of the batteries with household waste. All consumers are statutorily obliged to dispose of batteries at a collection site in their community/city district or at a retail store. This obligation is intended to ensure that batteries are disposed of in an environmentally safe manner. Only hand in batteries/cells that are fully discharged.

Dispose of the packaging materials in an environmentally responsible manner.

Appendix

Technical data

Operating voltage	3 V DC(2 x 1.5 V Batteries of Type AAA/Micro)
Laser class 2
Precision 1 mm/m
P max < 1 mW
Wave length λ 650 nm
Measuring tape length 3 m
Dimensions 15.7 x 2.8 x 5.7 cm
Weight	approx. 170(with batteries)	g

GB IE

Warranty

You receive a 3-year warranty for this appliance as of the purchase date. This appliance has been manufactured with care and meticulously examined before delivery.

Please retain your receipt as proof of purchase. In the case of a warranty claim, please make contact by telephone with our service department. Only in this way can a post-free despatch for your goods be assured.

NOTICE

The warranty covers only claims for material and manufacturing defects, not for transport damages, wearing parts or for damage to fragile components, e.g. switches and batteries.

This product is for domestic use only and is not intended for commercial applications. In the event of misuse and improper handling, use of force and interference not carried out by our authorized service branch, the warranty will become void..

Your statutory rights are not restricted in any way by this warranty.

The warranty period is not extended by repairs made under the warranty.

This applies also to replaced and repaired parts.

Damages or defects discovered after purchase are to be reported directly after unpacking, at the latest by two days after the purchase date.

Repairs carried out after the lapse of the warranty period are subject to charge.

Service

GB DES UK LTD

Tel.: [phone] (£ 0.10 / minute)

E-Mail: [e-mail]

IE Kompernass Service Ireland

Tel: [phone] (0,082 EUR/Min.)

Standard call rates apply. Mobile operators may vary.

E-Mail: [e-mail]

Importer

KOMPERNASS GMBH

BURGSTRASSE 21

44867 BOCHUM, GERMANY

www.kompernass.com

Sisällysluettelo

Johdanto....10