Precision 2409 - Coffee grinder OBH NORDICA - Free user manual and instructions

Product Type	Burr Coffee Grinder
Brand	OBH Nordica
Model	Precision 2409
Model Number	2409
Voltage	230V AC
Power	150W
Bean Container Capacity	200 g
Ground Coffee Container Capacity	Approx. 100 g
Grind Fineness Settings	1 (fine) to 9 (coarse)
Cup Selection	2 to 12 cups
Grinding Mechanism	Removable upper burr
Safety Features	Auto shut-off when containers are not properly placed
Material	Plastic body, stainless steel burrs
Cleaning	Hand wash removable parts; do not immerse base
Dishwasher Safe	No
Warranty	Valid according to national legislation
Country of Origin	Denmark (brand)
Special Features	Static reduction, grind amount selector, safety interlock
Usage	For whole coffee beans only
Overheat Protection	Recommended not to grind more than 1 minute; cool down 5 minutes

Frequently Asked Questions - Precision 2409 OBH NORDICA

How do I adjust the grind size?

Turn the fineness selector on the side of the appliance to the desired setting (1 = fine, 9 = coarse). Never change the setting while grinding.

Can I wash the parts in the dishwasher?

No. The ground coffee container, its lid, and the bean container lid must be cleaned in warm water with mild detergent and dried thoroughly. Do not place them in the dishwasher.

Why does my grinder not start?

Ensure the ground coffee container with lid is properly placed. The grinder will not operate if these parts are not correctly installed. Also check the bean container lid is on.

How do I clean the burrs?

Remove the upper burr by turning the fineness selector to 1, then turn the roof clockwise to UNLOCK and lift out. Use the enclosed brush to clean both burrs. Do not unscrew the upper burr from its housing.

What is the maximum bean capacity?

The bean container can hold up to 200 g of coffee beans. The ground coffee container holds approximately 100 g of ground coffee.

Can I grind something other than coffee beans?

No. This grinder is designed for whole coffee beans only. Do not use other items like spices or grains.

How can I reduce static in the ground coffee?

Before removing the ground coffee container, tap the machine a few times to relieve static buildup that occurs during grinding.

What does the grind amount selector do?

Slide the grind amount selector to the number of cups you want to grind (2-12). The grinder stops automatically when the set amount is ground.

How do I remove and replace the upper burr?

Turn fineness selector to 1. Turn the roof of the upper burr clockwise to UNLOCK. Lift it out. To replace, align and turn counterclockwise to LOCK until the fineness selector points to 9.

What is the warranty on this product?

The warranty is according to valid national law. Keep the receipt as proof of purchase and return the appliance to the store where it was bought.

USER MANUAL Precision 2409 OBH NORDICA

precision grinder // coffee burr grinder //

Adjustable course settings 1-9 //

200 gr beans / 100 gr grinded coffee - tot 300 gr//

EI selection 2-12 //

Removable grinding wheel //

Easy to clean // electronic

Type 2409

OBH Nordica Denmark A/S

Ole Lippmanns Vej 1

2630 Taastrup

Tlf.: 43 350 350

www.obhnordica.dk

Tekniske data

OBH Nordica 2409

230 V

100 W

OBH Nordica Sweden AB

Box 58

163 91 Spånga

Tel [phone]

www.obhnordica.se

Tekniska data

OBH Nordica 2409

230 V

100 W

OBH Nordica Norway AS

Postboks 5334, Majorstuen

0304 Oslo

Tlf: 22 96 39 30

www.obhnordica.no

Tekniska data

OBH Nordica 2409

230 V

100 W

Before the appliance is used for the first time, read through the instruction manual carefully and save it for future use.

Wash the ground coffee container with lid and the lid to the coffee bean container and make sure that all parts are dry before use. Wipe the cover with a damp cloth.

Put the lid on the ground coffee container and put the container back into the grinder. Note that the coffee grinder will not operate if the ground coffee container and lid are not properly in place.

Important information before you use the appliance for the first time!

During manufacturing the grinding wheels are installed so that they touch initially. The grinder will not function properly while the wheels are touching each other. To avoid grinding with the wheels touching, proceed as follows:

• Place the appliance on a flat level surface.
• Make sure that the bean container is empty, clean and dry.
• Plug the grinder and set the fineness selector to number 9.
• Fill the bean container with 3-4 tablespoons of coffee beans.
• Set the grind amount selector to number 4. Make sure the ground coffee container with its lid is in place.
• Push and hold the switch for 2 seconds.
• Repeat the same procedure in a different fineness position, for example number 3.
• The appliance is now ready for use at any setting.

Use

Grinding process

• Place your appliance on a flat level surface.
• Place the ground coffee container lid on the ground coffee container and put it into the grinder.
• Plug the grinder into an outlet.
• Lift the lid from the bean container and fill it with coffee beans and replace the lid. The bean container can hold up to 200 g coffee beans. Note: Only coffee beans should be filled into the bean container. The coffee beans keeps its aroma for up to two weeks in the container.
• Set the grind amount selector to the number of cups of coffee you want to grind by sliding the grind amount selector (at the front of the appliance) above the correct number. These numbers are to be used as a guide. The amount of ground coffee varies quite a bit depending on how coarse or fine you grind and whether you use light, dry beans or dark oily beans. After grinding a few times you will find the correct grind amount position for the amount of coffee you want to grind.

• Set the fineness selector (on the side of the appliance) to the desired setting. If you want coarse grinded coffee that is suitable for perculators and press coffee makers, you should set the wheel at setting 8 or 9. If you want a more finely grinded coffee for espresso makers for example, you should set the wheel at setting 4. We recommend that you test different settings to find the ultimate setting for your need.

• Note! Never change the fineness selector setting while grinding.

• Push and hold the switch to start the appliance. The grinder will begin to grind the coffee directly into the ground coffee container and will stop automatically. Attention: beans may stick to the wall of the bean container preventing them from falling into the burrs. You will hear a high pitched noise from the motor when this happens. Gently shake the grinder so that the beans slide down into the burrs. Note, if you need to turn the grinder off before the grinding cycle is finished, slide the grind amount selector to the STOP position.
• Be sure to turn off the appliance and disconnect the plug after use.

Grinding tips

• Never grind in advance, only grind the amount of coffee you will use. Ground coffee loses aroma and flavour quickly and attracts other odours.
• Do not grind for more than one minute at a time. Let machine cool down for 5 minutes before grinding again.
• Empty the coffee ground container before it is completely full. Otherwise ground coffee can back up to the grinding chute and block the grinding mechanism.
• Before removing the ground coffee container, tap the machine a few times. This will relieve some of the static build-up which occurs during grinding.

Cleaning and maintenance

• Always unplug your coffee grinder before cleaning.
- Remove the ground coffee container, its lid and the bean container lid and clean them in warm water and mild detergent. Do not place these items in the dishwasher.
- Remove ground coffee from the grinder chute with the enclosed brush. Empty the bean container and wipe it with a damp cloth.
- The cover can be wiped clean with a damp cloth.
- Never immerse the grinder or its cord in water or any other liquid. Do not use abrasive materials to clean the appliance.

Cleaning/removing the upper burr disk

• Turn the fineness selector to number 1.
• Turn the roof of the upper grinding burr clockwise according to the instruction (UNLOCK).
• Lift the upper burr out of the grinder. Clean both burrs with the enclosed brush. Note, do not unscrew the upper burr from its housing.
• Replace the upper burr into the grinder and turn counterclockwise (LOCK) until the fineness selector points to number 9.

Safety instructions

1. Read the instruction manual carefully before use, and save it for future use.
2. Plug the appliance to a household outlet of 230V only, and use the appliance only for the intended use.
3. Always unplug the appliance from the mains supply when not in use.
4. This appliance can only be started when the lid is properly placed.
5. The appliance must not be immersed into water or other liquids.
6. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

7. Children should be supervised to ensure that they do not play with the appliance. Children are not always able to understand potential risks. Teach children a responsible handling of electrical appliances.

8. Check that the cord is not hanging over the edge of the table.

9. Do not place the appliance on or near hotplates, open fire or the like.
10. The appliance should only be used under supervision.
11. Always examine appliance, cord and plug for damage before use. If the supply cord is damaged, it must be replaced by the manufacturer, or his service agent or a similarly qualified person in order to avoid a hazard.
12. The electrical installation must comply with the present legislation concerning additional protection in the form of a residual current device (RCD) with a rated residual operating current not exceeding 30 mA). Check with your installer.
13. The appliance is for domestic use only.
14. If the appliance is used for other purposes than intended, or is it not handled in accordance with the instruction manual, the full responsibility for any consequences will rest with the user. Any damages to the product or other things are not covered by the warranty.

Disposal of the appliance

Legislation requires that all electrical and electronic equipment must be collected for reuse and recycling. Electrical and electronic equipment marked with the symbol indicating separate collection of such equipment must be returned to a municipal waste collection point.

Warranty

Claim according to valid law. Machine stamped receipt shall be enclosed if one wishes to make a complaint. The appliance shall be returned to the store where it was purchased.

OBH Nordica Sweden AB

Box 58

163 91 Spånga

Phone: [phone]

www.obhnordica.com

Technical Data

OBH Nordica 2409

230V AC

150 watt

With reservation for running changes.