341-022 - Ladder Hard Head - Free user manual and instructions

Product Type	Ladder
Brand	Hard Head
Model	341-022
Production Date	2014-04-03
Maximum Load	150 kg (estimated typical)
Material	Aluminum (estimated)
Safety Features	Restraint devices, stability tie-down, non-slip feet
Maintenance	Regularly check parts and hinges, oil hinges carefully, use only manufacturer spare parts
Storage	Store in dry place, not exposed to rain or snow
Usage	Light work for short periods, one person at a time, face ladder when climbing
Electrical Hazard Warning	Use non-conductive ladders when working near live electrical equipment
Number of Steps	Not specified (typical 4-6 steps for leaning ladder)

Frequently Asked Questions - 341-022 Hard Head

How should I inspect the ladder before use?

Visually inspect the ladder for damage at the start of each work day. Check all components for condition and function. Do not use a damaged ladder.

What is the correct angle for a leaning ladder?

The angle of inclination should be approximately 1:4 (about 75 degrees), with steps horizontal. The ladder must be placed on a level, even base.

What is the maximum load for this ladder?

The maximum load is not specified in the manual, but typical ladders support up to 150 kg. Do not exceed the maximum load indicated on the ladder.

Can I over-reach while on the ladder?

No, keep your belt buckle (navel) inside the side rails and both feet on the same tread while working to maintain balance.

Is it safe to stand on the top steps?

No, for a leaning ladder, do not stand on the top three treads. For a freestanding ladder, do not stand on the top two treads (or top four if protruding).

Can I use the ladder outdoors in bad weather?

No, do not use the ladder outdoors in high winds or other bad weather conditions.

Can I use the ladder as a bridge?

No, never use the ladder as a bridge. It is designed only for climbing and working at height.

What type of footwear should I wear?

Use suitable shoes with good grip when climbing or working on the ladder.

Should I avoid side loads?

Yes, avoid strong side loads such as drilling sideways into hard materials (brick, concrete) as this can cause instability.

How should I store the ladder?

Store the ladder in a dry place not exposed to rain or snow. Lubricate hinges regularly with oil, being careful not to get oil on the rungs or side rails.

USER MANUAL 341-022 Hard Head

EN - Operating instructions in original

Date of production: 2014-04-03

© Jula AB

SVENSKA....4

SÄKERHETSANVISNINGAR....4

HANDHAVANDE 4

UNDERHÅLL 6

NORSK 8

SIKKERHETSANVISNINGER 8

BRUK....8

VEDLIKEHOLD 10

POLSKI 12

ZASADY BEZPIECZEŃSTWA 12

OBSŁUGA 12

KONSERWACJA 14

ENGLISH 16

SAFETY INFORMATION 16

HANDLING 16

MAINTENANCE 18

SÄKERHETSANVISNINGAR

Read the operating instructions carefully before use.

Please retain for future reference.

WARNING!

• Make sure that you are capable of using the ladder. Certain medical conditions and certain medications, alcohol or drugs can make use of the ladder unsafe.
• When transporting ladders on support beams or in a lorry, make sure that they are placed appropriately to prevent injuries/damage.
• Inspect the ladder after delivery and before initial use to check the condition and function of all components.
• Inspect the ladder visually for damage and check that it is safe to use at the start of each work day the ladder is used.
• The ladder must be inspected on a regular basis for professional use. Make sure that the ladder is suitable for the task.
• Do not use a damaged ladder.
• Remove dirt, e.g. wet paint, clay, oil or snow, from the ladder.
• Before using a ladder at work, make a risk assessment in accordance with the applicable regulations in the country of use.

HANDLING

• The ladder must be raised in the correct position, e.g. at the correct angle for a ladder leaning against a structure (angle of inclination should be approx. 1:4) with the steps horizontal and freestanding ladders should be fully extended.
• Restraint devices, if such exist, must be fully secured prior to use.
• The ladder must be placed on a level, even and stationary base.
• A ladder leaning against a structure must lean against an even, non-fragile surface and should be fastened before use, e.g. be tied down using an appropriate stability device.
• Never move the ladder from the top.
• Once the ladder has been positioned, pay attention to the risk of collisions with the ladder, e.g. by pedestrians, vehicles or doors. Where possible, lock doors (not emergency exits) and windows within the work area.
• Find out if there are any electrical hazards in the work area, e.g. overhead lines or other detached electric equipment.

• Always stand the ladder on its feet, not on its top tread.
- Do not place the ladder on slippery surfaces (e.g. ice, shiny surfaces or heavily soiled solid surfaces) unless additional steps have been taken to prevent the ladder from sliding or by making sure that the soiled surfaces are adequately cleaned.
- Do not exceed the maximum load for the ladder.
- Do not over-reach; users should keep their belt buckle (navel) inside the side rails and both feet on the same tread while working.
- Do not step off the ladder at heights without taking additional safety measures, e.g. by tying the ladder down or by using an appropriate stability device.
- Do not use freestanding ladders to get to a different level.
- Do not stand on the top three treads of a ladder that is in leaning against a structure.
- Do not stand on the top two treads of a freestanding ladder without a platform and hand knee-rail.
- Do not stand on the top four treads of a freestanding ladder with a protruding top tread.
- Ladders should only be used for light work for short periods of time.
- Use ladders that are electrically non-conductive to carry out work where it is not possible to switch off the power.
- Do not use the ladder outdoors in bad weather, e.g. in high winds.
• Take precautions to prevent children from playing on the ladder.
- Where possible, lock doors (not emergency exits) and windows in the work area.
- Face the ladder when climbing up or down the ladder.
- Keep a firm hold on the ladder when climbing up or down the ladder.
- Do not use the ladder as a bridge.
- Use suitable shoes when climbing a ladder.
- Avoid strong side loads, e.g. drilling in brick and concrete.
- Do not spend long periods on the ladder but take regular breaks (tiredness is a risk factor).
- Leaning ladders that are used to climb up to a higher level must be at least one meter above the point of contact.
• Equipment that is carried up a ladder should be light and easy to handle.
- Avoid work that constitutes a side load on freestanding ladders, e.g. drilling sideways in solid materials (in brick or concrete etc.).
- Hold on with one hand while working from the ladder, or take additional precautions if this is not possible.

MAINTENANCE

• Regularly check the parts and hinges of the ladder. Oil the hinges regularly, but do so carefully to ensure no oil drips on the rungs or side rails.
• Repairs and maintenance must be carried out by a skilled and trained individual in accordance with the manufacturer's instructions.
• Only use spare parts supplied by the manufacturer.
• Ladders should be stored in places where they are not for instance exposed to rain or snow.

Jula reserves the right to make changes. In the event of problems, please contact our service department. www.jula.com