342-027 - Ladder Hard Head - Free user manual and instructions

Brand	Hard Head
Model	342-027
Product Type	Ladder (leaning and freestanding)
Intended Use	Light work for short periods
Recommended Inclination Angle	Approximately 1:4 (75°)
Required Surface	Level, even, stationary base
Inspection Frequency	Before each use and after delivery
Cleaning	Remove dirt (wet paint, clay, oil, snow)
Maximum Load	Not specified (refer to ladder label)
Number of Steps	Not specified
Material	Not specified
Weight	Not specified
Maintenance	Regularly check hinges, oil hinges, use only manufacturer spare parts
Storage	Store in dry place away from rain/snow
Weather Restriction	Do not use outdoors in high winds or bad weather
Child Safety	Keep children away from ladder
Restraint Devices	Must be fully secured before use
Leaning Ladder Extension	Must extend at least 1 m above the point of contact
Standing Restrictions	Do not stand on top three treads (leaning), top two (freestanding without platform), or top four (freestanding with protruding top tread)

Frequently Asked Questions - 342-027 Hard Head

What is the correct angle for a leaning ladder?

The ladder should be placed at an angle of inclination of approximately 1:4 (about 75 degrees) with the steps horizontal.

How should I inspect the ladder before use?

Visually inspect the ladder for damage and check that all components are in good condition. Remove any dirt like wet paint, clay, oil, or snow.

Can I use the ladder outdoors in bad weather?

No, do not use the ladder outdoors in bad weather such as high winds.

What is the maximum load for this ladder?

The maximum load is not specified in the manual. Do not exceed the maximum load stated on the ladder's label.

Can I stand on the top steps of the ladder?

For a leaning ladder, do not stand on the top three treads. For a freestanding ladder without a platform, do not stand on the top two treads. For a freestanding ladder with a protruding top tread, do not stand on the top four treads.

How should I store the ladder?

Store the ladder in a place where it is not exposed to rain or snow, such as indoors or under cover.

Can I use the ladder for electrical work?

Use ladders that are electrically non-conductive for work where power cannot be switched off. This manual does not specify if this ladder is non-conductive; check the ladder's label.

How often should I oil the hinges?

Oil the hinges regularly, but carefully to avoid oil dripping on the rungs or side rails.

Can I move the ladder while standing on it?

Never move the ladder from the top. Always climb down before repositioning.

What should I do if the ladder is damaged?

Do not use a damaged ladder. Repairs and maintenance must be carried out by a skilled individual using only manufacturer's spare parts.

USER MANUAL 342-027 Hard Head

EN - Operating instructions in original

Date of production: 2014-04-03

© Jula AB

SVENSKA....4

SÄKERHETSANVISNINGAR....4

HANDHAVANDE 4

UNDERHÅLL 6

NORSK 8

SIKKERHETSANVISNINGER 8

BRUK....8

VEDLIKEHOLD 10

POLSKI 12

ZASADY BEZPIECZEŃSTWA 12

OBSŁUGA 12

KONSERWACJA 14

ENGLISH 16

SAFETY INFORMATION 16

HANDLING 16

MAINTENANCE 18

SÄKERHETSANVISNINGAR

Read the operating instructions carefully before use.

Please retain for future reference.

WARNING!

• Make sure that you are capable of using the ladder. Certain medical conditions and certain medications, alcohol or drugs can make use of the ladder unsafe.
• When transporting ladders on support beams or in a lorry, make sure that they are placed appropriately to prevent injuries/damage.
• Inspect the ladder after delivery and before initial use to check the condition and function of all components.
• Inspect the ladder visually for damage and check that it is safe to use at the start of each work day the ladder is used.
• The ladder must be inspected on a regular basis for professional use. Make sure that the ladder is suitable for the task.
• Do not use a damaged ladder.
• Remove dirt, e.g. wet paint, clay, oil or snow, from the ladder.
• Before using a ladder at work, make a risk assessment in accordance with the applicable regulations in the country of use.

HANDLING

• The ladder must be raised in the correct position, e.g. at the correct angle for a ladder leaning against a structure (angle of inclination should be approx. 1:4) with the steps horizontal and freestanding ladders should be fully extended.
• Restraint devices, if such exist, must be fully secured prior to use.
• The ladder must be placed on a level, even and stationary base.
• A ladder leaning against a structure must lean against an even, non-fragile surface and should be fastened before use, e.g. be tied down using an appropriate stability device.
• Never move the ladder from the top.
• Once the ladder has been positioned, pay attention to the risk of collisions with the ladder, e.g. by pedestrians, vehicles or doors. Where possible, lock doors (not emergency exits) and windows within the work area.
• Find out if there are any electrical hazards in the work area, e.g. overhead lines or other detached electric equipment.

• Always stand the ladder on its feet, not on its top tread.
- Do not place the ladder on slippery surfaces (e.g. ice, shiny surfaces or heavily soiled solid surfaces) unless additional steps have been taken to prevent the ladder from sliding or by making sure that the soiled surfaces are adequately cleaned.
- Do not exceed the maximum load for the ladder.
- Do not over-reach; users should keep their belt buckle (navel) inside the side rails and both feet on the same tread while working.
- Do not step off the ladder at heights without taking additional safety measures, e.g. by tying the ladder down or by using an appropriate stability device.
- Do not use freestanding ladders to get to a different level.
- Do not stand on the top three treads of a ladder that is in leaning against a structure.
- Do not stand on the top two treads of a freestanding ladder without a platform and hand knee-rail.
- Do not stand on the top four treads of a freestanding ladder with a protruding top tread.
- Ladders should only be used for light work for short periods of time.
- Use ladders that are electrically non-conductive to carry out work where it is not possible to switch off the power.
- Do not use the ladder outdoors in bad weather, e.g. in high winds.
• Take precautions to prevent children from playing on the ladder.
- Where possible, lock doors (not emergency exits) and windows in the work area.
- Face the ladder when climbing up or down the ladder.
- Keep a firm hold on the ladder when climbing up or down the ladder.
- Do not use the ladder as a bridge.
- Use suitable shoes when climbing a ladder.
- Avoid strong side loads, e.g. drilling in brick and concrete.
- Do not spend long periods on the ladder but take regular breaks (tiredness is a risk factor).
- Leaning ladders that are used to climb up to a higher level must be at least one meter above the point of contact.
• Equipment that is carried up a ladder should be light and easy to handle.
- Avoid work that constitutes a side load on freestanding ladders, e.g. drilling sideways in solid materials (in brick or concrete etc.).
- Hold on with one hand while working from the ladder, or take additional precautions if this is not possible.

MAINTENANCE

• Regularly check the parts and hinges of the ladder. Oil the hinges regularly, but do so carefully to ensure no oil drips on the rungs or side rails.
• Repairs and maintenance must be carried out by a skilled and trained individual in accordance with the manufacturer's instructions.
• Only use spare parts supplied by the manufacturer.
• Ladders should be stored in places where they are not for instance exposed to rain or snow.

Jula reserves the right to make changes. In the event of problems, please contact our service department. www.jula.com