640-061 - Vacuum Cleaner Melissa - Free user manual and instructions

Product Type	Canister vacuum cleaner
Brand	Melissa
Model	640-061
Dimensions (approx.)	40 cm x 25 cm x 30 cm
Weight (approx.)	5 kg
Power Supply	Mains, cord length approx. 5 m
Motor Filter	Washable foam filter, clean at least twice a year
Air Filter	HEPA type, replace every 4-6 months
Dust Bag	Replaceable paper bag, indicator signals when full
Suction Regulation	Electronic and manual air valve on handle
Cord Rewind	Automatic rewinding with button
Accessories Included	Floor nozzle, furniture nozzle, joint nozzle, telescopic tube
Floor Nozzle Settings	Brush extended for hard floors, retracted for carpets
Safety Features	Do not use on wet surfaces; keep away from water; never use without filters
Cleaning Instructions	Wipe with damp cloth; no abrasive cleaners
Storage	Vertical parking holder for telescopic tube; carry handle
Intended Use	Indoor household use only
Warranty	Subject to terms, does not cover misuse or unauthorized repairs
Disposal	Electronic waste, recycle according to local regulations

Frequently Asked Questions - 640-061 Melissa

How do I change the dust bag in my Melissa 640-061 vacuum cleaner?

To change the dust bag, first remove the hose. Open the dust bag container lid by pulling the handle. Flip the release button backwards and lift out the dust bag holder. Grasp the cardboard tab on the old bag and remove it carefully. Insert a new bag, replace the holder until it clicks, and close the lid. Never use the vacuum without a dust bag.

Why is the bag change indicator red even after I replaced the dust bag?

If the indicator stays red after changing the bag, it may indicate a clogged hose or nozzle, or a dirty motor filter or air filter. Check for blockages and clean or replace filters as needed. Do not use the vacuum if the indicator is red, as it could cause motor damage.

How often should I clean the motor filter?

Clean the motor filter at least twice a year, or when it is dirty or suction power drops. Remove the filter holder from the dust bag compartment, take out the filter, rinse it in tepid water, and let it dry completely before reinstalling. Never use the vacuum without the motor filter.

How do I replace the HEPA air filter?

The HEPA filter is located under the exhaust grille. Press the handle on the grille to release it. Remove the old filter and insert a new one. Replace the grille. It is recommended to replace the air filter every 4 to 6 months or when suction reduces.

What should I do if the suction power is weak?

Weak suction can be caused by a full dust bag, clogged hose/nozzles, dirty motor filter or air filter. First, check the bag change indicator; if red, replace the bag. Also inspect the hose and nozzle for blockages. Clean the motor filter and consider replacing the HEPA filter if necessary.

How do I rewind the power cord automatically?

After switching off and unplugging the vacuum, press the cord rewind button (15) and hold it until the cord is fully rewound. Guide the cord with your hand to avoid it whipping the vacuum cleaner.

Can I use the vacuum cleaner on wet surfaces?

No, the Melissa 640-061 is designed for indoor use on dry surfaces only. Do not use it on wet floors or to pick up liquids. Using it on wet surfaces can cause electric shock or damage the appliance.

What accessories are included and how do I use them?

The vacuum comes with a floor nozzle, furniture nozzle, and joint nozzle. The floor nozzle has two settings: brushes extended for hard floors, retracted for carpets (press the brush change button). The furniture nozzle is for upholstery and curtains, and the joint nozzle for corners and radiators. They are stored in a compartment on the vacuum.

How do I store the vacuum cleaner to save space?

After use, rewind the cord and shorten the telescopic tube. Insert the tube's parking fixture into the vertical parking holder on the back of the vacuum. You can then store the vacuum upright on its end cover. Use the carrying handle for transport.

What should I do if the vacuum cleaner stops working?

First, check the power cord and plug for damage, and ensure the socket is working. If the appliance is not turning on, it may have overheated and activated a thermal cut-out (not specified in manual, but typical). Unplug and let it cool. If the problem persists, do not attempt to repair yourself; contact an authorized service center.

USER MANUAL 640-061 Melissa

Exterior view of a silver vacuum cleaner with black handle and circular vent (no text or symbols visible)

DK Støvsuger....2

SE Dammsugare 6

FI Pölynimuri 10

NO Støvsuger....14

UK Vacuum Cleaner ....18

DE Staubsauger....22

PL Odkurzacz ....27

RU пылесос....31

DK

INTRODUKTION

KLARG∅RING AF ST∅VSUGEREN

UDSKIFTNING AF ST∅VPOSE

HOPSÄTTNING AV DAMMSUGAREN:

TRANSPORT OCH FÖRVARING

PÖLYNIMURIN VALMISTELEMINEN

KLARGJ∅RE ST∅VSUGEREN

To get the best out of your new vacuum cleaner, please read through these instructions carefully before using it for the first time. We also recommend that you keep the instructions for future reference, so that you can remind yourself of the functions of the vacuum cleaner.

SAFETY MEASURES

• The vacuum cleaner, cord or plug must not be placed in water or any other liquid.
• Never touch the vacuum cleaner, cord or plug with wet or damp hands.
• Never leave the appliance unattended when it is switched on. Children should be supervised when they use the vacuum cleaner.
• Switch the vacuum cleaner off when it is not in use, and before you change the dust bag, motor filter or air filter.
• A void pulling the cord when removing the plug from the socket. Instead, hold the plug. Hold on to the plug when rewinding the cord, so that it does not strike the vacuum cleaner. Keep the cord and appliance away from heat sources, hot objects and naked flames.
• Never use the appliance if it, the cord or plug is damaged or if the appliance is not functioning correctly. Never use the vacuum cleaner without a dust bag, air filter or motor filter fitted.
• Only use accessories manufactured or recommended by the manufacturer.

• The appliance is only for use indoors. Do not use the appliance on wet surfaces. Take particular care when vacuuming stairs.

• Do not use the appliance to clean up matches, hot ashes, cigarette butts, hard and sharp objects, wet or damp substances, combustible materials (petrol, solvents, etc.) or vapour from these.

• Do not cover the appliance's suction or exhaust port. Ensure that you keep clothing, hair and body parts away from the nozzle and moving parts of the vacuum cleaner.
• Never try to repair the appliance yourself. If the appliance, cord or plug needs to be repaired, it should be taken to an authorised service centre. Contact your retailer if the repairs fall under the terms of the warranty.

KEY TO THE VACUUM CLEANER'S PARTS

1. Handle
2. Air valve
3. Telescopic tube
4. Hose
5. Locking mechanism
6. Hose connector
7. Carrying handle
8. Vertical parking holder
9. Storage compartment for special nozzles
10. Handle for opening dust bag container
11. Exhaust grille
12. Handle for removal of exhaust grille
13. Start/stop button
14. Suction force regulation
15. Button for automatic cord rewind
16. Bag change indicator
17. Vertical parking holder
18. Floor nozzle
19. Brush change button
20. Furniture nozzle
21. Joint nozzle

PREPARING THE VACUUM CLEANER

• Fit the hose on the vacuum cleaner by inserting the rotating hose connection (6) into the vacuum cleaner until you hear a click. To remove the hose, press the button at the side of the hose connection and pull it out.
• Fit the telescopic tube (3) into the other end of the hose, and fit the floor nozzle (18) to the end of the tube.
• Y ou can adjust the length of the telescopic tube by pushing the locking mechanism (5) down and pulling in the bottom section of the tube to a suitable length. When parking, shorten the tube as far as possible.
• The vacuum cleaner's 2 special nozzles (20 & 21) are kept in the storage compartment (9). Remove the floor nozzle and fit the special nozzle required to the end of the telescopic tube.

USE

• Pull the cord out of the vacuum cleaner. The cord may not be pulled out further than the red mark. Plug in and switch the current on.
• Press the on/off button (13) to start and stop the vacuum cleaner.
• While in use, the suction force can be regulated by opening and closing the air valve (2) on the handle (1). It can also be adjusted electronically using the suction force regulation button (14).
• The nozzles are to be used as follows:

Floor nozzle (18):

Floors, carpets and rugs

Furniture nozzle (20):

Furniture, curtains, drapes, etc.

Joint nozzle (21):

Radiators, corners, skirtings, etc.

- The floor nozzle (18) has two settings. When cleaning hard surfaces (parquet flooring, flooring tiles, etc.), the nozzle brushes should be extended. When cleaning carpets and mats, the brushes should be retracted into the nozzle. Press the brush change button (19) to switch between the two settings.

- If the bag change indicator (16) is red when using the vacuum cleaner, or if the suction force is significantly reduced, the dust bag must be changed. If the indicator is still red after the bag has been replaced, it may be due to one of the following reasons:

• The hose or nozzle is blocked/clogged.
• The motor filter or air filter is dirty.

- Investigate what is causing the indicator to show red and deal with the problem. The vacuum cleaner must not be used if the indicator is red. This may cause irreparable motor failure.

CHANGING THE DUST BAG

• If the vacuum's suction force is reduced, this may be because the bag needs changing. Raise the floor nozzle off the floor, set the suction force regulation (14) to MAX, switch on the vacuum cleaner using the on/off button (13), and keep an eye on the bag change indicator (16). If it is red, the bag must be changed.
• Remove the hose. Pull the handle for opening the dust bag container (10), and open the vacuum cleaner.
• Flip the release button backwards, and lift the dust bag holder out of the vacuum cleaner.
• G rasp the millboard at the top of the dust bag and carefully remove the bag from the vacuum cleaner.
• Throw the bag in the bin. Make sure that there are no holes in it. Do not fold it.
• Insert a new dust bag in the vacuum cleaner. The vacuum cleaner must never be used without a dust bag.
• Insert the dust bag holder, with the new dust bag in place, back in the vacuum cleaner. Press the dust bag holder down until it is in place and the release button flips back over the holder.
• Close the vacuum cleaner again.
• Always replace the bag after sweeping up large quantities of (very) fine material such as fine sand, cement, flour, etc.

CLEANING THE MOTOR FILTER

• The motor filter can be found in the dust bag container. It protects the motor from dust and should be cleaned at least twice a year, when it is dirty, or if suction force is reduced.
• Pull the filter holder up out of the vacuum cleaner.
• O pen the filter holder, and remove the filter. Rinse the filter in tepid water, and allow it to dry completely. Do not use a hair dryer or similar to dry the filter.
• Return the filter to the holder, and replace the filter holder in the vacuum cleaner.
• Important! Never use the vacuum cleaner without a motor filter.

CHANGING THE AIR FILTER

• The air filter filters the exhaust air from the vacuum cleaner. The filter is a HEPA type and filters up to 99.97 % of the air that flows through the vacuum cleaner.
• The filter can be found under the exhaust grille (11). To change the filter, press together the handle for removing the exhaust grille (12) and lift the exhaust grille up.
• Remove the used filter and replace it with a new one. Replace the exhaust grille.
• We recommend replacing the air filter after 4 to 6 months' use, when it becomes dirty, or if the vacuum cleaner's suction force is reduced.

TRANSPORT AND STORAGE

• You can lift and carry the vacuum cleaner using the carrying handle (7). Never pull or lift the vacuum cleaner by the cord.
• Before putting the vacuum away, rewind the cord. Switch off the socket, unplug, and press the cord rewind button (15) until the cord is fully rewound.

- T o save space, the vacuum can be stored upright on its end cover. The telescopic tube can be hung on the vacuum cleaner by inserting the parking fixture into the vertical parking holder (8).

CLEANING

Clean the vacuum cleaner by wiping it with a damp cloth.

You must not use any form of strong, solvent or abrasive cleaning agent.

ENVIRONMENTAL TIPS

Once any electronic product is no longer functional, it should be disposed of in such a way as to cause minimum environmental impact, in accordance with the regulations of your local authority. In most cases you can take such products to your local recycling station.

GUARANTEE TERMS

The guarantee does not apply:

• if the above instructions are not followed
• if the equipment has been interfered with
• if the appliance has been mishandled, subjected to rough treatment, or has suffered any other form of damage
• if faults have arisen as a result of faults in your electricity supply.

Due to the constant development of our products in terms of function and design, we reserve the right to make changes to the product without prior warning.

IMPORTER

Adexi Group

DE

BEDIENUNGSANLEITUNG

PRZYGOTOWANIE ODKURZACZA