WDF 740 G - Tumble drier HOTPOINT - Free user manual and instructions
Find the device manual for free WDF 740 G HOTPOINT in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Tumble Drier |
| Brand | Hotpoint |
| Model | WDF 740 G |
| Capacity | 7 kg |
| Drying Type | Condenser |
| Energy Class | B |
| Dimensions (H x W x D) | 85 x 60 x 60 cm |
| Weight | 40 kg |
| Power Supply | 230 V ~ 50 Hz |
| Power Consumption | 2500 W |
| Drum Material | Stainless steel |
| Drying Programs | Cotton, Synthetics, Delicates, Wool, Timed Drying, Anti-Allergy |
| Sensor Drying | Yes |
| Delay Start | Up to 24 hours |
| Anti-Crease | Yes (30 min post-drying) |
| Child Lock | Yes |
| Water Tank Capacity | 4.5 L |
| Lint Filter | Removable, clean after each cycle |
| Condenser Cleaning | Periodic (indicated by light) |
| Noise Level | 65 dB (A) |
Frequently Asked Questions - WDF 740 G HOTPOINT
How do I clean the lint filter on the WDF 740 G?
Open the door and pull the lint filter out from the bottom of the door opening. Remove the lint by hand or with a soft brush and rinse under running water if necessary. Dry thoroughly before reinserting. Clean after each drying cycle.
Why is the drying cycle taking longer than usual?
Check if the lint filter is clogged, the condenser needs cleaning, or the load is too large. Also ensure the room temperature is not too high and the appliance is not overloaded.
How do I empty the water tank?
Pull out the water tank drawer located at the bottom left of the appliance. Empty it into a sink or drain. Replace securely. The indicator light will remind you when full.
Can I dry wool items in the WDF 740 G?
Yes, use the dedicated Wool program. Ensure items are labeled as tumble dryer safe. Do not overload and remove promptly at the end of the cycle.
What does the 'Clean Condenser' light mean?
It indicates that the condenser unit needs cleaning. Remove the bottom panel, take out the condenser, rinse with water, and dry before reinserting. Reset the light by pressing the button if needed.
How do I use the delay start feature?
Select your drying program, then press the Delay Start button repeatedly to set the delay time (1-24 hours). Press Start to begin the countdown. The machine will start automatically at the set time.
The appliance stops mid-cycle. What should I check?
Check if the water tank is full, the lint filter is clogged, or the condenser needs cleaning. Also ensure the door is closed properly and the program is not paused. Refer to the troubleshooting section.
Can I install the tumble dryer under a counter?
Yes, but ensure adequate ventilation. The appliance requires a gap of at least 2 cm on the sides and rear. Do not obstruct the air vents or the condenser area.
How do I activate the child lock?
Press and hold the Child Lock button (usually a key symbol) for about 3 seconds until the indicator lights up. To deactivate, repeat the same steps.
What is the maximum load for the Cotton program?
The maximum load is 7 kg for cotton items. Overloading can lead to poor drying results and longer cycles.
User questions about WDF 740 G HOTPOINT
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Tumble drier in PDF format for free! Find your manual WDF 740 G - HOTPOINT and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. WDF 740 G by HOTPOINT.